ufh | Page 5

ufh

Recent contents View information Top users
  1. D

    Wiring Ecodan ASHP control unit to Polypipe UFH

    Hi All, firstly i apologise for the length of this message but i am going round in circles with polypipe and Ice Energy. I've just had the second fix completed on my self build and am concerned re the wiring set up with my polypipe UFH and my 14KW mitsibushi Ecodan ASHP provided by Ice...
  2. L

    Combi boiler and UFH

    Hi, I had finished a first fix on a timber frame 6 bed house last week, all the customer wanted was standard radiators and hot water off a oil combi boiler. Rang me this morning to say his wife wanted UFH in the kitchen, sunroom and utility. So I went there this morning to run 3 core cable to...
  3. B

    S Plan with UFH

    Hi, I have wired an S Plan with a 3rd valve for UFH. The system runs with 2 pumps, one dedicated to the UFH. at present I have the boiler and both pumps wired in parralel and called from the orange wire out of the zone valves. How can I wire up to have each pump seperate as at the moment the...
  4. yellowvanman

    UFH and other heating

    Got to wire up the heating system in a house later this week and its not totally straightforward: UnderFloorHeating on ground floor - 6 zones, radiators on 1st and 2nd floor, hot water cylinder and a set of towel rails, all of which need to be on different timers (4). Problem is when joining...
  5. N

    Wiring UFH to existing y plan

    Hi, Please bare with me. I have attached a diagram of the plumbing that has been done to create the UFH. and the current wiring diagram for the CH and HW, My problem is i have heard alot about "bakfeed" to the mid position valve through the orange wire. Is there a wiring diagram including my new...
  6. S

    UFH internet connection ?

    Not sure if this is the correct section ? I am currently installing cables for a wet underfloor heating system, stat cables and control wires to the boilers and tanks. Connecting all this up is not a problem, the issue that has accurred is the the builder has told me the client would like to...
  7. D

    Large load UFH

    Doing a kitchen job at the moment and as is the norm electric under tile heating has been specified throughout the tiled areas. Being a big area the load (about 4kW) is greater then the stat can handle so i'm going to have to fit a relay or contactor in line with the load. Firstly, does anyone...
  8. M

    s plan 8 zone ufh diagram?

    as part of a re wire the house is having underfloor heating, via the boiler. having spoken to the plumber he says they are going to be using a john guest 8 way mains voltage system John Guest Speedfit - The World Leader in Push-fit Fittings, Pipe and Plastic Plumbing Systems - Mains Voltage...
  9. R

    Kitchen Island Supply with UFH

    Looking for some advise on how to supply some sockets on a kitchen island through a floor that will have wet underfloor heating. The floor hasn't been started yet, so I've got the choice of which layer to install it in. The complete structure of the floor starting from the bottom will be...
  10. S

    Critical help needed - ufh system wiring

    I have taken on a job which I probably should have not and have now come unstuck. 1 - Boiler VITODENS 100-W supplying two zone valves. From valve one to central heating for house and need new thermostat. Apparrently no volt free connections on boiler and have run 1.5 t/e for thermostat...
  11. S

    ufh getting hot and cold areas

    hi all, anyone come across this problem, mat type underfloor heating, heating up in some areas not others. apparantly never been very effective. it is installed in a conservatory under oak panelled floor. does not matter what you set thermstat at will not heat up correctly. could it be a faulty...
  12. E

    Installing UFH

    After numerous problems installing Under Floor Heating I am trying to decide if spending a couple of hundred quid on some testing gear can help eliminate faulty mats/probes etc. Numerous times I have been called out because the probe has failed on an install (customer usually supplied...
  13. E

    UFH Mat Problems

    We installed an underfloor heating mat in a bathroom on a new build last week and before letting the tiler put his tiles over it I checked it with my ohm meter and got a reading of about 6ohms, tiliing finished so I went back today to fit stat and power on. Decided to check with my ohm meter...
  14. Dan

    ContractorForum: Turning on ufh for the first time: I have electric underfloor heatin

    ContractorForum: Turning on ufh for the first time: I have electric underfloor heating in a 4m x 5m room, tiled with 45cm x 45 c.. http://------/4z1p5Z More... Follow us on Twitter.
  15. D

    17th edition and UFH

    Hi all..... Has there been any changes to the installation of electric under tile heating in bathrooms etc..... I am a tile fixer by trade . How has this effected if any the installation for tile fixers if we use a sparky for the connection...which i know you have to anyway..:) What i want to...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top