earth rod | Page 4

earth rod

  1. A

    Earth rod for electric fence

    Hi, We run an electric fence configured as follows. A PEL energiser is powered from a 12V battery (with solar panel), the output is in the form of two leads, the "Live" output connects to the fence, and the "Earth" output connects to an earth stake, currently a galvanised rod driven about...
  2. G

    Eicr earth rod over 200ohm

    Earth rod measures 247 ohm, with water and gas connected 233ohm. All covered by 30maain rcd. C3? Improve the rod reading to below 200?
  3. uksparks

    Earth rod spacing

    Hi, Just a general question, I have never installed an earth rod so don't have any experience in them, but would like to think I know the basics before I come across one I have to install. My question is, presumably I would be correct in thinking the 3/8 rods are not worth the time and should...
  4. W

    Earth rod

    Is it okay to fit a 16mm earth wire to a galv rod without an earth pit or mechanical protection? I think I read in the regs it was ok, as long as 16mm? Help appreciated
  5. B

    Earth Rod Issues

    Hi. Has anyone used Bentonite for a high resistance Earth rod? If so, does it work & where can i buy it as struggling to locate in builders merchants??
  6. D Skelton

    Earth rod inspection pits

    Bit stuck here guys, I'm looking for an earth rod inspection pit that I can mount/sink neatly into a paving slab that isn't going to stick out like a sore thumb in my customers patio. Any ideas? I can't seem to find one anywhere that isnt rounded at the edges and bevveled into the pit. A nice...
  7. A

    earth rod test

    Hi All When testing a tt system, if you cant locate the earth rod is it ok to carry out a ze test for that supply and put a limitation in the earth rod section of the test cert. if not can anyone suggest how to obtain the correct resistance measurement with only the earth cable at the board...
  8. ringer

    Safety electrical connection label on Earth Rod

    About to put in a 5/8" rod, unsure how best to label it up. Cannot take a BS951 label off a clamp as no way to fix it - large screw on rod clamp is too big.Wholesaler gave me a label with small fixing hole and a cable-tie - surely this is not good enough? How do you guys (properly) affix a...
  9. vxwestie

    two installations, one earth rod

    A customer of mine has two installations (self contained barn coversions) connected to the same earth electrode. Each consumer unit has a 16mm cable connected to the same rod. I cant help thinking this is poor practice, but what regs does it break, if any?
  10. D

    Earth rod testers

    It's pretty rare that I come across TT installations, but recently been looking at investing in a bit of extra kit so thought I'd take a look at earth rod testers. I'm amazed at how expensive they are! Some of them are extortionate! I don't mind spending money on something I'm going to use...
  11. H

    Bt installing earth rod

    Went to price a board change today, did the usual checks and noticed it had a tn-s and tt earth supply. Both met the required ze, however the customer claims that bt installed the earth rod years ago because his phones had stopped working and they said it was because the house had lost its...
  12. S

    Earth rod placement

    Have posted befor on similar topic, working on small touring campsite, all TT. Overall reading is 10 ohms. This being made by I suspect the newish pitch installations feeding back through distribution cables to office block. office block local rod cable was broke, replaced and ze is reading 108...
  13. S

    Earth Rod Cable and Clamp Fault

    On job today at small toruing caravan park entire site is TT The toruing pitches are newly cabled in last year sometime, the office block wasnt touched, but had been refurbished by MWPS (i think) the previous year A total rats nest in the loft, with cables cut and just left floating. The site...
  14. S

    Earth rod inspection pit keys

    On a job today and this pit is in position Toolstation > Electrical > Accessories > Earth Pit Plastic does anyone know where to get the keys for them, as I couldn't open it, it hasn't been opened for a long time and yet a full inspection was carried out in January for the sites ecr.
  15. W

    RCD and Earth Rod?

    Looking for help. I had a look at a friends flat, he said the walls in his flat were live when he put a Pen type voltage indictaor to the wall. This was after there had been a flood in the flat next door and his walls are soaked, literally. Sure enough the Pen stick did light up but I tested...
  16. H

    Using a generator to obtain a ze reading at earth rod.

    How accurate would the reading be? Want to do a quick test before the supply company comes to connect up. Don't have a proper earth rod tester but do have an Eli tester.
  17. C

    TT earth rod question

    Is it sufficient to just use a decent terminal cover on an earth rod or must it be protected by a proper inspection box?
  18. D

    earth rod box

    Hi all, does anyone know if there is a earth rod box enclosure that you can basically mount directly on top of a concrete path. Was planning on removing the old twig and using the existing hole to drive some new ones in, rather than risk hitting a service.
  19. M

    Help needed re using an earth rod in an out building (shed) vs domestic earth

    Hope you guys can help me - seems to be two different opinions and dont know which one is right. I have run a new supply from a house out to a shed/bedroom in the garden. The supply (3 core 4 mm) originates in the fuseboard in the house - earthing system for the property is TNC_S. The feed is...
  20. H

    The 5/8 Earth rod debate

    Did a re wire on a village hall TT system , after reading the threads on rods i went for it, chucked away the 3/8 twig coupled together 3 5/8 rods and away i went driving away with my 4lb lump hammer 3.6m of depth and got my ZE down to 14 ohms so i guess thats a ok reading for a TT well bellow...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top