Hello,
I have an ARITECH alarm system CD 34 with currently an alarm transmission using fixed telephone line (RD6201) and voice extension (4 audio messages broadcast when the connection is established).
Question: I would like to delete the fixed line (terrestrial) and use a SIM card transmission...
Hi.
I am a diyer and very new to anything electrical.
I was hoping to put a new outdoor ip camera up outside the house. At the side of my house I have a boiler room that has a light and switch inside it. This light is fed off the light ring at the breaker as I tested it before hand. My plan...
Smoke Alarms Not Waking Kids Up (Which smoke alarms will wake a child??)
It seems that many high pitch smoke alarms wont wake up kids.
#WakeUpCall
They're trying out smoke alarms that use a human voice with a low pitch.
It's on WatchDog right now.
So does anybody have any experience with...
Hi Guys, I have asked this question before in another thread that I was following, but can't find it.
I've installed a CCTV system. What I'm after is a 10m x suitable Cat 5 or 6 cable complete with plug ends fitted.
I believe it was suggested that copper solid 8 core cables are better.
The cable...
My 27 year old doorbell started to hum & buzz all the time. Replaced it & the push button and the doorbell still hums & buzzes. Replaced the transformer and the doorbell still hums & buzzes. What else could it be?
Hello lads. Just want to ask how much learning is involved with moving into Alarms, CCTV an Door Access. I’ve done a lot of Fire for Protec Fire Detection, both addressable and Conventional, Vespa- Cirrus Pro, a little bit on PA systems etc. I basically have limited installation experience on...
Hello lads. Just want to ask how much learning is involved with moving into Alarms, CCTV an Door Access. I’ve done a lot of Fire for Protec Fire Detection, both addressable and Conventional, Vespa- Cirrus Pro, a little bit on PA systems etc. I basically have limited installation experience on...
Hi all I have a abacus panel I want to put new bell box in It’s a Texecom premier odyssey 1e. Can anyone please help has anyone got instructions for wiring please. Also. 2nd question can I use any keypad with the abacus panel. I have a Texecom panel is it ok to use if so looking...
Hello, my Esser IQ8 control FACP is displaying an O/P fault 046. I have tried to see if its a zone or an address or a device. Still havent been able to rectify the fault. And what's the meaning of the O/P fault. Please anyone help. I have been on this for two dats now. All troubleshooting is not...
Hello, please i have an issue with the Vesda Xtralis air aspirating system. The system is connected to the central FACP. And formerly coming on alarm fault and fire alarm. But i was able to solve the problem by servicing devices connected to it and changing the resistors. Now the fault was...
I was working on this addressable system an Esser IQ8 control Facp. And the system just came on CPU failure. It started coming on fire alarm. Dont know what caused the CPU failure and if the CPU board or mother board may be damaged and needs replacement. But i perceived a small of burnt on the...
Please how do i start to check for system fault on panel short circuit. I was able to solve this problem before but now it's taking like forever and am getting frustrated please help. I am working on a Esser IQ 8000 control FACP.
ive ordered a gjd xl opal. My driveway is approx 10m deep. The idea of the detector is to alert me inside, using the gjd controller for activity on the driveway. Would I be best to mount the detector above the windows on ground floor or put them on the ground near the pavement facing the...
Evening all.
I have a home CCTV system which I had connected to my broadband router with Ethernet power line adapters. These have recently stopped working and I am looking to replace with Ethernet cable between DVR and router.
It will be running under the floorboards in the bedroom and then...
Good afternoon all,
I am new here, so please excuse my inexperience...
I am looking to add CCTV external outdoor microphones (Netview External microphone) to all 10 of my IP Camera's (Bosch FLEXDOME 5000 outdoor HD). The IP camera's are some distance away from the PoE Switch and NAS storage...
Hi all!
Just wanted to get everyones opinion on the best CAT5 & CAT6 cable which you’ve used on jobs.
I have been using VueNet Cat5e and really like it, not had any problems and is at a decent price.
Let me know what you think :smiley:
Hi all
I have a customer having issues with their Blupont A72 DVR system.
System is plugged in, cameras working and confirmed recording. I'm trying to connect to their broadband so that I can set up mobile access to the camera feed. The system is in the attic and uses plug in network...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc