Advice Please..
Installed a 1 gang double dimmer powering, on one side, a triple 3x50w halogen ceiling fitting. On the other side it powers 2 separate 50w halogen switched wall mounted spots connected part way down the line at a simple junction box housed in the roof-space.
The two separate...
Hi all
A question for those of you pricing your own PV systems and advising on expected FIT returns etc.
Do you have PI insurance to cover you against possible errors in your advice?
Is this a requirement of MCS?
What kind of premium should i expect to pay?
I'm pricing a job for my...
i have just walked out on my job(as a subby). all the trouble started when they asked me to, through crimp a 10mm main bond i think this was in my 1st week that i started i told my supervisor this was not allowed he said its too late to replace it on hand over,the supervisor and the director...
Got to connect up electronic bath filler control unit..... which is only rated @ 20w, so very few amps - 0.08A
Just wondering what the smallest plug top fuse you can get it is ?
hi there every
one
done a periodic on what can be only describe as a pre site constrution then lobed in place accomodation building for one of her majestys places etc.
opened up a push button time delay switch thinking standard or conversion but no :eek: parallel using twin and earth...
Hi all, looking for some advice........my dad recently purchased a Lacanche cooker off ebay. Went to wire it up and it appears he had overlooked the fact that it is a commercial cooker and requires a 3 phase supply to power it. The question is, can it be wired up to a standard domestic supply...
Hi All,
Recently did a PIR on my brother-in-laws house (practising for my 2391 next week)
Most things were fine and everything tested okay - the only thing that caught my attention was this:-
(opinions appreciated)
It was a Square D split board - half circuits on RCD and half not.
The...
Hi everyone.
Just found your forum and wondered if anyone could help.
I've come across a non standard socket and need to find out where I can get one.
There doesn't appear to be any manufacturers marks to indicate who makes it, but it is basically a 13amp 3 pin type with one major difference...
Hi guys. Can someone tell me if it is possible to do r1 + rn and r1 + r2 socket tests with the standard lead which comes with the megger 1552. This is the lead with the 13a plug on the end. I have read that this can be done but I would love to know if this is true because it would save me...
We were given a list on our course, but the NICEIC inspector pho-pho'ed them and gave me another list.
What are your favourite Standard PIR Limitations?
Just a quick question really,
Have recently past my inspect & test and thought that was the done deal and that I wouldn't bother getting cert as I didn't fancy the household work stuff.
I was under the impression from my instructor that I was now qualified to do PIRs, however in the pub...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc