Would you deem a socket (twin or commando) to be exempt from requiring RCD protection if it is fitted above a suspended ceiling installed to supply a specific piece of equipment?
Initially I'm thinking yes. Wouldn't think anyone is going to go out of their way to access them if there are other...
Simple job, swap an MCB to an RCBO on a lighting circuit. It's got me totally stumped!
IR test L+N -> E is fine on the circuit. So is Zs. All 2-way switches operated.
Instant trip when changed to RCBO though, and tried two RCBO's
Ramp tested them both, all good. All tests pass on them with no...
Hi all in a rcbo t Should the white pe cable. he sleeves in green/yellow earth sledging on a domestic consumer unit thanks for your help and stay safe Pete
On a recent EICR i have ring final circuits (sockets) on type C 32 amp rcbo
Some of my ZS reading exceed maximum ZS (0.55 OSG) ie:0.65 ohms .
On a earth fault this will disconnect via the MCB part of the RCBO.
How can i ensure a LINE to Neutral fault will still disconnect?
HI guys,
I have an odd problem. I haven RCBO that did trip, I have found the reason and corrected it. However, when turning the RCBO it stays on, it has power yet it does not seem to provide power to my light. this is for a lighting circuit only, so there are no power points to remove things...
Hello guys, completely forgot to remove the board cover to check what type of rcbo was required for this particular Crabtree board. Anyone from experience know which type RCBO fits?
thanks in advance!!
I'm currently planning for a CU upgrade on the domestic premises, and following previous advice on this forum, I was told that I should consider upgrading to a Type A RCBO CU.
I have been doing a bit of reading and came across some confusing information, stating that an RCD would not work on a...
Morning all,
Does anyone know if there is a replacement part for this discontinued one?
I’ve seen some second hand ones floating about on eBay, but if I can’t find a brand new alternative then I’ll have to change the whole board.
I’ve sent Schneider an email almost a week ago and still haven’t...
I've just installed a new kitchen consumer unit with RCBOs. The client says the oven RCBO is now tripping when it cools down. Any ideas what could be causing this?
a fuse carrier is broken in 6way mem board with no rcd protection , it makes sense to upgrade to rcbos like other boards in the installation..
My question is , I'm nearly certain there is borrowed neutral on the lighting circuits and he won't want a wire fitted from kitchen to landing to...
I came across something new today. When I removed the main earth to do ze the rcbo tripped. Put the earth back in and it's fine. Can anyone explain what is going on?
Hi, first post here!
Just wondering on your thoughts on RCBO neutral fly leads being connected to the bottom of a main switch?
Went to replace a cracked double pole switch for the storage heater, went to give it a quick test and came across this. Dual RCD board with an extra main switch added...
I need to get 30mA RCD protection to a new circuit I am putting on this consumer unit.
I didn't take the cover off so I am not sure if there will be spare ways on the RCD side of it (wish I had checked!). It looks likely that there would be space, does anyone know if the RCD side of this board...
Hello I you are all well
This is hard to explain but basically doing a three phase install and there is no power yet so I wanted to test two lighting circuits before the lifter went, I used an extension lead and connected live to phase L2 (that's what the lights were on) Neutral to the neutral...
I shall be replacing my dual RCD CU, for a all RCBO populated CU. A question or two about technique for IR testing.
For the IR test, I've read here before that a global IR test is preferable. With older types of RCBO's that wasn't possible, without disconnecting cables, which ended up with the...
Hi guys, if 16 RCBO neutrals are tie wrapped together for neatness, are there any thermal considerations such as grouping factors to be taken into account?
Morning everyone, this is my first post - although i had an account years before that seems to have been lost.
Can any of you shed some light onto a situation I've come across.
I have a newly installed RCBO which is failing the x5 test with a reaction greater than 40 mS.
Now, I don't have a...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc