flat | Page 3

flat

Recent contents View information Top users
  1. O

    Consumer Unit Positioning on New Build Flat (2011)

    Hi, I purchased a new build flat in Greater London, it's a duplex, the Consumer Unit is fitted in a cupboard under the stairs, however I have a massive boiler right up against it. So close to the Consumer Unit I can't even see all the labels located on the Consumer Unit, not sure how I would...
  2. H

    transit minibus flat battery

    Transit minibus Flat batteries in the morning Alternator working correctly With vehicle idle & all of there is a discharge if 0.31A Is this correct ? Is there anything which could cause a draw in the battery like this ? Would a draw in the batteries of 0.31A be enough to drain a charged...
  3. A

    Wiring lights in flat with concrete ceilings

    Started A job today, concrete ceilings, and was thinking of ways to get the cables from switch to pendant, and thought of chasing the plaster and artex of the ceilings, and glue gunning the cables up and bonding/plastering over, do you think this is do-able? Don't really want to trunk it, thanks
  4. S

    Bonding to a gas meter outside flat.

    Doing a CU change on a ground floor flat in a bock of low rise flats. The flat is next to a plant cupboard that houses a cabinet of 1361's with what I think is MICCs (copper covered, two cores) feeding each flat. It's a TN-S. The gas meter for the flat is next to the cabinet and bonded to it...
  5. R

    Office & Flat supply

    Looking for some thoughts and opinions on this situation. Looked at a burn out gutted old post office with an above flat needing to be fully rewired with extensive building repairs. The ground floor will be reused as a general office when it reopens. The D.L.O. head is situated in the post...
  6. C

    16mm T & E flat supply

    Existing supply is 16mm T & CPC to 2nd floor floor flat from ground floor communal CU! Fed via BS1361 60amp, after the incoming mains have been split between 2 meters! Incoming main fuse only 60amp too! Loop reading @ 2nd floor CU is 0.12 & PFC is 1.87kA respectively! Bit of an existing mess to...
  7. infinity

    flat roof mounting on domestic install

    I have been 'given' a job (friend of friend) to install 6 panels on a flat roof at their property, i have not installed any flat mounting systems as of yet so wondering if anyone can recommend a good kit manufacturer? Any advice appreciated.
  8. E

    Wood flat bits

    Any tips on the best flat wood bits? Bought makita ones - didnt last for even one first fix!!!
  9. P

    Pyro in a flat

    Hi I have been looking at a 1950's flat which is wired in pyro so would this mean RCD protection is not required?
  10. jengo22

    High ZE Reading in Flat

    I have been asked to carry out a rewire of a top floor flat when checking the existing supply characteristics. TN-S with a ZE of 1.24 ohms and PFC of 1.91 KA. 1361 Type 2 with 100 amp Fuse Should I contact the DNO and ask for them to come and check before commencing work. Unable to treat...
  11. A

    Flat on a Flat roof

    Being a bit of a numpty when it comes to PV installs, I have a question: I have a flat roof 5m x 4.8m SE facing, Flat to the roof is not so good I know, but I can get away with 12 panels. If I were to use maybe 15 degree mounts I am guessing I could get away with maybe 8 panels. If only for...
  12. R

    Flat supply wiring and fuse protection.

    Any ideas on this one? I am doing a survey/eicr on an intake serving 9 flats belonging to a local housing authority. The cables are early 70's 16mm/6mm T&E run through the building structure. I have assumed the maximum draw is around 30A per flat and checking the Ze values and distance it...
  13. F

    10kw Flat Roof Solutions with Low Ballast

    Can anyone recommend a good flat roof solution without penetrating the roof. I looked at renusol consoles today, however their wind load calculation suggested I needed a ballast of 320kg in each console bucket! This is for a building that is 30m in height, and in my opinion 44 panels with...
  14. M

    "new granny flat"

    Hi All I have been asked to look into putting in a CU in a garage that is likely to be converted into a granny flat in the near future. Planning on using 10mm or 16mm SWA cable (buried to 600mm) as no real idea what load is going to be if it is converted so want to take worst case into...
  15. J

    Rented Flat - Oven tripping, Live cables with RCD OFF!

    This is my first post, So i must say hello to all the members! :) Right i have a few questions, This is my first flat i have rented so i am un sure of the rules ect... My oven trips out when it gets hot, Its very old oven its a delonghi eoc360-1g It bypasses the pole switch (oven switch)...
  16. B

    RCD Protection of tails to flat

    1st floor flat on PME supply. Service head on lower floor below G/F flat. Tails to 1/F flat some 10m away protected by switched fuse after meter. Cant see run of tails but 99.99% sure they are buried in the wall as no conduit/trunking evident and they also go through the communal staircase area...
  17. S

    Flat consumer unit change.

    Changing a consumer unit at a flat but have a few questions regarding earthing etc. supply is from 16mm T&E fed from the incoming supply cupboard in a separate building main supply is tn-c-s. Each flat is supplied from a 63amp switch fuse. So earthing to the flat is via the 6mm back to the...
  18. B

    HELP! Water leaking through the light pendants from upstairs flat

    I am a fairly new electrician and recently received a call out from an elderly client who says that on 6 occassions over the last 5 years there have been numerous water leaks transpiring from the flat above hers. She says on at least 3 occassions the water was pouring out from the spotlight...
  19. S

    Flat roof system recommendation

    We are looking for other options for a flat roof install either Landscape or portrait layout. We have used Renusol Consule buckets which are ok but looking for something new/ different. Any suggestions? Thanks
  20. D

    The dangers of under sizing your catinery garage supply from your flat.....!

    Exactly what it says on the tin :) http://www.liveleak.com/view?i=25f_1344496418 .

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top