• Please use style selector to select BLUE AND WHITE. If you are not already on it. This notice will go once you're on the correct style.

Search results

  1. S

    Solar Panels supplying new build

    I’ve not been out yet but he says the inverter is connected yes, he’s been using it to power the caravan he has been staying in whilst building this house. He has an isolation switch that feeds a supply cable to the house but he says it’s turned off just now. He says there’s 230v at it but he’s...
  2. S

    Solar Panels supplying new build

    Should have also said he’s done the solar side if things, inverter etc & run the supply cable, just up to me to do all the consumer unit work.
  3. S

    Solar Panels supplying new build

    So...who has experience in this on here?? Not me for sure. Basically roughed in a new build for someone, was told he was haggling with the local authority over the price for putting power to his house, it's in the countryside. So I basically kept plodding on, got it all just about done, fitted...
  4. S

    Commercial pizza oven part

    Furnotel it says on the front. The below is the model number:
  5. S

    Commercial pizza oven part

    To be honest I’ve no idea, there’s no manual, looked for one online but can’t find one. Element is fine. So, it’s a double oven, each oven has a top & bottom element, the one that wasn’t working was the bottom oven bottom element, it gets hot for a minute, then says HHH & starts cooling. So I...
  6. S

    Commercial pizza oven part

    Any idea where to find the following part? The bottom element that it controls is not holding the heat & temperature dial is showing hhh.
  7. S

    SWA outer sheath damage

    Thanks for the reply’s, they’ve agreed to replace the cable.
  8. S

    SWA outer sheath damage

    Have been asked to connect a SWA supply into a garage. The cable was ran in before I even knew about the job. No ducting as it enters the garage, been concrete poured round it as well. Then to top it off the joiner has fixed a stick to the concrete putting pressure on the cable. I’ve done IR &...
  9. S

    Attached Garage Wiring

    Perfect. Thanks for the replies.
  10. S

    Attached Garage Wiring

    What’s the norm these days for wiring an attached garage? Only entrance will be outside then in garage door. Best to run a supply to garage supplied by RCBO then have a small 2 way consumer & take the circuits from it? Or run a ring main to garage & come off existing house lighting circuit for...
  11. S

    OpenTherm programmer stat etc

    Wired all the usual for a boiler a while back, room stat in lobby & programmer in kitchen. Was an old boiler which has now packed in. They’re putting a new boiler in which apparently has OpenTherm connections, it’s an Intergas boiler. I’ve connected to an OpenTherm boiler once before & the...
  12. S

    Baxi Bermuda no hot water

    Got to the bottom of this...wasn’t an electrical problem. Very strange setup. So when you turned on HW it fired on the Baxi, when you turned on CH it fired the pump up. The stat was disconnected, it must have been in there from the previous system, would have just been a fire so that explains...
  13. S

    Baxi Bermuda no hot water

    No heating cables altered. Yeah I’m wondering if there’s a JB under floor for all the terminals that I’ve not found yet. There’s every chance a cable could be loose as when I was working under the kitchen floor there was hardly a clip in sight, between me & plumber being under floor cables would...
  14. S

    Baxi Bermuda no hot water

    Can’t find the wiring centre, thought it would be under the floor beside the Baxi boiler as that’s where the pump is. Would it now be wired into the cylinder stat before the valve first though? I’m getting no power at the cylinder stat at all.
  15. S

    Baxi Bermuda no hot water

    As usual, a problem arises nearly last thing on a Friday!! Was wiring a kitchen for someone this week & the customer noticed this afternoon before I finished there was no hot water. Central heating is working fine. The back of the programmer shows it as fully pumped on the selector. Getting no...
  16. S

    Fire panel & detectors system

    Thanks for the reply. Will head round a look later & check those things. Had a feeling it was just gonna be a resistor in each until I found the problem.
  17. S

    Fire panel & detectors system

    Hopefully someone who works with these regularly can hit me with some sort of tip here. Hotel owner I know decided to change all his detectors now it’s coming up general fault on the panel. I’m guessing he hasn’t noted in & out on cables before replacing but he’s sure he did. He also says it’s...
  18. S

    New smoke detectors law

    This new law coming in, noticed it’s saying a detector in every circulation space. What are we classing as circulation space? This mean every bedroom or will you still get away with having them within 2m of bedrooms?
  19. S

    New build query for Scottish based electricians

    Been asked to carry out the electrics in a new build for someone I know. Although I’m a qualified electrician I’m not registered with Select or a similar body, I know it is advised to use someone from one of these bodies to carry out work & sign it off but where would I stand legally if I just...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Back
Top