Doing an CR on a very old period property with some very expensive original features. It has been rewired around 10 years ago but they have reused the old original switches, some of which I believe to me 70-80 years old!
A few of the switches are clearly arcing when moved so C1 noted.
What...
Guest569
Thread
arcing
condition
light
old
original
others
period
pretty
switch
switches
"Hello All",
I have just read about this Today in the Installer Magazine [Gas related]:
A `Gas Fitter` soldered a copper joint on a Gas pipe next to an Electrical cable - He burned the insulation on the cable which He `repaired` by putting some insulation tape over the burnt area - arcing...
Why do the Neutral connections seem to burn out more than the line?
Is it because the Neutral collects more debris, harmonics and all sorts of junk like that?
It seems that the Neutral conductor connections are the ones to watch and I am not sure why.
Any opinions are welcome.
Thanks very much.
When we first moved into our house about 16 years ago the whole of the downstairs power, including the kitchen was re-wired by Eastern Electricity. The ancient fuse box was replaced to a Wylex consumer unit (I think 12 way) with mcb's and 1 rcd in it.
Also power was added to the loft...
Tom J
Thread
arcing
bedroom
coming
dangerous
electricians' talk
fcu
problem
socket
sockets
type
upstairs
Hello all, Been to look at a fault today which consisted of the lighting circuit tripping the mcb. When looking into it further no obvious fault became apparent. When I took a look at the d/b I found some scorch marks and melting of the plastic on the neutral rod from the load side of the main...
Hi
I read somewhere that i could clean my amplifier inside with this product, i promptly bought some and sprayed it all inside, switches, pcb etc. I am now worried that i may have overdone it and do not want to power up incase something untoward occurs. Could someone please advise me on this...
pzblues
Thread
arcing
aus
clean
contact
electricians' talk
switch
Hi got a problem with a PIR I am doing got small arcing when putting bond on to main gas pipe getting .5v when measured across pipe and bond had gas board out they proved that incoming pipe is in plastic disconnected all earths and still getting it discon earths and neutrals still getting it.
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc