Hello,
I have just posted in the Electrician's section one photo and two videos of what I believe to be a dangerous situation of short circuits happening within a shower unit.
You can see (also here attached):
1) Extensive burn marks on the plastic cover;
2) A vast amount of water leaking from...
This could be interesting. Any thoughts/predictions:
I have a pump operated shower – in the past year the pump has been replaced 3 times as it stopped working – but the plumber is at a loss to the problem and said it must be something to do with the electrics? This makes sense, because if I go...
We own a small, one bedroom flat (built 1989).
An EICR inspection raised three C2 observations and recommendations:
(A) The shower cable, and mcb were incorrect size (9.5Kw Mira shower) - Recommend replace 6mm cable with 10mm cable (12 meters, surface run, in trunking) and replace 32 amp...
Hi There,
Homeowner here with no electrical knowledge, so go easy on me!
We've had our garage converted, and coming to the end of the project. We've had a shower/utility room (2.7m x 1.5m) added as part of the conversion, within which is housed a stacked Tumble Dryer on top of a washing...
Hi
I've had an electrician fit a new set of led recessed ceilings lights in my bathroom including one which is in my shower cubical.
When he has taking the old lights out some of the ceiling came way and he has told me I need to fill the gaps around the light fitting in the shower. I just...
Hiya,
Had a Triton T80 8.5Kw shower for the last two years in upstairs bathroom connected to the mains cold supply.
Its still working but cutting out and the water going cold when the upstairs bathroom sink tap is switched on.
Have just bought a new Triton T80 10.5kw shower and hoping this...
Hi All,
I hope you are doing well.
I keep having the issue with this pull cord switch to the power shower.
I used a number of pull cord switches 45A and 50A ones mostly from Screwfix but I think the problem is with the wiring.
As you can see on the picture the RED and BLACK twisted copper...
Hi. I have an inverted spotlight above my shower and the light bulb has gone so need to replace the LED spotlight but I don’t know how to get into the fitting to replace the bulb. Unfortunately I don’t have the make and model as it was installed as part of a bathroom refit. Have tried turning...
Would you consider a single phase Shower Pump Motor operating with a temperature high enough to burn finger tips touching the motor body, to be too high.
Shower pump stopped during shower, checked various things. Fuse ok etc. Although the motor as said by the manufacture to have thermal...
Gents, I found this in a shower ( photo)
What would you say is the best course of action.
1, new shower.
Or
2, Replace cable. Replace connector block. 60amp connector block?
Cheers.
Hi All,
We have just had an electrical test done and have been told that our 8.5kW shower is too powerful for the 6mm cable. We have been told it should be replaced with a 7.5kW maximum.
I was under the impression and stand to be corrected that an 8.5kw would be fine for that cable as long as...
Evening all.
Doing a EICR in a rental today and presented with this.
installation date is 1992 and there seems to be no records since.
At some point in the recent past someone has added a electric shower circuit. Obviously a smash and grab merchant as no earth sleeve and it was the same in...
Well our own shower broke last nigh (don't worry - we have a bath as well!)
The thermal switch is deceased (gone to it's maker, pushing up the daisies ....) it's part 1746.436 or 4.1746.436.
Simples - nope not really, I just can't find one in stock anywhere, I have sort of ordered from city...
Run into this today at a house my nephew is moving into....
Original Dolphin 860 Shower (8600W) installed on 6mm Twin and Earth - maybe 15m length from the CU, which is an old MK board installed in 1986, but RCD protected - on a 45A MCB.
So far so 'normal'....
However, there is 2.5 T&E...
We had our bathroom renovated about 10 years ago and the original builder had left the shower wire too short and i didnt bother to get it fixed right away as we had another shower in the new loft extension done by the same builder around the same time. A few years go by and i then decided to ask...
Hi all,
I’m in the process of installing an en suite with a shower enclosure. I’ve created a recess inside the shower which will be fully tiled and sealed with moisture board behind.
I’d like to put an LED strip on the rear underside of the recess. What’s the best way to make this as safe as...
Good afternoon guys,
I was wondreing if anyone could help with the issue I have at home.
I have a MIRA offset quadrant shower (built around 3/4 years ago approx), and I am having leakings (see attached the photos). I have tried to put some silicone several times but the water is still going...
Reminer please as I've not been paying much attention to Part P changes - assuming that an existing install meets 2018 EICR 'requirements' - would a replacement swap of a faulty shower unit be notifiable works?
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc