Hello everyone!
I'm looking for some guidance regarding installing some stairs lighting. I have quite limited knowledge regarding all stuff electrical, so please forgive my ignorance.
I just moved into a new house and I want to add LED strips under the nosing of each step. The way I have the...
Im after some LED strip lighting for a garden project but I'm getting lost in a sea LED strip lights everywhere, prices seem to range from a few hundred to over £1000 for the kit i require, can anyone recommend a reputable seller?
Thanks
Good evening all,
I have a job to do fitting multiple sections of dimmable LED strip to be controlled by a DALI lighting system.
Can anyone recommend LED drivers and strip that are DALI compatible?
I would be grateful for any guidance/assistance.
Thank you
Hi, new member here seeking a bit of advice.
I want to run 4 x 5 meter addressable RGB LED stips around my living room skirting to form a continuous 20 meter strip -don't judge me lol. The LEDS will be controlled by a NodeMCU flashed with WLED and powered by a 5V 12A 60W psu. All 4 strips will...
Hi, can anyone recommend the best but not so expensive LED Strip light kit and where is best to purchase from please. Installation environment is in a kitchen on the edge of a plinth (straight run), the next is to cover two cupboards that are separate from each other but has no pelmet. Would...
Hi!
I’ve installed an rgb strip light to a friends house with a dropped ceiling and I did expect some voltage drop but not as bad as it is, the problem I have is
1. I have ran 2X 2 core 0.75mm2 cable from the carcass unit where all the sockets and less driver is in, into the wall and comes up...
Hi all
Need advice on my current LED light setup with Sonoff switch. Can I check if the Sonoff switch should be connected as highlighted in the picture? TIA.
Hi all I’m new here.
I’ve just installed 25m of ip68 led strip lights round my garden. 8w per meter. They came on just a plug top. Installed it all then plugged in brilliant. Just what we wanted. Now I’ve cut the plug off and gone through a photocell. But now when they come on at dusk they...
A client asked me to fit some LED strip lights, 1m long, easy enough, they bought them, probably on Amazon, 3 pin plug with 6 inches of wire and then a very small plastic enclosure about the size of a switch, then another 6 inches of wire directly into the strip lighting. I needed to extend the...
I have installed LED strip lighting behind some landscape panels. There are 7 panels each panel having 2 x 1200mm 2538 LED light strips. I have two power feed lines - one powering the furthest 3 panels, one powering the closest 4 panels to the power source. The power source is a 22amp 320 watt...
Hi guys
Doing my kitchen and want to put the led strips under the cabinets and also the kick boards. Any recommendations for any? The one for the kick boards would need to fit round a u shape so would ideally be flexible to bend round.
Cheers guys
Hi all, probably being really thick so apologies if I am!
Just wondered why led strip comes with such a thin supply cable?
For eg 10m x 9.6w = 96w \ 12v = 8 A.
So ideally not accounting for volt drop etc a minimum of 1.0mm csa needed.
Why does most led strip come with a supply cable of maximum...
Ultimately for my project im making a lamp which will be powered by the weight of an object. So i want to power the whole led strip lighting solely through placing an object on the weight sensor pad. If anyone knows where i could buy a setup like this or how i could go about making it myself...
Hi
New to LEDs, curious to how you’d go about getting LEDs on a strip to flash one after the other.
Small strip, 3-5 LEDs.
Ideally with a minimal amount of components. (Ive got a small area to work with)
Thanks
Hello forum. I am new here and seeking some expert advice.
I am trying to make some DIY led light strips that will be controlled via DMX.
The lights are these: 20/30/100 LED Battery Micro Rice Wire Copper Fairy String Lights Party white/rgb | eBay -...
I'm looking to install some LED lighting strips to light some display shelving.
It will consist of one driver going to a controller which will then be split into 8 x 1m length strips.
I was wondering if anyone can give me an idea on how to split the power from the controller to each strip i.e...
Hi all,
Hoping for some guidance, which would be much appreciated.
I currently have some Florescent Lights under my kitchen cabinets operated by a light switch and would like to replace with LED strip lighting.
I have purchased some 1 Metre 240V LED strip which is fitted with a 3A UK plug...
hi guys , can anyone advice me how many diode i should use for fitting my led strip in my car. i connected via 3 Key 12V~24V Switch DC 8A RF remote control Dimmer LED Wireless Controller and i want also to connect the power from the door switch but it disable the controller . i know that i can...
Dear all - I am looking to install some LED strip lighting (it will be wall-mounted near the ceiling, behind some uplight coving). The plan is to pull the power from the mains under the floor and chase the cabling into the wall (brick wall, no studs), to then be cemented/plastered/polyfillered)...
hi guys
Went yesterday to have a look at kitchen where the customer wants to change out some fluorescent lighting they have installed to the under cupboard and on top of the cupboards. They want to go down the route of LED strip lighting. I have only ever installed 12v LED strip, but I have...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc