Hi, I currently have a light that was wired as 3 way and am replacing it with a ceiling fan/light combo. What I want to do is wire the switches so they operate independently so light switch in one location and fan in the other. The power wire enters where the light switch would be going and...
I have a question for you all, We recently moved, and the old house had the analog meter on it, the new place has 3 structures on the property.. a barn, a defunct kennel which im going to turn into a workshop and the house itself.
All 3 buildings have these smart meters on them.. Our first...
Hi, I had my home entirely rewired 5 years ago had some outside lights added to the front of the house. I’d now like to add these into my SmartThings setup and have come across the Aeotec nano switch which appears to add smart control without needing to replace existing switch.
The photo below...
Hello,
I created this account as I have ran into a huge issue with my electric bill. I have been living at my house for 1 year right now. Every 2 months I have been paying anywhere between $60-$80 for my bill. I opened my bill today and it has jumped for $650 for this cycle. After calling...
I’ve currently got a Drayton wiser hub 2 channel for heating and hot water.
I’m looking to install hydronic ufh (3 zones) and would want to use the Drayton ufh wiring centre. So it can all be controlled via the same app.
Would I need to get a new Drayton wiser hub with 3 channels or can I use...
Be grateful to know if anyone is aware of a smart stat system that's built-in dual zone CH as well as standard timed DHW. As far as I know, Nest, Hive and Tado don't, you'd need to use two sets, which is practically possible but a bit 'lumpy' and obviously doubles the hardware costs. However...
hi im trying to fit a smart relay thing on my stairs light there is i switch at the top and bottom.
smart relay has 6 connections for no neutral switch
have it working on bench as follows.
L live
L1
L1 from bulb
COM to switch com
S1 to downstairs com
S1
works great on bench .
when i try on my...
So, big brother is coming to my town, and is rolling out those fancy smart meters.
My question is, what is the cheapest way to mask the loads devices give as signatures to the power company? Would putting a device behind a UPS make the device type not known to the power company? If not, would...
Do smart meters cause soaring bills due to inrush currents recorded digitally? Low power factor equipment may cause this???? What is the hive mind conclusion?
I have soffit led lights that are controlled by a photo eye and a dimmer switch. Would like to change this and go to a smart switch that I can set to sunrise and sunset in my local. Need to be dimmable also. This will be in basement. What would be a good switch to get?
Having just replaced an immersion element with its life expired cable and switch, I'm thinking of replacing the switch (20A double pole) with a smart version so that I can control the hot water from my phone etc.
Both the immersion heater and the current switch have earth terminals, however the...
Have a ceiling fan/light combo about 25 yro. florescent, incandescent, and a solid white led bulb work fine. a smart led bulb RGB-wifi acts as if it isn't a good connection and flickers rapidly between what appears a 50% brightness and full. Fan appears to be just a B W G install. other smart...
Hi all, a recent call out to a frantic home owner that the most everything in the house had blown up !
The cause was quickly found, the recently fitted smart meter had had a terminal failure at the neutral and as the supply was 3 phase and the overheating terminal got worse the neutral was...
Hi,
Domestic single phase smart meters in UK....what readout do they give to the house owner?
That is, if the house owner goes up to the smart meter, can they see a reading there and then?
What reading is it?
Presumably the reading they can see is the average power over the last 5 minutes (or...
Hi everyone,
I'm trying to have a clear view of is ok to connect a 1000W industrial fan to a 400W Tuya smart fan controller. I have some knowledge about the electricity but I'm not totally sure if it matters the switch load as long as the fan has is own capacitor.
I'm asking this as I...
Hi,
I am looking to replace my bathroom switch in my flat for a smart switch.
The switch controls 4 downlighting and the extractor fan. The extractor is also controlled from a separate switch in the kitchen. I.e two ways
below is picture of the old switch wired up.
Supply side has 3 brown...
Hi,
I am from UK and having a very basic knowledge in home electrical systems. I would like to replace my traditional 2 gang switch (which controls 1 way outdoor light and 2 ways hallway light) to smart wifi switch. Here is the exact existing wiring diagram.
I am confused with 2 way - 3 core...
Hi,
I recently just bought a new build home from Cala homes. Regarding the handover electric meter reading, instead of taking the smart meter reading using the figures on the lcd screen, or following the British Gas website instructions for taking a smart meter reading "total import". Cala...
Hey all
I have some basic electrical wiring experience, and I'm trying to install a wemo smart light switch in my bedroom
Load and line wires were easy to find and connect, but I'm having trouble narrowing down where the neutral wire is (or if I even have one)
Here's a picture of what I have...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc