My house had previously been wired for a generator (probably not by code to this day) but previous homeowner disconnected and instead hooked up car charger to that circuit. I would like to place it back to a generator hook up plug for emergency power. I have included labeled pictures of outside...
Good Afternoon All
I have quoted for the installation of an EV Charger that is located in an underground car park. I don't install many however when I have done before I have installed the Zappi Chargers. I am wondering whether they need an internet connection to both set up and use. The reason...
I currently have a level 2 Tesla wall connector installed on a 60amp breaker via 6 AWG wiring. I need to switch the wall connector out with a different charger brand. The problem is that the Tesla is hardwired through the top, and the other wall connectors I'm considering are fed through the...
Just a question as I’m waiting for a new electric car to be delivered and they have included installation offer when it arrives free of charge. However, I’m a bit concerned as to whether they will need to get to the main switchboard which is all the way round the house which is going to be...
Hi all,
I've installed a Tesla Gen 3 wall charger supplied by my client.
For your information, the place that I installed is in a block of flat basement where the Meter room is.
After some researching, I've fitted a Proteus board fitted with SPD and PEN fault detection device.
All dead test...
I’m getting a Audi Etron this week and need to install a car charger, I was looking at the Ohme charger as it ties in with Octupus Energy supplier but open to input from you guys who install them daily.
Thanks
Hi I have a job at work, an ev charger keeps stopping functioning, the company that looks after it has been out and said its not there problem, the supply voltage is 205v ac, (I still need to check this) but is there a step up transformer out there that that can increase the voltage to 240v...
Customer wants me to mount his EV charger on the back of an external, plastic meter cabinet. The cabinet is a new plastic one at the other side of his drive from the house with a separate consumer unit inside. This would be an ideal location for ease of installation.
Is this allowed or will I...
I have an issue with the GFCI breaker that was installed by my local electrician. It is not supposed to be installed with a charging circuit interrupting device (CCID) protection that is my charge point homeflex EV charger. Especially if using a plug.
I would love to just replace it with a...
Dear Sir,
I'd build a simple voltage divider charger with 1 Amp diode from 4.8 AC - DC adapter (500 ma - output volatge - 4.15Volt) to charge my two AA battery.
My Battery finished charged was 1.25 (Sony 4600mAh), but it can only be used within half day.
I suspect It may not enough...
Hi there, please be patient with me because I'm old and still learning. My electrician nephew is being inundated with EV Charger requests. He's fully qualified and has NICEIC accreditation too. I registered him for Ozev, but if I'm honest I don't understand it. Should he also be on the UK...
Hello,
I have a EV charger that is reporting over voltage and is unable to charge. the charger will operate up to 253V
The solar inverter reports voltages below 253V and when the solar is shutdown and isolated the incoming supply reports voltages in excess 248V consistently, peaking at 256V...
Hi. I’ve got two pendant lights that currently run halogen lamps. One of the converters is broken so I’m planning to change both for LED lamps. Please could someone let me know what LED charger I need to buy for this. Ideally Amazon for quick delivery. Photos of the lights and the existing...
Hi Everyone,
After a long time of research and development, we are finally proud to launch our new smart EV Charger: The NexBlue Edge.
Before we launch our new product officially, we would like to get professional electrician’s feedback on the installation and the usage, in order to be...
I am looking for advice on getting an upgraded 25 meter extension cable from my office into my car park to charge my EV from an IP66 rated socket, from a standard Tesla 3 pin plug - plug in charger. I know not to use normal off the shelf extension cables as they're naff, melt and are a fire...
Hello everyone!
I am curious to know if we need a new Electrical Installation Condition Report (EICR) after installing an electric vehicle charger at our property. Does anyone have any knowledge or experience with this? Any advice would be appreciated. The most recent EICR was only issued in...
my son has recently had an ev charger installed for his car (last week) cost was £900, simple run ,consumer unit on outside wall ,drill through to garage and armour cable run of 3 metres to the charging point.Not disputing the cost as hopefully they have provided the relevant certs etc.
now...
Had an EV charger installed in July last year. It’s wired directly off the mains.
Since end of November anytime I plug the car in to charge, the earth/ground wire in the cabling in other appliances in the house is overheating and melting components of the appliance until the main RCD trips...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc