Anyone come across one of these before?
It's in a flat so possible the Landlord may wish to keep out rafter-crawlers, but my customer needs new lights!
There's nothing I can see or feel inside the hole (other than a soft, spongy foam on one side) and I've resisted giving it an almighty pull for...
Just finished a small conversion in the loft and been running an extension lead up to a light.
I'm looking to put a switched light in there and just want to check my thinking is right.
I put a light in the loft running a new wire down to the bedroom switch that is currently a single switch. I...
Hello all,
I had a professional electrician firm look into this when I was having my house re-wired and they said it wasn't possible, but I'm not so sure!
The scenario is - one large extraction fan in the loft and a set of extraction ducting that has a Y piece in it so it can extract from two...
I’m an Industrial electrician and as such have limited knowledge of domestic installations (we all still use the same regs though). I’m wanting to know what people do about the increased insulation in lofts.
For example my shower is a nominal 9.5kW with a 10mm T&E cable If I was to install the...
Hi All
I'm looking to install 2 double sockets in loft to power a cctv system, plug in light (for when im up there...rare) and a network switch.
What's the correct way to install these double sockets?
I've already found the 2.5mm cable thats feeding the upstairs sockets, can i cut this and...
evening guys
for you guys that regularly do rewires....
when you do the upstairs lighting wiring in the loft
do you just use the existing holes in joists- and add a few extra 16mm holes if really needed
who clips? who doesn't? to side of joist if insulation is on top and is also getting...
Evening folks. Just out of interest I wondered what methods you guys are using in lofts / attics to keep your cables out of the mountains of insulation you can find these days?
Are you running your cables under insulation against the plasterboard or are you trying to clip to the roof trusses...
Hi just installed new tails and moved consumer unit, cables are about 7 metres long they run inside a cavity from meter and i have then clipped on top of loft joists , on one bit though there is a heating pipe so i have gone under and clipped to side of joist.... i realise cables have to be 50...
I would like to install an aerial signal booster/splitter in the loft but it requires a 13A socket. There is no power in the loft so is it ok to spur off the lighting circuit (with 3/5A fuse) and then install a single socket up there?
What are peoples opinions on this? or any other suggestions...
I use my loft as a storage area, it is about 20 m long and fairly narrow, and I would like suggestions for some cheap emergency lighting for it please. I was thinking of a non-maintained light that I would connect immediately before the light switches, for the 5 off fluorescents in the loft. I...
Hi all,
I have a few questions regarding the loft conversion I’m doing at the moment:
Is it okay to extend the first floor lighting circuit up into the loft? It’s separate from the downstairs circuit and currently has 5 lamps on it. It would be extended by five, two sets of recessed...
Hi guys, quick question
looking at getting around to installing a loft light at my sisters house and the board is 16th edition lighting on non rcd side. Cables will be clipped to wood work but 1 foot and half roughly will be going between joists to landing light. In this bit it is boarded and I...
Hi all.
Our existing loft has had new insulation put in recently by the look of it, with the insulation covering the existing wiring. Am I breaking any regs or causing a potential hazard by fitting some loft boards for storage?
Thanks guys.
I'm due to start a loft conversion and building regs require smoke alarm, can anyone tell me if I need to install interlinked smokes on every floor ?
cheers
I have recently started fitting new loft insulation and found a cable running between two bedroom lights ceiling roses is damaged and needs replacing, is Prysmian 1.0mm twin and earth ok there are no markings on the original but it does look to be 1.0mm, this is a straightforward job I have done...
Hi All, Ive posted before about this but is now completed need some advice please. we have 6 shotgun cables wired to loft, at minute 3 sky+ boxes are connected. we would like to keep as is but would like to have secondary sky to 3 other positions. I realise now I could have wired from RF out on...
I was asked to move a friend's bedroom light yesterday so went into the loft to inspect the existing circuit and when I lifted up their insulation in search of the cables I found some grey loose bits of insulation, and beneath that was another layer of fairly dirty thin insulation. There is not...
quick question for you guys. If we say the house again is timer frame with plasterboard covering the frame, 2 floors ground & first. When the cables exit your CU in a domestic property and go into the wall cavity, how do they get to your loft. The ring for upstairs prob jumps into the wall...
hi there
I was wondering if someone could help me
i’m trying to supply a light to my loft adding a switch also in the loft to turn the light on.
I have found a cable in the loft that supplies power to the living room lights. the living room has 2 ceiling roses which I am wondering if this is why...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc