Hi I am looking for an Electricians mate to work on new build house in the Loughton area of London.
Start Monday, 4 days work with the possibility of further work too. Please PM me for more details.
Thanks.
Hi Guys, Are there any regs relating to installing downlight light fittings in a new build house? Do the light fittings have to be fire rated throughout the installation? Do any electrical accessories installed within partition stud walls have to be modified to comply with any fire regs? thanks
Hi Guys,
I'm going to wire a completely new build house soon and I've been out of game for many years.The house has those Z joist which have timber top and bottom and hollow between, using metal Z frames for strength.
My question is for those of you that come across this a lot is, When...
Hi all,
I was just wondering if anyone had any tips or advice for wiring new build. I've been working on social housing occupied rewires and normal domestic but going for an interview for newbuilds. I'm thinking its got to be easier then occupied, but jus gota watch out for the other trades...
Hi all,
Hoping someone can advise. Firstly, I am armed with a few certificates (2393 Part P, 23820-12 and 2392), however have very little in the way of experience.
I'm about to start a new build - my first - and have a qualified & experienced electrician who is going to wire the place up for...
I have a new build flat in Wallington Greater London (Surrey), this is a duplex arrangement with 2 beds and 2 en-suites upstairs. One bathroom has an outside wall with a little window, whereas the other has no window or outside wall.
I'm sure there must be regulations in relation to...
Hi guys been more of an observer than a poster but need some answers if anyone can help so here it is.
i have picked up some work on a couple of new builds that were started before the recession the original sparks have went bust so im told any way i have been asked to finish the job but there...
Hi,
I purchased a new build flat in Greater London, it's a duplex, the Consumer Unit is fitted in a cupboard under the stairs, however I have a massive boiler right up against it. So close to the Consumer Unit I can't even see all the labels located on the Consumer Unit, not sure how I would...
Hi All! A newb here from Notts. I'm not a spark but a serial self-builder and have done a lot of (what I call) average knowledge work. Where I always fall down is with stuff like below. I do anything and everything I can but my spark's let me down and I need two things: 1) Some quick advice on...
Hello forum sparks. I'm running a cooker, ring and lighting circuit in a new extension but would like to know how you guys do it. The cables can come in at any level and run from floor up or roof down.....but for sockets above work top what's the best route, would any of you run horizontally to...
I was working with a contractor as part of my Electrical Trainee course and we were wiring a new build.
I noticed that the time served and apprentice trained sparky was telling me to run the cables through and around rsj's and into un-accesable places. I mentioned to him that if he would have to come back to...
Hello there
Currently first fixing a small annix building basically customer is having this annix built in the garden and is requiring 2 BT telephone points and would like to be able to use internet broadband from both points.
My question is do I run a telephone cable from existing house to new...
Hello everybody
Sorry if wrong section been a while since i last posted.
Basically i would like opinions on heating systems. Its a new build annex with 2 rooms and a bathroom I'm running a supply from the house. I don't have much experience with electric heating systems i was wondering what you...
been asked by architect if the smoke alarm cable has to be fire rated ??
first thoughts is no t&e cable is all it needs but is there any special requirements
its a 196 sq ft house 1 ground and 1st floor
Hi all,
Just been asked to install a new system on a new build to satisfy building control.
I done my 2399 about 6months ago but am not yet mcs as looking for a job to do and then use for my assessment.
My question is am I allowed to do this job then use it for my assessment??
The client...
Hello, What is the correct way of running the cable for an outside light as per regulations and good practice?
I have a timber frame building with a 50mm cavity and outer leaf brick work. Is it okay to run the cable from the loft, down the cavity and through a hole in the brick work? or could...
Hi haven't done new build for a while last time I done one it was 25 % low energy and fitting could only use low energy lamps, I know it's 75 % and I think you can use normal fitting as long as a low energy lamp is fitted
My questions is if I fit a gu10 downlights what led lamp can be used I...
Hi all
Been asked to help fill in the form required to get a new supply to a 3 detached new build I was going to ask for a 100 amp supply but they also ask for a kva figure
How do I go about working this figure out
Thanks in advance
Hi everyone wondering if anyone can give me any advice, I have a final interview this week for an electrical apprenticeship and have been offered to work as a mate on telecom electrical installations ac/dc exchange systems working with DC electricity at 50V, inverters and rectifiers among three...
Hi
I am attending a meeting soon to discuss the requirements for a rebuild (burnt down) of a 3 bed, 2 storey thatched cottage. A person from the bank will be there aswell to discuss money, along with the architect and builder. As this is new to me does anyone have any advice on conduct and...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc