pir

  1. J

    Bathroom Mirror with fluorescent tubes turning off at random times

    Hi, I have a bathroom mirror fitted in 2013 with 2 fluorescent tubes and a pir sensor to operate. Its been working without any issues until a couple of days ago. Now when I turn the light on by passing a hand under the sensor the light will then go off after anything from a minute to 10...
    • jazzlover
    • Thread
    • bathroom fluorescent mirror pir random times tubes turning
    • Replies: 5
    • Forum: Lighting Forum
  2. V

    Contactor for outside lights on a PIR - Opinion requested

    Hi I wondered what opinions would be on the following. I have installed 2 20W LED floodlights which will be controlled by a PIR and a 3 position switch to override the function of the PIR. The manual of the PIR seems to imply that if it used to control more than one light it should be via a...
  3. R

    Wiring up a PIR sensor to led light

    For years I have had a PIR sensor wired to some down lighters in my porch and the sensor has stopped working as the lights are now on permanently. I’ve bought a new pir sensor but am not sure how to wire it up. The first two pictures show the current worn out sensor and the third photo is the...
  4. driverman

    Pir

    Hi Guys, I’ve not been on here for a while and I’m getting out of touch with modern products. I’d like to fit a stand alone PIR to switch on an existing halogen (100 watt) light fitting and an existing bulkhead light fitting (100 watt tungsten). I’d like to fit an additional LED (20 watts)...
  5. N

    pir sensor in false ceiling

    I know fire rated downlights are installed in false or suspended ceilings as the normal as the cost difference is small... But what about PIR sensor in a false ceiling or a suspended grid ceiling wouldn't they need to be fire rated if it was a fire rated ceiling?
  6. mattg4321

    Maintained EM Lights on PIR

    Got some emergency lighting to fit this week. Spec is vague. Normally the key switch would be switching only the feed to the EM battery pack - not the whole circuit as I’ve seen some do. However the lights are all controlled by PIR. Does this have any impact? Can imagine they will be hard to...
  7. LewisM

    Recommendations for a ceiling mounted PiR Sensor

    Hi, I need to install a ceiling mounted pir sensor however the ones I have previously fitted look cheap and obtrusive, is there any that you guys have fitted that are small and not so crappy looking? Fyi unfortunately I can not fit a recessed one
  8. S

    Pir led flood with overide core

    Hi all, I need a decent quality PIR LED flood. Both JCC and KSR have the stupid double flick of the switch method for overide. I need one that has the good old fashioned perm live input aswell as switched! Any brands that 100% have this capability? Only needs be approx 20watt cool white pref
    • suffolkspark
    • Thread
    • flood led pir
    • Replies: 3
    • Forum: Lighting Forum
  9. F

    Driveway Leds - better with Parallel PIR or wireless?

    Hey All, I have 11 low voltage outside led lights in a line on the driveway , I want to PIR them at the bottom to trigger when I come home and a PIR at the back door to trigger them when I leave the house. I believe if set with enough time delay then this will allow me to come home , trigger...
  10. C

    Weird PIR wiring

    Does this sound like a normal way of wiring a PIR. So had to change a PIR for a pullcord today and this caught me out. Just wonder what others thoughts are. I could not get to any of the wiring above at all. I had two Twin and earth cables coming to PIR. 1st cable was power in no problem...
  11. Mark Wright

    B&Q Pir light had it, less than a year - please recommend new pir

    I installed a B&Q pir light under a year ago and it's flickering the LEDs have had it, it's totally contained and the LEDs are hard wired, pretty peveed, can anyone recommend a good outdoor pir light, one that comes with a rubber flex is preferred Don't know what I.P rating and was probably...
  12. S

    PIR wiring

    Hi guys when adding Pir to a lighting circuit would this be the correct way of wiring so at the light I have 3 core and earth. Black as switch line sleeved brown connected to the permanent feed of the light with the neutral and earth and the brown in a wago. And at the pir have brown as...
  13. E

    Failed security light PIR

    I have a set of security lights round the house, all supplied directly from the consumer unit although the circuit was modified recently to allow one to have its own on/off switch added. The led light on this switched unit has failed and was replaced by another, and on switching the circuit on...
  14. M

    Dimmer and PIR controlled lights.

    Hi all, I hope everyone is well! I currently have 5 downlights in my soffits controlled by a dimmer switch and a PIR security light on a timer switch and the PIR also feeds a small light beside the front door, I’m wondering if I could use the SL from the PIR to turn on the down lights as well...
  15. S

    PIR sensor not switching lights on

    Hi sparks I am trying to fit a PIR sensor to a downstairs bathroom, replacing the existing pull cord As per the instructions I have wired the sensor. When switching the trip back on, the led bathroom lights (4 in total) illuminate, but are dimly lit (by about 50%). Leaving in this state, does...
  16. D

    I on 16. Pir

    Hi all can anyone please help. Daughter has ion16. Alarm. Battery’s wanted changing. Since I have changed them. Keeps going off alarm panel says fault zone 7 have made sure the spring on the tamper is ok still going off any help please guys if the pir is faulty how do I program new pir...
  17. R

    Led PIR

    Hi. Can solar panels on house roof affect PIR led floodlight on rear outside wall .light switches on but can not perform walk test
  18. W

    Security light with PIR help please

    Hi guys, I am currently in the process of installing a new security light in place of an old one. My security light has 3 wires coming from it. The existing cable that joins to an internal switch has 4 cables. I have wired up to matching colours of wire using Wagos and put in a box...
  19. P

    Linked PIR lights

    A short while ago someone asked about having two PIR lights linked so they both act as one. In my reply to that thread I mentioned something cryptic about having separate switches to enable them and to select the linking action. Well here is a diagram of what I meant, as drawn up for a site...
  20. O

    Connecting 2 pir lights to work together

    Hi, I want to install 2 led pir floodlights directly from consumer unit and for them to work together when either sensor is set off. Can I run a cable to the first light (L,N,E) and then from the first light to the second light the same (L,N,E) and then run another cable from L1 to L1 on either...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Back
Top