checking | Page 4

checking

Recent contents View information Top users
  1. R

    Help checking lighting circuit

    Hi Guys When checking a lighting circuit you obviously need to check at each point on the circuit, switch and light fitting. What do you do when you can't get to the cable in the light fitting?? For example, in my kitchen I have 3 spot lights on a bar. I'm not able to remove the bar...
  2. M

    Checking your electrician

    Anyone coming to the forum looking for advice ect are most welcome if looking for specific advice it may be helpfull to give details of location and one of the forum members located near you might be in a posistion to assist Any electrician proclaiming to be part of NICEIC SELECT NAPIT ELESCA...
  3. G

    system for checking accuracy

    I have seen a card that allows you to check your multimeters accuracy on resistance measurements. Does anyone have a link to somewhere I can get one please?
  4. S

    Site survey for MCS

    I'm about to do my first sight survey. This will be for my MCS job with the NICEIC. To be honest i'm not 100% sure of what i'm doing but i think the only way to get to grips with it is to work one out. I'll be measuring the roof, checking the exact direction it faces, working out the roof...
  5. G

    ring mains joined

    continutity tested both rings no earth on 1 and no live on the other every thing works on sockets when swiched on but get high readings on 1 ring when other reads ok help please every thing diconnected from sockets when tested
  6. D

    Cal Checking Your Test Instruments

    I use a Megger MFT all in one tester. The NIC inspectors are not impressed with just flashing a 12 monthly calibration certificat in there face. So I need to purchase a test box and log the readings. So can anyone advice.Whats on the market with regards to test boxes. Plus any details on...
  7. S

    Checking an energized relay

    How can we check normally open and normally closed contact of an energized relay using multimeter?
  8. zone77

    checking rcd tester

    i ve got my NICEIC inspection at the end of the month and just wondered if using a cheap plug-in RCD unit is ok for testing if my instrument is accurate.:cool:
  9. N

    Just checking installation,

    Hi all, Right i just need my workings checked before i do anythng. I have a shed that needs power. Its roughly 10m away. Im using a 40 A MCB in the house CU and running 6mm SWA from there to a second CU in shed which will be using a 40A30ma RCD as its isolater. The CU will have a 32a ring...
  10. O

    main fuse

    Hi Everyone We All Know You Should Not Pull The Main Fuse, Its Down To The Big Boys From The Board.(in A Perfect World) But If You Didnt Have A Double Pole Switch Fitted, And You You Needed To Pull The Main Fuse To Disconnect Main Tails In Front Of The Inspector From Niceic, Do You Think...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top