plugs | Page 4

plugs

Recent contents View information Top users
  1. S

    SMA Power plugs

    Contractor has lost the power plugs off SMA2500HF. I think they are Cloverleaf shaped so maybe a C6 to C13 adapter would work to then use standard IEC leads off the shelf. Anyone know the type of plug into the inverters for sure?
  2. T

    Solid raw plugs

    Hello guys, I'm fed up with trying to clip to the wall and the nails just bending or the bricks blowing e.t.c. I was wondering if anyone knew where I could buy solid raw plugs that I could hammer a nail into, like a plastic dowel, but cut into pieces say the size of a raw plug. Cheers Guys Tom
  3. M

    Q on wall mounted generator plugs (240v)

    its just I have a job and the gaffer ordered 240v 32A wall mounted plugs to go on the side of site cabins to power up the cabins but 1 of them have 2* 7.5kw showers + 2Kw water heater as i am only agency i am not wanting rock the boat, i was just wondering if the socket would melt or what What...
  4. W

    Advise on 16A Plugs & sockets

    Hi guys I have a question what size conductor can you fit in a 16A 2P+E 230V socket/coupler/socket? Thanks
  5. D

    High current CEE form plugs/sockets.

    Hi chaps, Can someone enlighten me as to what the fourth pin is for in a single phase CEE-form plug? I've noticed that some 63A+ plugs have them and some don't... Don't know why I've never wondered about this before... Was just faffing with some the other day and it got the grey matter working!
  6. D

    Three phase tap off plugs

    Hi all Any body know a good supplier that sells the three phase tap off ( plug in ) units ? such as :- KSE 02CG5 AND KSA 02CG5 ?
  7. linuxthefish

    GRR, rewirable plugs...

    How come those stupid re-wirable plugs are SO hard to rewire? The wires are never the right length, and one always never fits or the strangs come untwisted... What tricks do you have for using re-wirable plugs, or making them easier to rewire?
  8. B

    Brown plugs on rewires

    A housing rewire specification says you have to use brown plugs and 5mm screws, would you comply ? would it make you think anything about the rest of the specification document ?
  9. Lucien Nunes

    Hello from London

    Hi all I'm Lucien, based in North London, where I spend way too much time tied up by two main interests in electrical stuff. One is part of the day job, where the electrical work is mainly theatre lighting and other entertainment related projects ranging from cinema projectors to organ...
  10. S

    FOR SALE: Load of Hager Klik plugs. 3-Pin & Red 4-Pin.

    Hi guys, I have a load of Hager Klik Plugs for sale, both standard 3-Pin and 4-Pin plugs. I have them listed with Best Offer option, the greater the bulk buy the lower the best offer I shall accept. Based in Southampton but can ship nationwide. 3-Pins: 10 x HAGER KLIK LIGHTING PLUG IN, 3 PIN...
  11. A

    IEC C13 sockets on a UK faceplates?

    Does anyone know if anyone sells 1 or 2-gang faceplates fitted with IEC C13 socket outlets? These are the unshuttered 3 pin outlets found on many electronic equipment items, with a rating of 6 or 10 amps. I ask because I have put four 1.5 kVA UPS units in the cellar of my house where it is...
  12. E

    Portable Appliances Fitted With IEC 60309 "Commando Plugs"

    Afternoon all, I require some wisdom from the fountain of knowledge that is electricians forums. Last week I was carrying out portable appliance testing in an a factory that I carry out alot of work in, The factory floor has been wired with IEC 60309 sockets throughout, all fine so far...
  13. S

    Plugs

    Can anyone explain why some people refer to a British 13 amp plug as a 'plug-top'? Where does the 'top' bit come in? I call them a 13 amp plug, or if being unambiguous or pedantic a BS1363 plug.
  14. C

    Help! Plugs downstairs stopped working - What should I switch?

    Hi all, I just plugged in a (apparantly faulty) steamer, and all my plugs went off, but when I went to check out the consumer unit, everything was switched to "on" including both that are labelled "plugs down" and "plugs up"...... except this dial on the left which says "RCD connected circuits"...
  15. sawdust

    5 & 15A Unfused Lighting Plugs

    Hello, I was asked to clean up some stage lighting, and was wondering if anyone knew of any relevant regulations for stage lighting that I should be aware of? Was quite interested to find that none of the plugs had fuses in them (being of the 5 and 15A round pin type). While I can appreciate...
  16. S

    opinion on this wiring job

    Ok... ive recently completed 2330, so im no time served. However see the photo and give me your views, is this as incredibly dangerous and dodgy as I think... I rent a house, my landlord is an electrician, supposedly JIB. I went to test the element in my oven and couldnt find the isolator...
  17. E

    Which plugs to use?

    I'm seeking advice on suitable masonry plugs. I'm currently using 5mm Hilti plugs, literally by the thousand, in a University student accommodation reno. for direct ceiling fix cable tray, ductwork, conduit, and surface mounting. 5mm seems the best to use, as it can be both drilled and pushed...
  18. D

    Where might I source these sockets and plugs?

    I can find them on cpc: 4795.0000. - SCHURTER - REWIREABLE 16A, FREE SOCKET | CPC But I'd like to have other options available. I'm looking for what cpc call 'chassis in', male and female, ie plug and socket, and also for power supply leads in a rewireable plug and rewireable socket. This...
  19. tank

    commando plugs

    hello all , i still learning and need some advice about industrial plugs. i need about 5.5 kw of power from some bs1363 sockets mounted on a mobile contraption which would be wheeled to near to a consumer unit for connection. i'm thinking a 32 amp circuit breaker feeding a 32 amp single...
  20. S

    Phase 3 timer switches....

    Is it possible to get timer switches which can turn 415v phase 3 equipment off/on automatically during certain periods of the day - ie lunch/breaks. I know you can get domestic timer plugs which you plug straight into the socket and the equipment then plugs into this. I would imagine with 415v...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top