R
Rob6502
I have been getting rejections, from commercial websites for quotes, such as "...does not meet the regulations [(electrical)] for this category..."
I assume that it is because a part P professional won't touch a DIY installation? (circa 2004).
If so, then is it possible for me to force the DNO to replace e.g. the ELBC with an isolator? (because the tails from the 100A meter to the (circa 1955 ELCB) are only 16mm) - currently they refuse to do this, they said "it was on the domestic side".
I assume that it is because a part P professional won't touch a DIY installation? (circa 2004).
If so, then is it possible for me to force the DNO to replace e.g. the ELBC with an isolator? (because the tails from the 100A meter to the (circa 1955 ELCB) are only 16mm) - currently they refuse to do this, they said "it was on the domestic side".