led lights | Page 5

led lights

Recent contents View information Top users
  1. G

    Powering LED lights.

    Evening. Been asked to replace some old halogen under cabinet lights for their LED equivalent. The power supply is boxed in and not at all accessible, so was going to use this to power the new fittings, but am I right in thinking a standard 12v psu might upset the LED's... All the ones I've...
  2. R

    Led lights = less electricians

    Was speaking to a manufacturer of LED lights ( though like everything else made in Far East ) who told me the next step in LED lights is a modular system Apparently a 2 core cable is run round a building back to a central point and lights can be added ,taken out ,moved etc without physical...
  3. 1

    Led lights what wire to use?

    I've got led lighting cable and a Led driver just want to know what electrical wire do I need to use? Sorry sounds vague but not an electrican. Thanks in advance Paul
  4. M

    TX65 led lights from Glamox

    Hello! Anyone have experience(or problems) with this kind of LED lights:TX65401200 - Glamox AquaSignal In the brochure its written that is the IC driver technology and manufacturer claims no inrush(low inrush is critical for my use). Is this thrust worthy? It sounds to good if you ask me... I...
  5. P

    Led lights / light switch

    Hi, I've fitted four 3w led spots to my bedroom. My touch sensitive light switches only work with a minimum of 40w load. Any ideas please? ps... Don't say add another 10 spots. :)
  6. S

    LED Lights and dimmer.

    Guys, looking for some help here. I done some work for a customer installing 11x 8.5W ip rated dimmable downlights with a dimmer switch for his toilet. Anyways, I had to go back yesterday to finish up work for another part of the house. when getting there, the guy tells me that the tiler says...
  7. R

    led lights dim and flickering

    Hi, I recently replaced the three halogen bulbs in bathroom downlighters with LED bulbs and one worked fine other 2 dim and flickering. I was told by a friend that I needed to change the original transformers for LED Drivers so decided to replace one of them first to see if he was right- I have...
  8. V

    Flashing LED lights

    Hi, I have an installation using JCC6 Led none dimmable down lights, about 150 fittings installed , on initial switch on about 10 started flashing on & off, after a period of time ( 3 to 60 minuets) some settled down & remained on but a few continued flashing , These were replaced & worked...
  9. D

    Led lights on same circuit as florescent??? Problem occurred!

    Hey guys I'm having a problem, when connected the led lights on same circuit the florescent lights don't work or barely start up. Constantly flicker Why and how can I prevent this please.
  10. J

    LED Lights without drivers

    Hi I am looking to engage an electrician to install 10 LED lights around an outside pool and I know, from the research that I've done, that I have to have a driver in the pool plant room. I am trying to choose the fittings beforehand, however nearly all the LED lights on sale come with drivers...
  11. cliffed

    Led lights

    Having a bit of a nightmare ,loads of led light fittings to be connected,on 1st fix used 1.5mm as spec,problem being is how to join this to the fittings,it's ok where a void is present,but with 2 x 1.5mm at fitting major problems,the designer put the problem back to us,he now suggested it would...
  12. P

    led lights in bathroom help please

    hello please can you advise me i have bought led lights to install under my bathroom cupboards could you answer a few questions for me please 1.converters should i put them inside cupboard or leave on top ? 2. use a pull cord switch to operate lights ? 3 should i put the converter in a...
  13. J

    LED lights blowing?

    I have wired 9 LED lights in a utility room. I wired a 1.5mm cable from the CCU to the 1G switch and then took another 1.5mm from the switch in a radial formation to each of the 9 lights ending with just one cable at the 9th light. I wired these in a week before the builders put the ceiling...
  14. C

    intermittent tripping on 2 new circuits with led lights

    hiya, got 2 new circuit which all have led gu10's on them, led strip etc. on a 6amp b mcb, seems to be tripping the mcb intermittently, not the rcd. Most of them are controlled by dimmers, just wondering if they got a high start up current. Would it be worth sticking on a type c? Anyone had any...
  15. M

    Inductive coupled LED lights

    Hi, question from a new member here. I am installing a wet room and something I like the idea of is having a set of low level LED lights close the the bottom of wetroom area (Think plinth lights or similar). However as this is a wet room and will be fully tanked I don't want to be using...
  16. L

    Led lights problems conrolling via photo cell

    Hi just enquiring if anyone has had problems with photo cells controlling led lights.On a recent job i connected two 30w led floods and an over sign led strip to switch via a photo cell,when first powered up lights came on i assumed this was just the photo cell kicking in on initial power up,but...
  17. G

    led lights on standard 12v transformers

    any opinions ???
  18. J

    LED Lights in SERIES

    Hi, On a job today the client had some LED lights that aren't working. LED transformer is OK and 12v is at the lights. The lights are wired in series (as it says they should be on the fitting themself) and are wired in the following way - Twin and earth from transformer - Brown to Light 1...
  19. N

    LED lights in a bedroom - Any advice/recommendations?

    We're having our bedroom refitted and the designer suggested we put in (six) LED downlights on a dimmer. Now I've little experience of them so wonder if anyone here has any advise or opinions on them? The model the designer recommended are Aurora Sola - 110-240V LED Aluminium IP65 Fixed 9W...
  20. D

    12v Led Lights

    Hi, I have been given some 12V Led lights, the only wiring coming off them is a red wire and a black wire. What is the best way to make these led lights work off house mains? Do I need to buy a convertor?

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top