amp

Recent contents Top users
  1. D

    EMINoise filter amp ratings?

    if a servo driver has a amp rating of 9.5 amp single phase 240V and peak current at 30amp what amp rating should be chosen for a emi power/line filter? thank you.
  2. H

    Wall lights 5 amp fused spur

    Hi. I wanted to run a 5amp fused spur from a nearby socket but find its already a spur ( only one cable in). Help please.
  3. drounds67

    multiple 2 gang 20 amp outlet box wiring on new gfci breaker

    I have a question on wiring to make sure I am doing it correctly. I plan on adding a new GFCI/AFCI 20 amp circuit breaker to my box and run the wires to the first 2 outlets in a 2 gang box I am installing. I am also installing 2 other 2 outlet boxes. This is in a finished garage. I know how...
  4. J

    1.25 flex of a 13 amp fused spur feeding a 3KW immersion heater

    How tight is it running 1.25 flex from a 13 amp fused spur feeding a timer for an immersion heater?
    • Jako13!
    • Thread
    • 13 amp amp feeding flex fused fused spur heater immersion immersion heater spur
    • Replies: 12
    • Forum: UK Electrical Forum
  5. R

    Can I run a 50 amp subpanel directly from main metered panel

    1990s home. 100 amp main feed. Nevada. 15 years mechanical experience on cars + motorcycles. Previous electric exp: I ran the other 50 amp 4-wire setup directly from the interior subpanel. Now I was told by an electrician when I was shopping around to get the above job done, and a 30 amp plug...
  6. P

    100 amp service entry through shed wall

    I have a 4 wire 100 amp service run through 1-1/4" pvc underground to my pool shed. I need to take those wires and some form of conduit through a tuff shed panel wall to an interior sub panel. I will have at least 5 other circuits needing to go through this wall in roughly the same area. 2 20...
  7. txsmed

    Crouse-Hinds LW020PR Rainproof+ 200 amp main lug. Will it accept tandem 20 amp breakers?

    I need to free up space for a 50 amp breaker by combining 2 20 amp into a single tandom breaker. I can not find any information on this model number. Will this lug accept tandem breakers.
  8. timhoward

    20 amp RFC, ok or not?!

    We ran into this question on another thread. A couple of people I respect a lot have suggested it's ok. I'd always believed it wasn't ok. I'm sure it's actually safe, but does the letter of the regs allow it? That's the only reg I know of for an RFC too. It does actually specifically say...
  9. w0z

    Recall: Proteus Switchgear - 100 Amp Double Pole Isolator - which might not isolate.

    Disconnect once check twice..(or more) Found HERE at Trading Standards Risk level Serious Risk type Electric shock Risk description The fault was identified during routine installation process which includes a test. It was found that the switch did not isolate the circuit. The product does...
    • w0z
    • Thread
    • amp double isolate isolator might pole proteus recall switchgear
    • Replies: 21
    • Forum: The Electrical Exchange
  10. M

    Advice Regarding Connecting 16amp plug to 32 amp

    Hi, I am an amateur with little knowledge of electrics, so please bear with me. I recently bought a petrol generator Pacini 6.5KVA Petrol 13HP Generator, Electric start - https://ige.ie/pacini-6-5kva-petrol-13hp-generator-electric-start The purpose of the generator is to power basic...
  11. justcurioustwo

    What is an electric "amp"-?

    I believe "current" is the rate of flow I believe "watts" volume of mass I believe "volts" is the force Then again I am not sure. Then again all the above are means to measure something from different points of view while not understanding/explaining what "it" is.
  12. H

    Will a 14.5kw oven work on a 32 amp connection?

    Hi I have been having problems with my cooker and want to change it. I have looked at several that say a 32amp permanent connection is required, which is what I have, however, I don't think the specifications sheet is correct. An example is 14.5kw cooker should be on a 32 amp connection...
  13. C

    Direct Burial 200 AMP - 250 FT runs

    This is my first post... I am not an electrician and I am trying to build a house in the Hudson Valley. The quote for 200 amp underground wire IN conduit came in very very hight. The electrician (good guy) said that these covid days conduit has tripled in price. So MY questions are A) is it OK...
  14. S

    Can I bypass the 13 amp outlet on my cooker circuit?

    Hello everyone, I am no domestic electrician but I do work as a designer in the railway, low voltage signalling circuits etc. My question concerns my oven. I have just bought a second hand double oven of the internet and went to fit it in my rented house. The existing oven is connected using a...
  15. C

    Would a breaker be bad if it reads no voltage at breaker? The 50 amp gfci breaker for my hot tub is not reading voltage

    The 50A gfci for my hot tub is not reading voltage.
  16. Rob Plant

    Why do mA and A settings on multimeter give different result?

    With apologies in advance for the newbie question... I'm using a multimeter to figure out the source of my battery drain, so attempting to measure the leakage current between my battery terminal and its lead. When taking the readings shown below, they are quite steady, but as you can see, on...
  17. C

    45 AMP DP ISOLATOR SWITCH TO IMMERSION HEATER QUERIED BY ELECTRICIAN

    Hello All, Sorry if this is a ridiculous question - as I am not an Electrician I wanted to check whether my initial thoughts were correct before answering a question from a neighbour I have been asked by a neighbour whether a 45 Amp DP switch with Neon indicator is a correct isolator switch...
  18. J

    Why is my power supply giving more than it says it should?

    Hi, I'm new to electronics and exploring the basics so please please forgive me. Currently I have a simple circuit with a 12V,1A PSU, bulb and mulitmeter. When using the multimeter to meaure the bulb's resistance I get 4.5 ohms and then 12V for the voltage across the bulb. According to Ohm's...
  19. W

    Connecting 2 3.5kw ovens

    Hey people, i have two 3.5kw ovens to connect, customer has an existing 10mm t and e in situ on a 32 amp breaker, would this be okay in your opinions
  20. K

    Food trailer amp socket advice

    Hi there Asking for some big help!! I have Jsut had a permanent pitch agreed, yay! For a food trailer. I keep trying to get my head around the amp socket that the supplier would need to have installed... I am wanting to run - Potatoe oven Stove top Water heater and pump Coffee machine...
Best EV Chargers
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

YOUR Unread Posts

Daily, weekly or monthly email

Receive a daily, weekly, or monthly email containing a digest of new and recently updated threads.

Advert

TrueNAS JBOD Storage Server

UK Tiling Forum | Tilers Forums
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Electrician Tips from Professional Electricians
JBOD Forums: a forum for JBOD storage server advice
JBOD Suppliers: JBOD Storage Server Supplies
Back
Top