tools list

[simpson93]

hello guys i am doing a project at college and am looking for a hand
got a booklet and need to do a tools list for testing and comisioning this

1) PVC twin and earth cable supplying;
A ring final circuit with six single socket outlets.
Three lighting points, one lamp with one-way control and two lamps with two-way control on a ‘loop system’.
2) An attached garage installation which is RCD protected supplied by a steel wire armoured cable from the main installation providing;
A single socket outlet for use with portable garden tools.
A one lamp one-way lighting circuit.
3) Main Equipotential and Supplementary bonding.
4) A special location – a bathroom with an electric shower with a pull cord isolator, an extractor fan with a 3 pole isolator, a ‘globe lamp’ on a pull cord switch, and supplementary bonding to the hot and cold water supplies.
5) A mineral insulated cable circuit supplying a DOL controlling a ramp lift motor.
6) Suitable isolation and over current protection for all the above items.

i need to have all the tools and also tests meters specificly any help would be great thx

 

[gawain]

i guess ill start you off ^^ terminal screwdriver for removing/reconnecting of conducters.

 

[kentster]

lockoff device and approved voltage tester for safe isolation - or a neon screwdriver, hahaha

 

[IQ Electrical]

hello guys i am doing a project at college and am looking for a hand
got a booklet and need to do a tools list for testing and comisioning this

1) PVC twin and earth cable supplying;
A ring final circuit with six single socket outlets.
Three lighting points, one lamp with one-way control and two lamps with two-way control on a ‘loop system’.
2) An attached garage installation which is RCD protected supplied by a steel wire armoured cable from the main installation providing;
A single socket outlet for use with portable garden tools.
A one lamp one-way lighting circuit.
3) Main Equipotential and Supplementary bonding.
4) A special location – a bathroom with an electric shower with a pull cord isolator, an extractor fan with a 3 pole isolator, a ‘globe lamp’ on a pull cord switch, and supplementary bonding to the hot and cold water supplies.
5) A mineral insulated cable circuit supplying a DOL controlling a ramp lift motor.
6) Suitable isolation and over current protection for all the above items.

i need to have all the tools and also tests meters specificly any help would be great thx

Approved voltage indicator

Proving unit (if no live source present)

Lockoff kit

Low resistance Ohm meter

Insulation resistance tester

Earth loop impedance tester

RCD tester

Full set of insulated screwdrivers

A long R2 wander lead

Tape measure to confirm zones in special location

BS7671/On-site guide/GN 3 to check measure values comply

Label printer

 

[sjm]

BS 7671 electrical installation certificates. To add to IQ Electrical fused test leads.

 

[KWCFC]

Cutters.

 

[olly w]

A hammer ...always take a hammer....every job needs one.

 

[IQ Electrical]

Cutters and a hammer to test and commission?
Brutality!

 

[olly w]

and don't forget one of those "PENS" from men in black, in case it all goes ---- up.
At least you can deny it....

 

[simpson93]

found a much easier way to do it all i need is a van and a pen ^^ ( but i guess i cant take the van into the exam room >.<