rating | Page 4

rating

Recent contents View information Top users
  1. J

    UK Switch

    I have a switch that is with a rating voltage of AC 250V/ 1A – can I use this to turn a standard desk light that is plugged in to the mains??
  2. Baddegg

    Ka rating

    Anyone point me the right direction for the ka rating of bs 88 class Q...
  3. S

    Which fuse rating to between starter and leisure battery?

    What fuse rating do I need to put in between the starter and leisure battery? I have a 12V 75AH Starter battery and 110Ah leisure battery. Cable size 16mm or 8mm. (this is for my off the grid van :) )
  4. A

    IP rating of Nylon cable gland

    Hi guys New to this forum and thought I’d ask the powers to be on here for some advice. Basically I’m on a job installing some electrical instruments. The instruments are quite small and have come with the gland body , lock nut and ip washer on the outside . The reason for this is to reduce...
  5. B

    Rating of CU main switch

    Hi all, I noticed on my consumer unit that the main switch is rated for 100Amps, however the total load of all the MCBs is over 150Amps! I appreciate that diversity COULD (?) be applied in that not every circuit would be simultaneously running at full capacity, but is the installation...
  6. Gary Tollison

    Kitchen ceiling lights fire rating

    greetings :) Was curious about the ceiling lights in the kitchen if they were fire rated or not. Google was no help with model info. There’s an F in a triangle symbol on the side, but I don’t know if that means anything. Any ideas? Thanks, Gary
  7. D

    Tagging a post for a rating.

    As most of the tags/ratings you can add to the post are positive we don't need to reflect on them but with regards to the negative ones, specifically the 'Dumb' and 'Disagree' options, can we ask you add a follow up post to express your opinion and why you are in an opposing stance. What we...
  8. E

    UPS voltage Rating Specs

    Hi Guys, In IT UPS back up systems is there a general upper voltage rating before the device will compensate for overvoltage or is it down to each manufacturers spec. Have been experiencing reports claiming they have been alerted of overvoltages. This I will need to check out. Many Thanks!
  9. C

    Switch gear / Panel board Rating

    The Incoming breaker model is Terasaki - S250-PE, 250 Ampere Frame rated for which Ics is 70kA, Category A breaker The outgoing breakers model is Terasaki - H125 NJ, 125 Ampere Frame rated for which Ics is 85kA,Category A breakers The bus bar rating is 65kA for 1s. How should this panel board...
  10. HappyHippyDad

    What power rating would this garage door be?

    I have a roller garage door that my friend has fitted which i've noticed is connected to a socket to give it power, but then has a flood light attached to the control panel which is also connected to the lighting circuit. In other words you need to isolate sockets and lights to make sure the...
  11. spud1

    RCD RATING VS. SERVICE FUSE RATING

    Hi chaps A Wholesaler told me me this week that the RCDs in the new '18th' split load boards have to be rated at 100a because the 100a service fuse is only means of upstream overcurrent protection. But I was once told that service fuses, although marked as 100A on the cutout label are actually...
  12. S

    Christmas lights transformer rating

    Hi I’ve got a set of filament lamp Christmas lights, which I think is quite old. It is a set of 80 lights, and the lamps are rated at 2.4V, 0.29W, 120mA. The transformer is rated 24V(AC), 0.7A, 16.8VA. It had 8 ballast lamps installed, so I assume 1 ballast lamp for a string of 9 normal...
  13. C

    Bus Bar Ampere Rating of MCCs, Sub distribution Panels

    Is it mandatory to have the bus bar rating equal to the Ampere Frame (AF) of the Incoming Breaker (MCCB) in the MCC, sub distribution panels. Is it okay to have the bus bar rating equal to the AT ratings?
  14. B

    MCB rating advice is appreciated.

    Just a quick question got a new boiler going in soon and noticed that the MCB that will be used for the dedicated feed ( on kitchen ring ATM ) is 16amp is this correct rated MCB? or does this need replacing with a 6amp MCB with a 3amp fuse at spurr? Cheers
  15. A

    1250amp underground cable rating

    hi, can someone tell me what size cable is required for underground cabling.. rating needs to achieve 1250amps. Can also use cables in parallel.
  16. B

    what is electricity rating for

    Hello I have seen electricity meter that show rating of 5-30Amp why it is not less than <5Amp
  17. Joshua

    Earwig, a new upcoming agency rating website.

    I hope this is in the right forum I thought I would share this, it's a website that's due to be released by the end of the year. It's a Service for agency workers to review agencies and rate how good they are. Hopefully it'll benefit someone in the forums. You can sign up here earwig -...
  18. Marcus Vaughan

    Click Minigrid - concerns of 10 amp rating

    Well - I got pulled by LABC on first fix for planning to put isolators in cupboards for built in kitchen appliances. So grid switches it is then. I now have a 47mm back box chased in with plans to supply inbuilt fan, microwave, hob (it's gas - just for an igniter - apparently), and fridge...
  19. R

    Long method de rating factors

    Having used Amtech for so long I can't remember if the de rating factors are applied to the design current or the tabulated regs current, can anyone give me a refresher example calc, I guess it has to be tabulated if it's a current reducing factor
  20. D

    UPS - input rating vs output load

    with a single UPS rated at 8KVA, 230v, stating maximum input current of 44A, would the over current device, cable size etc be based on the 8KVA installed load (the UPS), or, the actual load of 8A, connected to the output of the UPS ? this is a fixed installation, supplying computer based loads...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top