Hi Everyone, before I start ill admit I have very little knowledge of EV chargers etc, I have had a question from a customer who has had a 7kw zappi installed and his wife has just bought an audi a3 tfsi e. This apparently will only charge at a max rate of 2.9kw as its a hybrid, hes concerned...
Hi Guys
Not been involved with any EV much as of yet. But time has come now with new LABC regs that we have to fit on all new builds.
Did the Niceic (think was 1/2 day) EV course 2-3 years ago, then signed myself up as a pod-point installer.
That was about it ! All the OLEV paperwork put me...
I have a single 7kW EV charger that serves three holiday cottage. The supply to it is E7, with the night rate currently at exactly half the day rate, so most users charge at night, controlling the charge from apps. on their 'phones.
Batteries are getting bigger, so it's becoming difficult to get...
Has anyone installed the Gen 3 Tesla EV charger. Is an RCD required at the supply as it says it has a type A one built into the unit. Also can anyone recommend a good Open pen detection device?
I'm going to start some construction projects at my own gaff soon, including sorting out some better outdoor supplies.
Currently have a 32a supply via SWA in what I think (need to check!) is 10mm which the previous installer has conveniently put a junction box join for right where I can...
I am looking to install an EV home charger for one vehicle, but possibly two in the future.
I have a second unused (but still active) mains supply cable from a time when we had electric heaters. Unfortunately the separate meter on this supply was removed a few years back. It would seem to be...
We recently had a solar panel system put it in. The solar batteries were delayed and put in after, at which point it became clear that the CT clamp for the solar system was positioned on the wrong cable. The inverter was reading the power generated by the solar system and including it in the...
Evening everybody.
A Landlord who's pub I do a bit of work in called me today to discuss putting an EV Charger in for customer use.
His idea was to charge £x for 60mins. I vaguely remember that Rolec had a token operated EV Charger but I'm not sure if they still make it. A fair bit of Google...
I’m looking to get my consumer unit upgraded in my Garage as it’s an old Chint board that is not very good..
My Dad is looking at EV Chargers too and I was wondering if it’s possible to get a consumer unit that would handle that. The current board has MCBs for
6A - Lighting
16A Electric Fire...
Hi there, new to the forum and in final stages of completing C&G level 3; need to complete design project to complete. Am struggling to get my head around how to draw up correct circuit diagram showing EF Loop path for EV charger where initial supply is described as 'three phase TNCS' feeding to...
Hi, I Bought a 32A EV Charger, it comes with a CEE wall plug. I need to use it with a 60A range recepticle which I use to plug in my welder. So obviously I need to change the CEE plug into a Range plug. There is no paperwork, no schematic. As the CEE has 3 wires Red, Black and Yellow/green...
Just saw this on BBC news:
https://www.bbc.com/news/uk-england-hampshire-61006816
Now re-directing to a pr0n site looks like a prank rather than a serious attempt to cause michief, but it got me wondering if chargers with internet access are being abused in more cunning ways?
Hello folks.
I am about to complete on a (detached) house purchase and I want to ask your advice whether to have three phase connected to the house and possibly whether I can have it connected for free.
I plan to have two Zappy EV chargers installed with them both charging at the same time...
Hi!
I’d like to install a pedestal-mounted (230 V, 30 A max - programmable) EV charger close to my driveway, which ends about 12 feet away from the house, on the other side of a landscaped rock wall of sorts. While I am at it, I would like to oversize the circuit to allow a second EV charger to...
I have a rolec ev chargpoint tester. Been asked for an ics ev chargpoint to be installed. Anybody know if the tester is compatible for the ics model please :)
Hi,
Early 1980's housing estate 60A large detached house supply looped through next door. What is the experiance in with Northern Power grid, re the un looping and who pays?
Hello again!
Has anybody got any experience of EV charger installation courses?
there are plenty about if I google it, of course, but would like to hear from anybody who has been on a course and found it helpful or otherwise!
Many thanks
Hi,
Am I correct in saying I can install a single pole Type A 30ma RCBO to feed an Hypervolt EV charger? the supply cable is SWA and the Hypervolt has in built 6ma DC RCD protection. The consumer unit is a Lewden board so would ideally like to install a SP RCBO type A, any issues with this? its...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc