inverter | Page 6

inverter

Recent contents View information Top users
  1. R

    PV Inverter cutting off array sunny days

    Hi new member here looking for advice. I’m having a nightmare with my installer and Solis and wondering if anyone can come back with any ideas. 5kw solis hybrid inverter, 7kw BYD battery and 6.3KW 20x 315w panels on the roof (two strings). system points SSE at 45 degrees. On very sunny warm days...
  2. S

    Help stopping reverse power flow from inverter

    Hi Everyone, My name is Sid and I am based out of Bengaluru, India. I would like to ask for your help on an issue that I am facing recently. Context: I have a battery inverter connected to the electrical system to help with power outages in the following manner: Mains -> Main...
  3. B

    Solar PV insulation fault ABB aurora inverter.

    Hi guys, I am new to the forum so be nice! I used to install solar PV systems back when the tariffs were still good, and I've never had to go back to one of my old installs because of a fault, so I'm not too clued up with regards to fault finding on PV. A customer has recently called me out to...
  4. robertl

    UK 3 phase inverter welder from Split Phase / Bi Phase supply 480v

    Hello all, I have discussed my power install before as i am sure a lot of you will remember as it is quite different to a normal setup. I have a split phase / Bi Phase system, 2 phases coming into the workshop from a center tapped transformer. 240v phase to neutral and 480 phase to phase. I have...
  5. IKETBeD

    Can't setup generator in close proximity to service panel.

    How many feet can 10-gauge Romex run (inlet box to service panel) and still properly support 30-amp inverter generator? Do I also take into account the 25-ft of 30-amp wire (3-pronged locking) that connects the generator to the inlet box?
  6. S

    Inverter waiting but plenty of voltage so what is missing

    I have 2 arrays on 2 SMA inverters. One is 500v single string and the other is paralleled 2 x 300v strings. I have just lost one of my arrays via SMA 2500. It is lit but no power generation. I replaced with spare Steca which would not work as it needs more PV voltage so I had to swop over the...
  7. J

    Omnik Inverter throwing Relay Check Fail Fault

    Have a fault reading; Relay check fail. Done some research and replaced the x2 check relays with quality components. Still have the same fault sadly. Any thoughts ?
  8. Y

    Off Grid 12v Solar Inverter

    I'm thinking about purchasing a 12v 1000W inverter/solar controller: https://www.photonicuniverse.com/en/catalog/full/372-Iconica-1000W-12V-hybrid-pure-sine-wave-inverter-with-50A-solar-charge-controller-and-20A-mains-battery-charger.html I would like to power a lighting radial circuit with a...
  9. T

    Using an inverter for home backup power

    I’m interested in using a high-capacity inverter as home power backup when the grid goes down. I see that there are high-capacity inverters such as this one: AIMS Power 6000 Watt Pure Sine Inverter Charger 120/240VAC Output, PICOGLF60W24V240VS -...
  10. P

    UK MCBs for Inverter-Supplied System

    My house is off-grid and supplied from an inverter. Max power output of the inverter is about 6kW (25A). Max fault current is 100A. The highest rated Type B MCB that can be tripped by this max fault current is 16A, so I cannot use MCBs with higher ratings than that. I cannot have a circuit with...
  11. S

    UK Sunny Boy Inverter

    I have "grid failure, check fuse, 801" on my sunny boy inverter. I want to switch it all off and switch it back on again but cannot remember in which order I do this. There is a red knob to the left "solo pv system" and a black knob to the right "pv array". Which knob do I turn off first...
  12. G

    Solar PV Inverter

    I am replacing my Solar Inverter which is a Power One PVI 3.6 OUTD, and changing to a solaX X1 3.0T boost or 3.6T Boost. Any advice which to use
  13. edexlab

    Motor VSD problem

    Evening all Had a problem this week which has puzzled me a bit Installed a machine last week which has 2 sides to it both doing the same operation It ran perfectly for 19 hrs and then one side stopped working I was away from the site and the maintenance guy called me so I got him to open the...
  14. Graham Smith

    Solar Diehl AKO Platinum Inverter 4300S Help

    Good evening all - I used to be a member of this forum ages ago, but couldn't work out what my username and old email address was, so decided it was easier to register again. Many years ago, (2012?) at home I had installed a 4kw system - 20 panels with a Diehl AKO Platinum Inverter 4300S. We...
  15. J

    Inverter

    Just a quick one before taking the inverter back. Recently we got an 12v to 230v inverter but started getting a shock off the casing. Tested it and around 80v but sometimes up to 120v. Is there something that can be done or is the inverter faulty
  16. W

    solar edge inverter and feed in tariff meter dont match

    Recently had fitted Solar Edge and notice their monitor gives a reading but the meter used to obtain my feed in tariff gives a lower figure and this is the one I am paid on not the solar edge inverter.So why the difference? this could cost a lot of money over the years.
  17. M

    PSCC from canal boat inverter

    I am soon to be helping a friend with his electrics on his canal boat, he is looking at putting a small consumer unit, with a circuit for sockets and another for lights and upgrades to sockets wiring etc etc All sounds easy enough but I am wondering how to select the correct short circuit...
  18. K

    Grounding a 1500 watt inverter

    I'll cut to the chase - bought a 1500 watt pure sine wave inverter, which has a small screw and a nut coming out of the chassis labeled "ground", and they provide an associated 12 inch wire, ring at one end, that I can of course attach and tighten down to this exterior screw. The other end of...
  19. S

    Inverter blowing fuses?

    My grandfather has solar panels as well as a battery pack for them. I have noticed however that its very common for fuses to blow in his house particularly quick blow fuses much more common than elsewhere also his voltage seems to be 220v which to me seems rather low. Should he be worried and...
  20. R

    Solar Aurora inverter issue

    Newby from Tasmania. After replacing failed Zetter a/c relay following 031, a quick, cheap and simple operation, there is now an intermittent 013 fault indicating Wrong Mode. Sometimes inverter operates for hours without failure sometimes only a few seconds. During the automatic restart...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top