Tails into metal switch fuse

[Gazthesparky]

I've got a job where I'm running a Swa sub main to a 17th edition board. I've got to put a switchfuse by the meter and I'm intending to run tails from the meter into it.

Previously I've put a male bush and locknut in the bottom and run the tails into that but I'm after other ideas that give strain relief.

I've seen the wiska tails stuffing gland but it's expensive at about 20 quid a pop

Any other ideas ? Suggestions

Cheers

 

[shanky887614]

Using an impact driver to tighten a connection is even worse

but its the cowboys favorite tool ive seen them use them on mcb's

 

[davesparks]

Still a little bitty screw, and all part of the earth fault & not one you can tighten up with an 'impact driver'. Who started this argument anyway. Back off to manage more manly things, the BBQ

It's only a screw on the 20 and 25mm, above that it's a threaded stud and nut

 

[Midwest]

Yep my thoughts exactly, I am shallow yet I am deep

 

[Midwest]

but its the cowboys favorite tool ive seen them use them on mcb's

I refer the honourable gentleman to the answer he gave in post #70. BBQ was good.

 

[Midwest]

Are you sure, never used them above 25mm, cos of that reason. Holier than thou I am