Hi, Is it safe to install junction boxes in damp, high-temperature, or mechanically vulnerable locations for long-term use? What are the best practices to ensure safety?
I am from Chicago, but am currently in Italy. The building I am living in has 4 meters in a wooden box. I noticed my meter has quite a few more wires than the rest, so I took a closer look.
Meter 4 has a blue and black wire, that are spliced into another blue and black, that run into a tube...
Apparently half the downstairs works were on the left of the fuse box and half on the right sparky replace one of the fuses ( allegedly as I wasn’t in ) and decided not to use any of the left switches. everything is now powered from the right switches but he didn’t bother to relabel what’s what...
Hi Guys currently doing my apprenticeship and looking for some external advice regarding safe isolation.
Situation is a circuit supplying some external street bollard lights and 1 or 2 street lamps. This circuit is fed via a single phase MCB then through a contactor all located in the db. The...
I want to put an inline booster pump into the bathroom hot water supply due to low pressure. I need to take a single spur from a double socket into the ceiling cavity where it'll be fixed to a joist approximately five foot away from where the pump will be located. The double socket that the spur...
Good Evening Folks!
I recently started on my house for an Outhouse/Summerhouse 35m away from main Property.
It requires :-
x5 Double Sockets
x2 Strip Lights
The sockets will be used for Televisions and Charging.
I have 2 ways i’d like to to this.
A 6mm SWA from Main CU/32A RCD clipped...
Hi all, trying to work out the best way for proving safe isolation of a motor.
Motor is fed from a contactor inside control panel, it then passes through a local isolator and then to the motor, the isolator has auxillary contacts so that when it is in the off position the contactor will not...
Hi everyone,
I hope you are all well and having a good week.
I would like to ask a question regarding safe isolation in one particular case.
I know we have to lock off/tag off the circuit we are working on, but what if there are two electricians attending the job?
Scenario:
Two qualified...
Hello,
I am renovating my kitchen and looking for advice on best placement of the meter and consumer unit. I am primarily concerned with:
Building regs
Electrical regs
Fire safety
It's just a simple dwelling, not HMO or anything. Currently, the meter and consumer unit is inside of a brick...
Hi am just looking for some expert advice, my little girls room only has 1 double socket, currently have an extension lead with just the camera for her baby monitor plugged in and the other socket has a room thermometer plugged in. We have just got a little clock night light and need to plug...
Hi, after some discussion with electricians, does removing a 16A or 32A socket constitute safe isolation? I understand that removing the socket completes an isolation, but for me, additional measures should be included, either placing a lock around the plug to prevent it from being placed back...
Hi, I was ironing and lost power to the bedroom and bathroom. All outlets and lights. I checked the box and reset breakers still no power. I called out the guy who comes to do electrical "new home still under warranty " and he came in bedroom opened light switch, i took these pics. He did...
Hi all,
I hope you're very well.
(The switch goes to a 10W LED)
Is the above wiring going to be safe please, especially given the way the ring main is treated at the top of the picture?
(You might wish to leave aside any UK regulations as the above scenario is in a different country)
We have a meter EDMI - ES30B fitted to our property.
I understand from the fact sheet for the smart meter (https://www.edmi-meters.com/wordpress/wp-content/uploads/2018/05/ES-30B-Factsheet-English.pdf), that our meter is rated to withstand 460V which I imagine is under fault conditions rather...
Hi all, if I cannot access the line side of a crabtree 100A DP main switch. Would someone enlighten me how to conduct safe isolation on this installation. Would the main fuse need to be removed ? Thankyou.
Hi there!
While making my bed I managed to flap my covers around so much that it hooked around my light and ripped it clean out of the socket. Included are pictures of the situation that I've got at the moment. What I want to know is if it's safe for me to switch off the electricity to the...
Hello.
I'll apologize to start with as due to my lack of knowledge on the matter I'm likely to waffle a bit and call everything by the wrong name but hopefully you'll get my point...
I am having some renovations done at home and need to have the electrical meter relocated slightly. We have...
Last year we purchased a home that was built in the late 1990s It has one outbuilding, sort of a barn/shed about 160 feet from the house (and probably closer to 280' from the utility connection on the far side of the home), which has a breaker box in it supplying three 20A circuits (lights on...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc