I bought brand new battery and put it into the car, didnt drive the car for 3 weeks as use a company car and was away from home for about week and half. When i went to take the car for a drive and enjoy her, the battery was as dead as dodo. Got battery replaced and have now taken to leaving the...
I have a few electronic items in my room.
When some one switches on the bathroom or hall light (same floor), the LEDs on my monitor go off & back on. Other items such as PC & consoles are not affected.
I have one of those switched extensions, I've noticed if I turn on one of the plugs for my...
What's with these guys. I want to buy an upgrade but they never answer their phone or return a call. They don't even bother replying to emails either.
Question: Is there some secret code/sign you need to use to get their attention or have they gone to the wall.
Hi all. Anyone know were I could get a regulater for a intercom system. The model number is MWS9125.
It was set at 12v . 230v 50hz 54w. Never really dealt with requlaters to be honest. Was wondering if a 12v transformer would do the job. But this said 54 v on it thats all. Any help...
Hi all, getting a tax rebate from the lovely HMRC very soon hopefully, looking to buy a van with some of it, if anyone's got a 58-59 plate VW Caddy going fully loaded for about 200 quid that'd be perfect ;) seriously though, looking for something around the vauxhall combo/ transit connect size...
did a cu upgrade on a house the other day but could not identify 1 16a radial circuit. The old board was not labelled and the owners were no help. I searched high and low for it and the house was also full of junk which didn't help. What do others do in this situation ?
As above really! I'm in the market for my own van and need help deciding what to go with.
I currently drive Transits and Sprinters quite often for another job, but I think the fuel burn would be unreasonably high for me to have something that large myself.
Bit of a ---- up between the smaller...
I'm sitting my 2394 this month and was just wondering if anyone had any tips. I'm revising as much as I can and reading chief examiner reports etc the usual stuff, nothing is sinking in though. In fact I feel worse for it than went I went on the course haha. I'm thinking just read GN3 every...
testing is all new to me so i have a few questions to ask , so i know what to do in future if there are any surprises in store
1- when testing an old board:
some cables IR test 6 Mohms , above the min 2 but is this cause for concern or normal ?
2- both rcds tripping at once , how do i solve...
Hello everyone!
Hope all that sun brings to everyone a lots of KW!
On display of my Fronius IG 30 plus inverter red led light is on and error on display "STATE 117"
Any idea? Looked on manual and is this fault relaited to AC and national grid.
Dos anyone had this error on their inverter...
many have seen these before but im posting it again as its slow tonite
tears stream down my face watching these lol.......
Electrician vs Fitter - YouTube
http://www.youtube.com/watch?v=mViO9mnCTBo
stong language contained within.
enjoy.
Hi Everyone, I have gone back to using hand written certs a lot easier and all completed on site. The problem is with the elecsa certs when doing a consumer unit upgrade the comments on existing installation box is too small to fill in all observations so I have seen a observation continuation...
hi im not too sure if anyone will be able to help but worth a try anyway i have been asked if its possible to auto opener/closer on a box top. Specs of box top is like 150 cm wide but in 2 halves so each side 75cm and need it to slide out so basically 2x 75cm squares sliding away from each other...
I thought I might have a look at this system a couple weeks ago to make the transition to the new DTI guide etc a bit easier. I've taken advice from the Sun Lounge - thanks everyone, but have since had a couple of calls from Easy MCS.
Basically they got me to try their online system for a week...
Got a home cinema to do with the above not sure on exact model but fitting dimmable led strip and maybe some colour changing too.
What do ppl reccomend not fitted led strip before but want something very high quality.
Lutron needs 40w per channel but you can buy synthetic resistor and works best...
Hope your guys can help with this had my 4 kWh system in since Dec 18 2012 everything is working great but i have just entered my import meter reading onto Scottish Powers site and i don't seem to be seeing much of a reduction in my ele usage
Feb usage = 369 vs generation 142 kWh export...
Considering registering with ELECSA and thought I'd see what people have to say about them.
Did their online registration form and was a bit surprised to see they want payment immediately, which put me off submitting it.
Any comments about them would be appreciated...
Can anyone throw any light on why, after I have taken a spur off a ring main (via a fcu) for a toilet cubicle - ceiling light, mirror light and fan - the plug-in mains doorbell units 3 of them, are going off, regardless of whether fcu is switched on or off? only the ceiling light is permanently...
Hi folks
I am a qualified sparky with 42yrs experience recently I retired and took redundancy for health reasons from a large national building maintenance company where I did electrical maintenance and installations,the company was NICEIC registered,I have bought myself a small van and intend...
Let's see your drawings boys I'll post some of mine on monday they're all at work.
Also post any complicated diagrams you've seen/got so I have something to try and decipher!
Electrical Installation/Design to Electronics drawings post it all.
I am aware we already have a Thread for showing...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc