Wet hands and electricity

[ipf]

Naah! He took both driers off and moved 'em a couple of inches.....

 

[littlespark]

He took the SFCU off the wall and got a clean line to the Allen screws

 

[Deleted member 26818]

He knocked the wall down.

 

[telectrix]

he stuck them on with gaffer tape.

 

[pirate]

Close, littlespark...close!
Drilled a hole in the side of the SFCU back box, blind grommet in it.

 

[littlespark]

Well, you never said it was on a surface mounted box. I would have taken the box off the wall, and not mentioned it on an Internet forum

 

[Pete999]

Seriously, though, I installed a couple of hand-driers recently, and simply put, the length of the flex and its exit point dictated that the SFCU had to be fitted close to the side, but above the bottom of the drier itself.
I went ahead, only to discover that the drier cover is held on by 2 allen screws near the bottom of the casing...so, all wired up, no room to get the hex-wrench in between the drier and the SFCU...doh!
I fixed the problem, but how is a secret!

Spoil sport

 

[pirate]

I don't mind admitting to my mistakes!
Not afraid of telling stuff that might just prevent someone else being as stupid as I...it's those "DOH!" moments where everything seems to be going well, and then...