Hello,
I am trying to fit 2x smart switches into my new build property. The upstairs hallway light is controlled by both an upstairs switch and a downstairs switch.
What I would like to do is set up a smart Switch upstairs that acts as a the main switch and turn the downstairs switch into just...
Hi, I am trying to wire a smart 3-way switch but the manual diagram does not make sense. Attached are photos of my existing switches and the wiring diagram from the manual. Which of my existing 3-ways do I swap out and which wires go where?
Thanks, I’ll owe you!
Hello,
I would like to upgrade our existing, wired, burglar alarm system for smart alarm system. We don't use it as the cat keeps setting it off, although it works fine. Rather than just get pet PIRs I would like to upgrade the whole system.
I don't want to go down the WIFI or hybrid route, so...
Hi All,
I hope someone can help. i'm trying to fit a smart light switch to replace my current one for the toilet (1 gang), but i'm having issues with the wiring. you'll have to bear with me as i'm not an electrician so only have basic knowledge :( the current light switch seems to be an...
A customer had a smart meter fail in such a way that it was passing on phase through to both of the output lugs meaning that both lugs supplied 120V to ground but there was 0 volts between them. The power utility replaced the meter and all was well but the problem reoccurred a few days later...
All, I'm a bit stumped trying to convert a three way traditional switch over to the Smart Caseta Single Pole On/Off switch. There are two switches today for a light, the plan is to convert one switch to the Smart switch, then add a secondary remote to the alternate switch location - essentially...
Hi All.
Due to the Covid probs i do not use the car as much.
I have bought a Ring smart charger to keep the battery topped up.
I would like to keep it in the boot permantly.
What cable amp and fuse would i require to run from the posative jump start point
to the boot.
I have some 27amp not sure...
So I've just recently qualified from my apprenticeship and I'm looking to expand my knowledge on a few different systems such as:
A) CCTV
B) Fire alarm systems
C) Door entry systems
D) Smart systems
E) Industrial equipment
Not working at the moment and not so eager to get back on site so soon...
Currently I have a fused switch situated in the hallway that operates the towel rail in the adjoining bathroom.
Looking to replace with a smart switch but considering options.
I have been told that I could put the smart switch adjacent to and after the present switch but I don't want a mismatch...
In the hallway we have a fused switch that operates the towel ladder in the downstairs bathroom. Any possible issues in replacing with a smart switch? I don't know of any with an integrated fuse.
Hi Guys
I'm wiring up an electric roller blind soon, putting on a conventional up/down/centre off retractive switch.
Would like to install a smart relay in parallel but cant seem to find anything out there ?
Ideally something like this (but this is purely on/off control only) with nice easy...
Having successfully installed some smart sockets, I have caught the bug of converting to smart home.
My next project is to replace the 2 gang light switch in the hallway.
The current setup is as in the first photo below. One switch controls the hallway light and the other an exterior light
I am...
As the title says, I am looking for a trailing edge smart dimmer. I have gone through 3 smart dimmers already, only to read here tonight that all the dimmers I have had are leading edge dimmers. I have used a no name brand, the Ewelink smart dimmer and the Sonoff D1(which keeps turning itself...
Have to say "DIYer", but I have no intention of doing any work myself - so "Consumer" might be better. Just adding 13A spurs is my limit.
I want to understand smart meters and Economy 7 in detail, before getting anything done at all. That will be after Covid, since there is no hurry.
I also...
Hi I hope someone can help, I have a light switch at the bottom of the stairs and it switches the light on at the top of the stairs. At the top of the stairs i have a light switch which is two gang for the top of the stairs and for the bathroom ( on the same switch). I understand I will need a...
Hi,
Currently We have 2 meters and each meter is connected to 2 CU. We are looking to upgrade to a smart meter. At the moment OVO have no slots for my area however, when I do get a slot they will replace 1 of the meters and remove the other they bit I'm not sure about is how will the 2nd CU...
Thanks for help in advance , I have 2 Deta grid connect switches im trying to install in hallway with led lights in ceiling
Issue
Wire switch 1 and 2 - Lights stay on in hallway - Buttons illuminate when pushed no change to the light stays on
Wire switch 2 down hall only - Light flashes and...
This might sound like a stupid question but if someone was on a variable electricity tariff and they didn't have a smart meter, and let's say the electricity was cheaper at night between 6pm to 11pm. How would the electricity provider know how much electricity you used at night so they could...
Hi, I need some help on what smart switches to purchase. I am going to hire an electrician do the install. These switches are going to go on the ADT system. My sales rep there for security said that any Zwave switch will get recognized by their app.
With that in mind, a few questions:
- If I...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc