Hello
We hold a contract with a local letting agent who has approx. 450 houses. They are wanting us to start a PAT testing program across these and I have negotiated some not too bad prices so it is definitely worthwhile us completing this as it is also a foot in the door for further faults we...
Hi, ive recently started a new job where I'm off the tools now, and my tester is 1 tool I will probably never use again (fingers crossed) so im selling it, it's got all the basic leads, the test button lead, all 5 kew tech light mates, 2 and 5 amp socket adaptors, loads of little bits with it...
I had an odd one today.
I was investigating a problem with a light that was not working. As it turns out, it was multiple loose connections causing the problem.
The circuit is wired in old unearthed two core cables making the contact voltage tester a waste of time.
At the light fitting there...
Guys,
I have my Fluke T5-1000 in as new condition for sale.
It has honestly only been used for testing about 10 times. This is because I bought this about 1 month before I got a new job as a Project Manager. This meant I am off the tools, unfortunately, and now longer need this bit of kit.
It...
Hi all,
Strange one today that i've never seen before - hoping someone else may have seen this...
Wiring an additional outside bulkhead today - couldn't easily get to the last fitting to take a switch wire from there so split the switch wire as close as i could to the fitting and wired in a...
Looking for someone with 2391 to test type certs online or software after rewire, do EICR before rewires on some properties ( 10% ) , able to communicate with main Contractor on e-mail And send required certs on time , answer questions??
Good rates And very flexible, just need someone to do...
Testing during a board change, a RFC on a 32A 60898, with rcd protection, you find that the max Zs is exceeded by 0.1 ohms using the no trip setting on your mf tester
On the EIC do you -
A) simply record the actual measured value
B) record the actual measured value and note the position under...
as title, I have a lot of car chargers to test. They are plugged into a socket via standard 13a plug, then goes into the charging unit, from there a lead to the car with the socket to be put into the car. They are for nissans and Mitsubishi cars. I have tried testing on seaward 250 but fails...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc