Evening,
Carried out EV charger installation survey today & found this meter. Is that a 16mm concentric type cable adapter between cutout & meter?
This is a TT installation, tails unprotected. Not sure about installation method of DNO supply.
I'd like to upgrade tails to 25mm between cutout &...
I have a few questions on a service upgrade project.
I am working on a ~100 yr old tri-plex in washington state.
The existing panels (3) have "edison" type screw in fuses. Two of the panels are co-located and the third remote panel and meter are at the other end of the building.
I plan to...
Hi guys,
I am going to a job Sunday and trying to gather as much info as possible before attending.
I believe I am looking at an elster a1140 export meter with an issue.
Solar PV on a gym, generation meter all reading fine (metered board for the inverters)...
The issue is with the export...
Hi everyone, i might be having to run new meter tails from meter box to consumer unit which is just under 3m run, i have used 25mm 3 core before and its hard to work with especially through joists. I was thinking about 2 core 25mm swa and a seperate 16mm earth to make life easier but then came...
I recently borrowed one of these to diagnose an earth leakage problem, and it was very useful: 560 60A Digital Earth Leakage Clamp Meter - https://www.cef.co.uk/catalogue/products/4131796-60a-earth-leakage-clamp-meter
Before I go out and buy one for us, I wondered if anybody can recommend...
Hi all
I have a customer who wants a smart meter .. they are with edf ..
The existing meters ...1 day rate , 1 off peak ..plus mechanical time switch are placed in the customers porch behind a panel rather than in a meter box ,.. circa 1965 I guess.
In order to upgrade the consumer unit we need...
Hi
We are looking to get an EV charger installed, and I asked for an SPD to be on the new CU that will be required for that.
The electrician has suggested that instead of having an SPD in the new CU, could replace the incoming isolator in the meter cupboard with one that has an SPD incorporated...
Hi,
Just had a new Smart Meter fitted yesterday along with isolator.
The chaps installing the SMART meter used 16mm tails from the main DNO fuse cut out (containing 80 amp fuse) to the meter, but then used 25mm tails from the meter to the newly installed isolator (which they also installed). I...
New to the forum. Hopefully somebody can give me some advice on finding a very specific meter box for my house. A few weeks ago our house was vandalized and the vandals ripped our power meter out of the socket, breaking the meter box door in the process. The house was built in the 70s and as far...
I had an eicr done recently, the electrician gave a C2 for the meter tails having their outer insulation stripped back too far.
Can I take a piece of the grey insulation off a spare tail and cut and glue it onto the missing piece to clear the C2? Much easier than having to strip back as it's...
Hello,
I created this account as I have ran into a huge issue with my electric bill. I have been living at my house for 1 year right now. Every 2 months I have been paying anywhere between $60-$80 for my bill. I opened my bill today and it has jumped for $650 for this cycle. After calling...
Good evening
Have to quote on a consumer unit replacement, problem is gas meter is next to existing consumer unit 25 mm between them, they are both in a wooden cupboard,
What would you do
I recently switched from economy 7 to a single rate smart meter. I have two fuse boards and wondered should these now be on 24hours a day and should they be charged at the same rate?
I got my bill through and it looks like they are charging us at different rates, both of which are higher than...
Hi
Has anyone seen this type of electric meter? It has the normal dial (on the left) and it has a card meter added. The card meter, I think can only read £1 cards.
At the moment, it will not accept any new cards. Apparently you are supposed to insert the card, when the red light goes green you...
Has anyone installed a Walbox EV Charger with a Power Meter to enable the Power Boost option? It's installed but there doesn't seem to be any way of confirming that the Wallbox is talking to the Power Meter. I spoke to Wallbox and they couldn't help.
Hi Guys, 4 Bed house I am going to rewire have two electricity meters. Customer want to install seprate consumer unit for upstairs on one meter and downstairs on the other one. Incoming supply is single phase with seprate cut out for each one.
my question is wheather it is allowed or not as I...
Hi looking for a bit of advice about an issue I have with some work arranged by a social landlord. The landlord had to fit a new consumer unit but sent out a contractor to fit an isolator switch the week before. He also renewed all the wiring from the mains fuse and the meter tails. When the new...
Following on from my ‘Fitting a Power Meter to a CU Part 1’ question here is Part 2.
My home installation includes a Lutron Homeworks system that is supplied by a dedicated CU image here - PXL_20211105_203655704.jpg - https://1drv.ms/u/s!AkQ39xZI1R4EkuBYCGWrqhjWgNTZlQ?e=W89acf
The power meter...
So that I can understand how the electrical energy that I consume is being used I want to fit one of these to my consumer unit (CU) - https://www.amazon.co.uk/EMPORIA-ENERGY-Emporia-Electricity-Metering/dp/B08G37ML2R/ref=psdc_1938287031_t1_B00G5DZK8I?th=1 The power meter appears to be primarily...
I'm adding a 30 amp RV outlet to the exterior of my house.
The location I'd like to put the outlet happens to be near the gas main/meter.
Are there any safety or code issues putting an outlet near the gas meter?
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc