Hi - On our small vessel we have a 12v failry powerful motor to run the autopilot, where the power is supplied by the boat's battery bank. On an 'independant' system we have 240v that is supplied via an inverter, but the power originates from the same battery bank as the 12v system. The...
I know the effect of a lost neutral (floating neutral) on a 3 phase system, and the theory of why the line voltages can vary.
However, I have been attempting to show this by calculating the line voltages of a phase system at given loads on each phase.
Lets say:- Red 296 Amps, Yellow 279 Amps...
Autumn is now here, it's that time of year where the clocks go back and lighting control moves forward. A time when UK customers with gardens want to light up their outdoor spaces earlier in the evenings; meaning they'll be looking for new lighting and a reliable method of wireless switching...
Went to a house to extend a circuit and upon doing the minor works I couldn't figure the earthing system. There was no DNO cutout and L and N came from overhead powerlines. I followed the main earth cable down and it went half a foot below the consumer unit to a connector block with 3 small...
I currently have a home with 7 interconnected, hard-wired smoke detectors. I have a hard-wired heat alarm in the garage that I need to have interconnected to the rest of the system, per local regulations. My solar installer added the heat sensor but does not seem to know how to handle the...
Doing a lot of EICRs at the moment and have came across what I'm sure is a common enough problem. In an off grid rural cottage I have a TT system, Diesel Generator that runs and charges batteries when they are below 10 percent or so.
Ra is about 150 Ohms... was about 3 ohms for Ze before main...
Wireless switching can really simplify an electrical installation. The FERRET is an RF unit that can add remote control to applications. It's tiny size makes it perfect for fitting in small enclosures like the WISKA range.
This month, @rfsolutionsltd have teamed up with @wiskaukltd to give away...
Hello everyone, I currently have two solar modules left over from an installation and I would like to use them to set up a solar system on the balcony. The system has an output of 800 W. Can you recommend a suitable inverter for me? Thanks for the help.
Hi, folks.'
I have a carrier 38MGRQ48E '5 zone' mini split system with 4 'heads'/evaporators installed, and one 'channel' still open. Had it installed about 6 years ago.
At the time the tech said "You really should install the fifth one in your bedroom."
I didn't listen to him and now i...
Carrying out a EICR in a commercial setting. In the main intake room the DNO supply comes in and it states clearly this is a PME system. 5 years ago it had a 120mm earth from the head going on to the MET which then had separate earths to each isolator on the panel. Within that time a new pumping...
Hello!
I've just moved in to a new property with "all electric" heating system and trying to figure it out. The agency/landlord are of no help so trying here. Previously only lived in properties with the usual gas combi boilers so a bit lost. It's a one bedroom flat with two of us living here...
Shop with no earth coming from head, overhead lines in sight everywhere - definitely no earth from the DNO.
Two 10mm earths going into the DB. One going to the water and another which disappears through a wall somewhere heading towards an external area never to be seen again.
Customer doesn’t...
I was working on a small door entry system today (4 flats ). It got me thinking , that say it was 16+ flats system , how would you go about dealing with the 16+ cables at the main entrance . Obviously a junction box system would probably be required , but was wondering how to over come that...
My 1951 CA home (none of original wiring grounded) has 7 receptacles* that have a separate ground wire extended into the subfloor and connected to the galvanized water pipes. Those pipes will soon be replaced with PEX. My plan is to drive ground rods with a new ground wire extending from the...
Hi
How do i access the earth rod to service it, where abouts will it be located and does a tt system have upfront rcds which will be probably in another enclosure?
cheers
B
I'm not going to touch it but I've a PV system installed that has CT clamp in supply meter. What does this do, why does it increase my import from grid?
Here’s what happened, we’re looking for a professional opinion: The auto transfer switch for our Generac stand by generator “exploded” (we heard a bang and the house shook a bit) and subsequently caught on fire earlier this week. It was mounted to an exterior wall. The generator was installed 8...
Introducing the NEW IP Rated SWITCHLINK System!
This system provides a quick and easy solution to a light switch when cabling is tricky, expensive or time consuming.
Features:
868MHz System
IP68 Receiver
IP66 Outdoor Transmitter
Up to 100m range in Buildings
Up to 500m Line of sight...
We have just completed a self build, and heating system is Air Source Heat Pump, unvented HW cylinder, Buffet Tank, all Vaillant equipment.
The heating firm have ceased trading before the system has been completed and fully commissioned. Ground floor is UFH with 6 zones controlled by Heatmiser...
Big argument with a newly qualified electrician with all the necessary qualifications
Had to give him a hand later on during the day, nice DB fitted &to be fair quite tidy too , with SPD…It’s a TT System with a good Ze 24.8 ohms.
All Rcbo’s except for the Mcb supplying the SPD, which I pointed...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc