Where can I get my Fluke 1652 calibrated?

[Goody]

Hi folks

Can someone tell me, where I can have my Fluke 1652 get calibrated.

I live in East London (Barking). Is there a place where I can take it to and get calibrated rather than sending it by post and so on.


Cheers!

 

[bluesky]

niceic and napit have this service, you can find more details on their site

 

[J@mes]

your local wholesaler might do it too.

 

[mogga]

naweys Electric cntr and Eddies all have services most wholesalers do it otherwise gogle calibration services barking see what turns up Mind and get prices for calibration and get them to phone you IF it needs repaired outwith this cost

 

[Guest123]

CEF also offer a calibration service via a 3rd party, TIC I think.

 

[MvP Electrics]

romford essex RM3 0AQ not too far from u they take about 45min-1hr.

Capital Calibration Services - 01708 396 331

 

[Goody]

Hi folks.

Thanks for all the suggestions.

Capital Calibration Services at Romford quoted me £90.00

.... and http://www.certific8.co.uk/ (NICEIC recommended) quoted me £45.00 + VAT. They will pick up the meter and deliver to your address after calibration.

I am going for the second one.

Regards!

 

[Andyfm]

If you haven`t sorted it yet , this firm are good
( Mobile calibration services On Site Calibrations instrument calibration 16th Edition test Equipment PAT Testing ) andthey do either a postal service or a mobile service where he turns up at home or onsite and does the calibration there and then, you just have to catch him in your area. I think he`s in the London area regularly.
He`s been doing mine for a few years and he`s not expensive - he does my three piece Robin kit for about £60

 

[skamuk]

Bit of a post resurrection but I found a place on eBay that will calibrate anything for £30. Anyone had any good/bad experiences using eBay?

 

[Engineer54]

Said it before and i'll say it again, ...i have no idea how these mobile testers can conform/comply with the legalities of the certificates they issue!! Personally, if it were my test equipment going in for calibration, i'd want it being done properly in a certified lab (local), and would expect to lose that equipments use for at least 24 hours.