Hello all
I need to re-wire my original Honeywell T6360B thermostat because the wireless version I replaced it with a few years ago is just so unreliable; But I need advice on which wire goes to which terminal.
I have the following wires: yellow, red, blue and yellow/green which need...
I want to add a remote room thermostat to my present central heating system.
At present I have a Draytek non-remote room thermostat which is located in the bedroom and I want to leave that one there. It has been wired/setup so that, when the heating is switched on, when the temperature drops...
Hi everyone,
I'm looking for some help with reconnecting a thermostat on a Stoves 1100, there are three lots of wires and three possible places to connect them to, any help with this would be great.
Thanks
Karen
Following my previous post in this forum regarding installing an additional forum, I would like to follow a suggestion made that I should install a remote room thermostat.
My current room thermostat, located in a bedroom, when it calls for heat it is wired to simply switch on the central...
I have a simple central heating system with a traditional Baxi Solo 2 60RS boiler supplying heat to radiators around the house.
The room thermostat is located in the main bedroom and so calls for heat
only when the temperature in that room requires. When heat is required this
thermostat is...
Help.
Just opened the the warmup 3iE sensor box - brand spanking new and no bleedin floor sensor and ready to plaster the cables in.
:blush5:
So my dillemma is - I have a spare Aube Under Floor Heating Thermostat TH132-F-230 - would the sensor from that be ok to use with the warmup heating...
I have been asked to install a new C/H Thermostat for a customer - never done one before so will be a learning curve.
How easy are they to install (never seeing the wiring diagram before - of course seen one in operation)
What makes are good to use, I dont know the make/model of the existing...
I have recently had a new combi boiler fitted after the old Ferroli died! I live in an ex council house so the wiring surrounding the boiler is a tad messy!!!
At the side of the boiler there's the fused socket, an alarm socket (for when the pressure gets too low, installed for the elderly tenant...
A thermo stat upstairs wired back to boiler and a thermostat downstairs wired back to boiler? Why would this be. Should it not be the up and down be wired in series back to boiler?
Hi chaps hope some one can help .
Following a gas landlord cert check a friend of mine was told each of his two combi boilers had to have a thermostat fitted, this was agreed and the plumber fixed to wall next to each boiler a battery powered Drayton Digistat +3 programmable Thermostat both to...
hi, got a new job, doin boilers. A wee bit out of my element:P
Got a vokera combi to wire, i understand almost everything apart from the thermostat.
Its a danfoss RET230 VF2.
what do i need to wire this?
Wire into Live and neutral terminals on the stat?
Wire into number 2 and 3 on the stat?
Or...
Hello peeps,
first message from George. I see that this site if furiously busy, so I hope I can get help here!
The landlord refuses to wire a thermostat to the boiler - causes constant cutouts, cold water, temperatures and pressures being reached which are no doubt no good for the boiler.
I am...
I am off up north at the start of July to do a Buddhist monastery's PAT testing. The abbot has a heating thermostat in his room that makes too much noise, humming etc and it is disturbing his meditation and he wants me to change it. Does anyone know of a thermostat that is quiet when installed...
Hi,
I have a little thermostat... very basic... ( two metals theory.)
think it was orig a thermostat for a fish tank heater.
Im thinking of putting it into the circuit of a small heater, so it will heat
the greenhouse to 70 , then cut out.
Im wondering, should I wire it into the...
Hi guys
I am replacing an old Honeywell stat with a Salus RT200. The old stat a live and switched live ( no earth ).
New stat has connections L / SL / N earth connection for park only. I have identified the L & SL from the supply ( twin and earth flex ). The cpc has been cut back at both ends...
Has anyone ever fitted one of these to a dual feed towel rail?
Customer has a dual feed rad and complains that rad gets dangerously hot? So im looking into wether an element with a thermostat can be fitted.
Ive spoken to the company that supplied the rad and they say they dont do them with...
Hi,
Ive been asked to connect a volt free thermostat to a combi boiler. The cable needs to either go from the boiler (under capping/plaster) upstairs, across the joists, and back down under capping/plaster in the hall, or may be behind the kitchen units, round the kitchen, and then through the...
I have been asked to install a 3KW mounted down flow heater with a 7 Day timer next to fuse board and a temperature controlled thermostat in the same room as the heater how do u wire this up do I feed in and out of the 7 day time clock and then take a 3 core from the fused spur to the thermostat...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc