lighting

  1. M

    Bathroom fan: do UK regs require connecting via lighting circuit?

    Hi, I've just had some electrical work completed in the bathroom; I've recently refurbished the bathroom, replacing the old electric shower with a mains/mixer. I had bought an inline fan and a separate humidistat/run-on timer module with the idea that it could be installed using the old...
  2. D

    LED lighting Mains and 12volt DC on same circuit

    Hello I have recently moved home and I looking to upgrade lighting across the house to LED. In the kitchen I have found that there is installed a mains powered lighting circuit which serves five LED lamps (surface mounted and recessed) Included within the same circuit is a junction box into...
  3. M

    24V dc lighting circuit

    I am having a flat roof constructed with solar panels over. As it is a cold, vented flat roof I will be having 175mm of Cellotex insulation immediately above the ceilings which I am reluctant to dig into to fit downlights (which I have never been the world's biggest fan of anyway). My thoughts...
  4. M

    Underwater lighting?

    Whilst having some building work done we discovered a stone lined well under our new kitchen floor , It is 25' deep and hand dug (through shillet) we think in the 1600s. Water level is about 4' down and the water is crystal clear. It is quite an amazing extraordinarily well built thing which...
  5. R

    UK Old lighting cables in new install

    Hi everyone, newly qualified spark here I went to a job earlier today where the fan was not running on after light had been turned off. Whilst sorting this problem I discovered that the bathroom circuits had been installed on a new rcd db but investigating further in the light and the pull...
  6. S

    Need advice removing flickering from AC LED spotlight, if it only has one sine wave available.

    Good afternoon! I've recently wired a lighting system, where one light switch (a motion sensor) turns on two lights, but another motion sensor switch turns on just one. Here is my wiring schematic: (In the schematic, the transformer connects to a 12V LED and the spotlight runs on 230V mains.)...
  7. J

    Lighting spots and outside lighting

    Looking to wire a summerhouse with Downlights and outside lighting but don’t really do much lighting and switching. Any advice on how to wire a lighting radial for the spots and outside lights to a 2 gang switch. Thanks
  8. J

    Rccb protection of lighting circuits

    My 1990 property does not have the lighting circuits protected by the Distribution Board RCCB.Only the power circuits are protected.If I get a trip from the RCCB the lights stay on. Do I need to upgrade my system to include RCCB for lighting?
  9. D

    Emergency lighting HMO compliance

    Hi all Got a question regarding HMO compliance. Visited property today for landlord looking to apply for an HMO license for one of their properties. She hasn't received any detailed stipulations from council on requirements for emergency escape lighting although this will be required as...
  10. S

    EM lighting test facility

    Hi, RCBO appropriate test facility for emergency lighting? I have a car storage facility ( one corridor with 10 rooms off the corridor to store vehicles ). Planning to install the row of lighting all controlled from occupancy sensors, hoping to wire in one run of 3 core to tie in all sensors...
  11. H

    Tennis court lighting

    Good afternoon all, I have been asked to quote for an LED lighting upgrade to 2 x outdoor tennis courts. The existing metal halide lights are mounted on lamp posts, 6 per court. Could someone please advise on an appropriate amount of lumens per LED light and any preferred brands? The tennis...
  12. T

    Maintained emergency light

    Hi all can a Maintained emergency exit bulk head light fed from non lighting circuit if it is correctly fused and test point provided if no local lighting circuit is available ? so it is lit all the time and would be in the case of a power failure
  13. R

    Lighting cable through mdf

    I am making a lamp and I need to run the live, earth and neutral wires through a hole in 25mm mdf. The outer sheath is removed due to a switch. Everything works until the wires go through the mdf. Then the live has no current. The hole is about 6mm diameter. What's happening? Thanks.
  14. Stinger

    Ceiling lighting malfunction

    Hello, I am new to this forum and not an electrician. I am an Electrical Engineer though. I have this kind of a ceiling lighting - https://www.cnmdled.com/data/watermark/20200525/5ecb8360db86c.jpg with two fluorescent tube bulbs, two starters, one capacitor and two EM ballasts of this type -...
  15. timhoward

    Bad emergency lighting install

    Two lighting circuits covering various communal areas on two floors of a HMO. The non-maintained emergency lighting that covers those areas is on a separate circuit (actually with the fire alarm). So either of the lighting breakers could trip and the relevant lighting wouldn't come on. Who...
  16. S

    Most popular outdoor garden lighting?

    Hi all, What is the most popular outdoor wall or spike lights you install? What manufacturers? Typically use Knightsbridge's outdoor range but am interested to see what everyone else is using. Also, what wireless controls do you use when customer asks for this? Thanks in advance
  17. K

    Ceiling rose with 3* single cores

    Hello, I had the floor boards up today and noticed that the ceiling rose for the room below, was wired with 3 singles. Probably the whole house is like this, this is just the first one I've seen. The house is a 1970's house so quite old with regard to the wiring, but I'm really curious what...
  18. LewisM

    Help with outside lighting....

    Hi, I need help to find an outdoor wall/step light. It needs to be surface mount but not wider then 70mm as they're to be mounted on the posts. It's to light up some very dark stairs at night for an old lady who's just had a hand rail built after a fall. I can't seem to find any that aren't...
  19. L

    2 way and intermediate

    Could someone tell me how to go about wiring a 2 way intermediate pull cord switch with fan and isolator? How would this be wired
  20. B

    Should I unclip lighting cables in loft to route over new insulation?

    Hi My 4 bed 2 storey house was extended 2 years ago and completely re-wired, but I am having to upgrade the insulation and board out the loft myself. In the loft the electricians clipped the new 1.0 mm wiring to the joists. There’s no ring, no JBs, it’s LED lighting only and all radial feed. No...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Back
Top