On a side note, the zonal information given by the manufacturers is incorrect, there is no zone around a basin, makes a mockery of the regulation telling you to take manufacturers instructions into account really.
The Length can be reduced by simply bolting the PE to the earthed chassis of say the DB enclosure, rather than using a separate conductor and adding to the length.
See Hager’s version
No, I mean that is the answer, the line conductor and PE should ideally not exceed 500 mm and in no cases exceed a meter.
Same applies to the neutral and PE.
Yep everyone bonds the gas on a new build despite the fact it’s a yellow non conductive pipe supplied in the ground but they see copper in the meter box and bond it anyway because that’s how it’s always been done.
Even more laughable is when bottled gas gets bonded....?♂️?♂️
Because safety continuously evolves along with our knowledge and learning from not implementing something, an example would be premature collapse of cables having had firefighters die because of it, that regulation is very much applied retrospectively in my inspections.
Fused neutrals as my...
The level of danger is still present regardless of what edition it was installed to.
Fused neutrals where once a thing, they would certainly warrant a C2 code regardless of what edition it was installed to.
The question is do the cables present a potential danger with how they are installed or...
If the cable is installed in the wall less than 50mm etc etc then you can not use a 100mA rcd for the required additional protection, is it buried in a wall or is it surface?
Having it on its own individual rcbo and ensuring selectively with all other circuits is not an issue, especially as an...
I’m glad you brought the regulation up because people are convinced in changing the fixing screws to nylon or putting caps over the heads, which is a ridiculously waste of time.
You can either preform a Ze of the installation using a loop tester or the Ra test procedure, there is no requirement to carry out both tests, the former being the easier/preferred method as it’s more convenient.
Unless your single dwelling electrical installation is pulling more than the 16mm tails (around 87 amps) then I don’t think there’s a particular issue.
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc