I took this Lucedo 10w bulb out earlier as I wanted another the same, it was bloody hot.
Tested temperature with an eBay IR gun and it’s at 98 degree’s. is this normal?! I don’t have much experience with lighting.
Hi,
I have an LED landing light, which has 9 G9 LED bulbs. The unit has two switches, one upstairs and one downstairs. Ive found that when the upstairs switch is in the closed circuit position, but the light is off due to the downstairs switch being in the open position, there is still a very...
My wife bought some long and short LED fairy string lights for Christmas decorations. We will decorate them on curtains and Christmas trees.
Yesterday, my wife did a DIY handicraft with LED string lights, a baby bottle, and cotton. It is very easy to do. She is very happy to share the steps...
Hi there ?,
Apols in advance if this has been done to death?!!! (I know it has but I can't seem to fathom out a similar set-up having searched through this forum and others).
I have an old wiring system in my house and wanted to fit a new LED light in the downstairs loo. I have attached pics...
I have a hallway led light that’s on 24/7 there is no switch to the light it’s wired in to be permanently on, I assume as a night light. is it safe to be on 24/7.
Am hoping you can help
Following an integral garage conversion, I am after a couple of fire hoods to cover some LED ceiling spotlights.
The lights are in a plaster boarded ceiling which has a garage roof void above (the room is part of an integral garage conversion).
Lights are around 150mm dia...
Hello all,
Hope someone can help please
I have had a batten light installed and the electrician has threaded a 1.5mm twin and earth cable through it to power a second light after it, so basically there is the feed cable and another cable that has been threaded in one end and straight out the...
I want to bypass the touch sensor on this aquarium light on the wrg side so i can connect it to a mechanical timer. Any help appreciated please see attached picture.
I recently purchased a 20 watt led floodlight from b&q to put above my shed door..
Live, neutral and earth all wired up properly to the junction box.
I switch the liget on and everything works fine but when I switch it off the light doesn't not extinguish it just goes dim so obviously it's...
How do i wire those cables into my new led light? Any help is much appreciated. I tried various ways but couldnt get the switch to work. Light was on but could not switch off.
Hi. I have a wall LED lights at home. I can turn it on with one switch at the entrance to the room and turn off with other near the bed. Problem is when both switches are turned off, wall lamp is flashing every 30 seconds.
Connection diagram I attached.
Is it any solution for this situation?
We are steadily replacing old incadescent, CFL and halogen bulbs in our house with LED bulbs. They tend to be the 2700k for the warm colour. We tried the daylight colour ones but they were too bright.
From my standard grade physics I know that LEDs are low powered devices that need direct...
Hi Guys,
My knowledge limited to just connecting a led light to a driver, but not with a dimmer, can anyone advise how to wiring these 3 items all together please?
Thanks
Leo
good evening ladies and gentlemen
Just a quick question, my aunt has asked
Me since she’s having her kitchen redone can I fit LED lights under her cabinets,
It’s not somthing I have done before Or even seen done so I was just wondering if it’s a tricky job.
I was thinking I could do the job...
Guys,
Just a quick one. I'm putting an LED half lantern outside on my new extension. At present I have just come off a 2 gang light switch along with the extension inside light. The 1.5mm twin and earth goes straight into the back of the outside half lantern with no wiring exposed externally. Is...
Hi new on here I am an adult apprentice fitted 2 new led fittings in an old house connected them up and at first switched on and off ok but my cousin called me telling me they aren’t switching on any more.
I have went back and checked they are just constantly dim.
It is not dimmer switches...
I've recently upgraded some light fittings that are probably 15-20 years old in an industrial unit to LED fittings
150W Low bay LED's internally
80w LED light fittings with separate photo-cells on external lighting column opposite warehouse.
Is there a requirement to issue a MWC
Hi all
I wondered what people's opinions are on the Electrek LED light bulbs available from Poundland for the bargain price of... you guessed it... £1!!! (On closer inspection it would look like they are actually made by/for Poundland too.)
I have had a couple of them for probably the best...
Hi all and good evening,
wonder if anyone out there can help. im looking to bypass this PIR (please see attached photo) unit which goes to an LED external light, so we can just operate the light with the switch.
What wiring configuration would I need, would it be ok to simply connect the live...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc