Search results

Search results

  1. JD6400

    Looking for a solar installer who is MCS registered.

    With a the Seg at what it is , it is more focused on what you save and not what goes back down the line. We have had the DNO out twice this week alone for + 253 v supplies , whilst chatting with them about a possible tap change one of the lads mentioned that the problem is all of the extra solar...
  2. JD6400

    Solar Panel Theft Solutions

    For the alarm side you could run a tamper line through the spare fixing holes on the panels fed from a 12 v transformer linked to a no volt panel relay . But it would not take a great deal of knowledge to overcome this. The best thing you can do is drop an appropriately sized ball bearing into...
  3. JD6400

    Solar Array swa sizing

    I have never got my head around how the inverter can see the volt drop and then add to it , but apparently it does . I have found that it is normally one of the indicator's if the system was installed to a decent standard if the installer has run a dedicated cable for the solar when it is...
  4. JD6400

    Solar Array swa sizing

    From what I have read , the main thing with amendment 2 is making sure any component used is fed from the right direction if it states it is directional in the manufacturer's instructions
  5. JD6400

    Solar Array swa sizing

    You should aim for 1% volt drop , as the inverter can see the drop and compensate for it , possibly putting the output of the inverter over voltage , so the smaller the volt drop the better. The 4 pole DC isolators are to do with breaking the DC as it helps with arcing , you loop each cable...
  6. JD6400

    Help with damaged underground cables

    They should have informed the poor bloke , it is hard enough making a living with out prats keeping quiet . But regardless of being informed of underground services or not , to open a cut with out scanning first is just poor and unsafe full stop. We have both a walk behind bobcat trencher and a...
  7. JD6400

    Help with damaged underground cables

    I would say that they have no excuse to leave them so shallow and are having a laugh with the no resin stance . But you have no excuse if carrying out ground works without cat scanning first , especially chain trenching . Sticking it on radio would have found these , to be honest I trust the...
  8. JD6400

    How can they justify the increase in your electricity bill !?

    Like you say ,the energy cost I can actually understand , even though it is 100% renewable. As we are all in it together. (ish) But the standing charge is nothing but theft in my opinion that will not come back down again ! For several years now I have started turning a blind eye to the bent...
  9. JD6400

    How can they justify the increase in your electricity bill !?

    Just had a email from E-on to say my yearly bill is going up £81 from £103 - £184. Now this has got me wondering how they can justify this --- Firstly it is for a spare feeder pillar in a field that uses 0 kWh per year , so the increase from 19p to 29p per kWh should not effect the end bill...
  10. JD6400

    Pricing for trench work

    Also as PC says buy your sand in bulk , it is normally far cheaper to order more than you need in bulk than to buy the exact amount in bags. Also ask about the quality of it , we use lower quality stuff that is sold for cattle bedding . They have all sorts of grades from the highest quality...
  11. JD6400

    Pricing for trench work

    You mentioned that you have six columns to install . Try and use ground workers with a digger auger , or hire one. We brought one for doing the ménages , we have 6" and 12" flights , but tend to use the 12" one for telegraph pole's , it saves an enormous amount of concrete and installation time...
  12. JD6400

    3a FSU downstream of a spur socket from RFC - compliant?

    Is it a double socket and fused spur or a single socket and fused spur ?
  13. JD6400

    Specialist firm for running cables in underground?

    I totally agree and tend to utilise on farm equipment where possible to keep the costs to a minimum. But I would venture to say that I guarantee your pallet tines will not be wide enough , unless you are handling potato or veg boxes .
  14. JD6400

    Specialist firm for running cables in underground?

    Going by Batt cables specification each length will be about 2.1 ton on its own without the cable drum. You will not want to be pulling that on its own let alone along side another one in a duct. In my opinion the best way is always to open a cut and lay it in , far less chance of damages to...
  15. JD6400

    Specialist firm for running cables in underground?

    Didn't mean to post yet , as got to take my daughter to rugby training , so will add what the point of my post is later , when back again.
  16. JD6400

    Specialist firm for running cables in underground?

    We end up doing at least 3 or 4 of these a year for ourselves , and have chain trenchers , both walk behind and tractor mounted along with a digger and a selection of moles . I keep toying with the idea of building a sand trailer as well with side unloading conveyor belts. To go behind the...
  17. JD6400

    Electrician Jobs Hiring in Buckinghamshire

    Hi we are a small company in based in mid Buckinghamshire , looking for extra labour short to long term possibly. Willing to look at varying hours and skill levels from wanting to get into the industry through to test engineer , including pairs. We cover just about all aspects apart from...
  18. JD6400

    500kva substation earthing , any qualifications needed ?

    They are only flat stores at the moment but we will designing as appropriate for that side .
  19. JD6400

    500kva substation earthing , any qualifications needed ?

    As I understand it , the earthing and test that he is referring to is for , and what the new substation is sitting on . I believe it was a nest of tape with rods at either corner.
  20. JD6400

    500kva substation earthing , any qualifications needed ?

    We were going from the new mains room and bolstering existing supplies and running a new one into the development of 21 units. Along with the new grain store and all the existing works. The phone call yesterday day came about because the other electrician has gone to ground now he's been asked...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top