Hi everyone
Commercial dishwasher stopped working. Water heats up but when the temperature reaches the right temperature the wash start button doesn't start the wash cycle. Checked everything out. Buttons, motors they all fine. Drain pump works but the behaviour is whacky. Normally you press...
Hello!
On Friday the RCD tripped and I narrowed it down to the dishwasher which was about half hour into a cycle at the time. After a couple of hours everything was fine and it worked perfectly without tripping it.
Unfortunately it has happened again this evening, about 10 mins into a cycle...
Hi,
Currently having to plug swap when wanting to use the either appliance (for safety as they both draw appox 10amp each). Looking for advice on what to ask a sparky to fit.
Can I ask for a single socket to be spurred off the current double socket, and plug one of the appliances into that...
A while ago the plastic switch that turns our dishwasher on/off came loose. We worked out wedging a paperclip into the switch held it in place and stopped the dishwasher from switching off. However, a few days ago after wiggling the paperclip back into place, I believe it caused some kind of...
Evening folks, I hope someone here can help me? I recently found on removal of my knackered integral dishwasher the plug that had evidently been pressed against the back of the dishwasher has melted and fused with the dishwashers insulation.
I have lived in this house since brand new and moved...
Hi,
We have a dishwasher that when it starts then there comes a pause for about 6-7 minutes before it starts working. It ends each washing program with satisfactory results.
I can't remember as if it has always had such a pause or not, thats why I wanted to ask you who have the knowledge if it...
hi all, we have a serious problem with our sockets. My partner turned on the kettle and it tripped the RCD, he unplugged it and turned the electricity back on but all sockets in the kitchen don't work anymore except for the cooker and dishwasher (electrician said they could be on a different...
Caz
Thread
cooker
dishwasher
earth
kitchen
not working
sockets
working
just had a customer in the phone saying that an engineer refused to work on her broken dishwasher because of a failed earth loop test and no rcd being present
The setup is as follows
Tt supply
From the House consumer unit a 10mm twin and earth runs through the house buried in the wall...
Hello,
The layout for my kitchen, which is not installed yet, is such that there is a free-standing dishwasher and washing machine on either side of a cupboard which has the kitchen sink over it.
My builder who recently re-wired my house has installed the wiring so that the plug sockets for...
I have recently had my house flooded, my insurance company have redone my kitchen but changed the location the dishwasher will be in to get it closer to the plumbing. I need to get power to the dishwasher but the socket above has already been spured (more than once and not by me) so don't want...
Was looking at a job where the customer wants another dishwasher same as the one that they have. The one they have has a rating plate which says 6.6kw/12.4A. It is wired in 6mm on a 40A mcb. Length of run is 10mtrs. Now I would have thought that 400x1.732=692.8
6600/692.8=9.53A therefore a 2.5mm...
Hawk
Thread
3 phase
cable
current
dishwasher
machines
phase
power
small
Hello
Ive just fitted a new dishwasher and after finishing the tedious job of fitting the door cover etc The second manual states that it must be bonded. So I pulled it back out and there is a screw on the back in which to earth.
My questions are, does the dishwasher actually need bonding as...
Hi, I realise here isnt many appliance guys on here but I have been testing my heating element in my dishwasher because the water wasn't heating up, I am getting 28 ohms on the element but not at the spade connectors where the wiring plug clips on, should I get 28 ohms across the spade...
Hi folks, first time on the forum so please forgive any technically inept terminology, but just wanted to seek some advice on an issue with domestic wiring. We recently had a new kitchen installed, and a new 30A circuit was required for an induction hob and double oven. The installers set up a...
Chaps, I'll don a tin hat here as someone is going to tell me I'm dim.
Problem is this: old property, plug socket under kitchen sink, it powers the sink food disposal churner thingy but when I unplug that and try to install a new dishwasher it won't send any power to it?? I just tried plugging...
big gus
Thread
dishwasher
electrical work
fault
faulty
power
socket
washer
won't
works
Customer has been trying to use a dishwasher using Economy 7 at night, and its not working properly. Works fine during the day, Miele engineer says nothing wrong but the cause of the problem is a pressure switch that ends up with the dishwasher failing to heat the water.
Water pressure has...
Hello all,
i have an issue with a commercial dishwasher who has been checked by an Engineer with no fault.
RCD trips as soon i switch the wall socket,however i've unplugged every plug i have and surprise it does not trip.
now,i've tried to see if have split load,correct me if i'm wrong,i did...
ragtime27
Thread
commercial
dishwasher
other
rcd
rcd tripping
socket
tripping
Commercial dishwasher in a site i look after went 'pop' today, it stopped working a couple of months ago and i found a 4a fuse had blown on the PCB. I changed the fuse and it has worked fine until today, took the cover off and saw one of the three heating elements has burnt out.
Found the part...
I have a 2 year old Hoover dishwasher and a couple of days ago it started causing a burning smell. At first we did not know what was causing the smell but have now worked out it is the dishwasher.
Today I pulled it out and all looks OK. I sniffed the plug and that had the remnants of a burning...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc