Good morning fellow electricians. Now, as I am sure you have all been enjoying, I have not been on here much lately, as I am jacking in very shortly, or at least not renewing my scam membership. So, with only 20 days left, it has just occurred to me it might be a good idea to install myself a...
Hi there,
I have just joined the forum.
I have been involved in the electrical and electronics industry for over 40 years. I am now involved with Electrical Vehicles, and run a charge point installation directory. I am here to learn and hopefully give any advice where possible.
Cheers
Gaz
Hi
Apologies if this is dealt with elsewhere, but I haven't seen anything.
I'm fitting a new bird nesting box which contains a wireless camera. It will be attached to a battery which will in turn be attached to a solar panel. I'm hoping to avoid the need to constantly bring the battery in to...
I have a nice job on in a few weeks which includes wiring up a solo chargepoint EV point. The pod doesn’t have its own RCD like Rolec do.
I am rewiring the house and intended to use either a type A RCD or RCBO.
As they also detect small levels of DC leakage.
I use BG consumer units but I...
Good afternoon ladies and gents.
Could someone please tell me if qualifications are required to install the above kit, or they need to be commissioned by someone approved to do so?
Thank you.
Looking to get trained/qualified on the EV charging point installations.
To those of you who have gone down this route which way did you go about it, is it worth getting training by one of the manufacturers or the training centres like nic?
I am currently doing an EICR in a warehouse and one of the circuits is for a Fork Lift Charging point (32A) In Light of the 18th Edition and all circuits being protected by and RCD, should I recommend that the MCB that is feeding that circuit at present be changed to an RCBO ??
I'm having problems with my central storage heater. Its an old 1970s one that does the whole flat. It worked perfectly up to the end of last winter, then just stopped. I woke up one morning to find it was only luke warm from the previous day and hadn't stored any heat so became stone cold over...
Hi all,
I have been asked to install an EV charging point for a friend who doesnt have an electric vehicle but would like either a cable ran in or a charging point installing to future proof his home.
My local training centre runs a course for EV points and I was wondering if the course is...
OK, we have yet another project on the horizon but this one involves battery charging.
We do a fair bit of battery work already with large battery UPS systems but we will have a requirement for charging batteries up before sending them to site for installation.
I used to work in battery bays...
Hi all, I was wondering how much hourly rate I should be charging? I recently quoted a job only to be questioned if I was an electrician due to being too cheap.
I’m thinking of upping my rates but want to keep at an honest and fair price.
Hi all,
I'm setting up a split dual-battery charging system that appears sound to me, but i haven't seen it done before, and my main concern is how the alternator will react, and thus whether the source of the S wire should be changed....
The original vehicle is a Toyota LandCruiser, 1HZ motor...
Wiring up a series of offices in an converted factory unit, all well and good.
They have asked us to install a car charging port for one of the managers cars, we have never fitted one and have no interest in getting in to fitting them, but we need to do this as a one off.
TNCS, will be approx 5m...
Just a thought where do you guys put the earth spike in when you install car chargers? Local to the charger? What if it’s a driveway? Slabs block paving etc
Hi Everyone!!
I need some serious advice please
History: The Car was working fine and there was no electrical problems
Had to repair the alternator / PAS mounting bracket and after putting it all together I accidentally put the battery warning light cable onto the W terminal and it did not...
I noticed a little nudge from Dan about deleting our account if we don't post an intro and so here it is.
I run Chargebase and we are an EV home and commercial charger installer based near Fleet in Hampshire. The business is owned and run by two of us and our work is contracted out to NAPIT...
Guys, i like to have a broad knowledge base and range of work, as i get bored doing the same things day in day out.
From working on F1 hospitality units, to kitting out warehouses, to a little bit of domestic (however i generally hate domestic Re-wires, so rarely do these).
I have been...
Obviously going to be a big thing in years to come but do you think it's worth going on an electric vehicle charging station install course? I'm pretty sure there is going to be some alterations in the upcoming 18th regs about this but my main concern is whether it's worth doing on a self...
uploaded this info from the iet guide for people interested or unsure about the earthing issues for ev charging. apologies if this breaks some unwritten rule about uploading information but its not for commercial gain or profit purely information purposes.
It may change a bit come 18th edition...
Been tasked to put a quote together for 3 EV chargers. The client wants a super fast charger and seen a few online - Rolec Basic charge to be exact.
The supply is fine, I’ll send out a 6mm 4core SWA.
I can’t seem to find anything on banging in an Earth stake? Im unsure if it’s a necessity...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc