please | Page 2

please

  1. P

    I have a Bathroom Extractor Fan Question please

    HI There, I would be grateful if you could help me, I have a very long duct between the bathroom and extractor outlet vent and for sometime, the bathroom stream overwhelms the extractor fan so much that I end up having severe condensation and moisture puddles, because it was a new build. They...
  2. R

    Help with symbol please

    Im doing a design taks in 2365 level 3 and I came across this symbol. Its located in male and female changing room next to socket outlets. Im thinking its a double pole switched fuse, but I cannot confirm, since I cannot find this symbol anywhere on the internet. Can anyone help ? If the symbol...
  3. S

    Testing rig ideas please!

    Hi 👋 I have my 2365 level 3 and currently working on my 18th edition. I work in construction but not electrical (hoping to soon!) I just bought my first tester, the Fluke 1664 and I plan on building a test rig at home so I can practice with it Looking for some ideas for useful things I could...
  4. V

    Electrical advice please. Thank you.

    Hello, I would like electrical advice please. I recently started a new cleaning job. I have been asked to use a Shark Steamer. The floor I am cleaning is huge. Unfortunately the steam is not sufficient enough to clean the big space. The owner has asked me to chuck water on the floor to help the...
  5. V

    Advice on New Consumer Unit Change Please?

    Hi Everyone, Last year arranged for my mother's and my consumer units to be changed by the same electrician who is NICEIC registered. Both jobs were not completed for various reasons, I have been trying to arrange for them to be completed over the last two months. At my home the oven began...
  6. K

    Buying house - EICR Results Help please!

    Hi all, we are purchasing our first home and the sellers had an EICR carried out in April 2023. They have sent us a copy of the report and said that the electrician confirmed to them verbally that there is nothing technically wrong with the house and it is perfectly safe. That most houses of...
  7. banksy

    Connection advice please

    I'm replacing a fluroescent tube with an LED strip light. Photo shows the wires which connected to the old tube light (single one way switch). The new LED light has a short pre wired cable with live and neutral wires only. How do I connect the new LED light to the old wiring, retaining the same...
  8. D

    Advice on Isolator Switches needed please

    Hi, I have received conflicting advice about Main Isolator Switches and would appreciate forum member's help to plan a way ahead. Looking to the future I might need a 7.4kW/32A charging point and the garage isolator is only 60A. 1. Recently, during a kitchen refurb, double pole Mains...
  9. R

    Makita 40v advice please

    Has anyone used Makita 40v tools? I’ve currently got Milwaukee but I’m having some warranty issues and a few battery issues. I’m thinking of giving Makita a try as I’ve never used them and they seems to get okay reviews.
  10. R

    Please tell me i'm not going mental and he's talking gibberish?

    This guy is trying to say that when the fuse is pulled, the supply to the fuse is still live and therefore it's dangerous.
  11. C

    Need A Guide Price For A Project Please

    Guide price guys if possible. Got a client that needs around 15mts 3 core SWA installing via YT4, Cleats (50/50 split), 3L (9mts) 100x50 trunking, 6 DSO in the 100x50 (with inserts), MCB for existing board, New garage board, 2x 4' LED slimline in one room controlled via 2G2W (in 100x50), LED...
  12. Marvo

    OAP Fall Alert Design Assistance Please

    This isn't really an electrical issue as such but I know you guys are pretty tech savvy and familiar with all the latest and greatest newfandangled gadets so I'd like some help coming up with a solution to a problem please. My dad is knocking on in years (90) and he lives alone in a two storey...
  13. caitlin00

    Please advise, Ampy Automation payment meter

    Hi all, not too sure if this is the right place to post, but at a bit of a loss here! i live in a block if flats, and about half an hour ago, heard a pop sound, and then all the electricity went off. I am on the prepayment meter that is shown below, which is handled by a live in caretaker. He...
  14. P

    Please read discussion

    PLEASE tell me Im not mad.!!!!! Within a communal Garage block of 11x units, currently fed through a Communal supply, has taken it on himself to employ a sparky to run an independent SWA up and across his Garage flat roof and several other independently owned flat garage roofs to the the...
  15. H

    302 question help please

    A motor has a synchronous speed of 50rps and runs at 2850rpm when connected to a 230-volt 50Hz supply. Calculate: a) per unit slip b) percentage slip.
  16. S

    UK Refresh my memory please

    I qualified as an electrician using the C&G 2330 route back in 2012... I stayed in my current job which is non electrical so I spent 3.5 years for a peice of paper. A breif description of why i need a little help. I bought a 1930"s house that needs a fair bit of work including a rewire or...
  17. B

    Advice on training please

    Thank you accepting me on this group. Maybe I am a bit late, however I have been looking into becoming a Sparky. I have contacted Access Training and ERR education and I had a chat with ERR about a course for X amount and about 2 years Weekend training with online course and practical at some...
  18. T

    Which wire where please

    Hello sorry photos now attached! Which wire goes where please ? Thanks Tom
  19. Jeffersonelias

    Cns anyone please help with this French Nano LED table lamp?

    I would like to install a plug as the original one has been cut off. It has a black sleeved wire but also a non sleeved cable with no indication whether it is a live. Can you please advise which type of plug I need for this? Many thanks
  20. J

    Help/advice needed please

    Hoping someone maybe able to help. We have a Horstmann electronic 7 that's connected to the water heater element(everything been great for years) until last year,we had no hot water,rang a plumber got a new water heater element got it fitted,been good until January this year,then it stopped...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top