I recently visited a restoration project which is massive in scope, and being carried out mainly by volunteers.
During the tour I was intrigued to see some different approaches to cabling, but when I enquired I was told that Juan did this room, Pedro did that room etc etc...so there is no...
Hi Everyone ,i need a advise please:basicaly i got two system boiler with one imersion heather ,they must be combinet in one way.If in any reasone boiler number one lost power ,boiler two supposed start working ,two boiler on different phases .
please if any one had simillar situations ,any...
I wanna control (reduce) the speed on my AC duct fan by inserting a variac between the mains and the duct fan.
The duct fan is currently connected to the mains (230v) in a junction box close to where I wanna install the variac (3 meters).
The variac has 4 connection-pins:
L - mains
N - mains...
Is it common to get different test results when upgrading a db? Basically I done an EICR in November and came back to upgrade the db and done live tests on all the circuits, but my results were quite different. Like 0.30 ohms out on one circuit
Hi, Before I start any changes that I make will be thoroughly checked over by a professional electrician for official sign-off. I am doing it as I am a capable DIYer and want to save costs while enjoying the fruits of my labour.
Having said that I am installing a new kitchen where the existing...
Last couple of days, the forum runs slow.
It can be fine when first opened, then after a couple of minutes freezes, or I get an error message.
This is using forum on iPhone 11, haven’t tried laptop yet.
Closing Safari down, then reopening seems to help… but a few minutes later, it happens...
Hi, I've had an unusual result from taking a Ze at a clients house and wondered what everyones take on it would be:
The property is TN-C-S
A Ze reading from a disconnected Earth to Line gave a reading of 0.45 ohms
A Ze reading from the Line and Neutral gave a reading of 0.33 ohms
A TN-C-S...
I am building an alternator of my own. I have found that by putting 6 points around my magnets crates an insanely larger amount of electricity with very little force. I am producing around 20-25V out of each point totaling around 125-135V total ran off a tiny little airplane motor and 2 1"...
Hi.
I have a radial circuit supplying electricity to the garage (part of the house). It's on a 20amp breaker, uses 2.5mm cable. It currently only supplies a single socket. Before anyone asks, its 100% a radial circuit. 6 months ago I had an electrician install a new consumer unit, and the...
With apologies in advance for the newbie question...
I'm using a multimeter to figure out the source of my battery drain, so attempting to measure the leakage current between my battery terminal and its lead. When taking the readings shown below, they are quite steady, but as you can see, on...
I have installed some lights to a wooden gazebo and the wire seems relatively thin ( the lights are 30 LED 0.6A each. I’m getting an infrared heater which I suspect will have a thicker cable. It would be easy to run a short cable to connect to the light cable to power the heater. Are there any...
Hi Everyone,
What are your thoughts on adding a different make of battery back up mains powered smoke alarm?. The quick back story is that there are 2 BRK (I think) interlinked alarms fitted in a property and that particular make are now discontinued. Building control now want an extra one...
Hi there! Looking for advice from anyone who knows about bathroom extractor fans. I have a dead one of these P Fan - https://www.greenwood.co.uk/product/138/p-fan ... Is this Manrose XF100LVT/SC 10W Bathroom Extractor Fan with Timer White 12V -...
I replaced 2 side by side rocker switches with 2 smart switches, one controls the kitchen lights and one controls the chandelier. There were 2 separate black wires coming from each wiring box that were twisted together. No tape or cap. Why would they be connected? And is this safe?
Hi,
I've got 6 Luceco downlights in my cellar. One is now flashing on & off. I've taken it out & can see that it's a contained unit, I can't replace the bulb.
Is it possible to buy a different Downlight to replace or do I have to buy the same model?
Thank you.
Hey holly electricians, I am asking are live and neutral wires different in composition or same but just some different colors of insulation. Was one type of wire just designed to carry electricity and the other to be a neutral one.? Are they different in composition? For testing purposes if I...
Dealing with a noodle scratcher.
Trying to figure out what has caused multiple GFCI outlets on separate circuits to trip at the same time.
Over the last two Wednesdays in the morning something has happened which caused multiple GFCI outlets throughout the house to trip at the same time...
Hi
On Friday I found 2 x 13A double sockets about 30 cm apart in an office. One of them was on same circuit as all other sockets in same room. The 2nd one had been added, and drilled through from the adjacent office. The circuits are on different phases. Common sense dictates that a 400v...
Hi All,
Background: I work for a solar and electric distribution company and I joined this forum to help myself learn about the more uncommon parts that are sold less often.
Question: In what situation is it appropriate to use different colored 4/0 gauge wire? I understand that amperage...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc