under | Page 5

under

  1. J

    MCS Guide is under review

    Consultation is here - been extended to 15th, to allow access to IET COP
  2. P

    Wet Under floor heating manifold and multi room stats...

    Evening chaps hope you’re al keeping well. Quick tech help question, I’ve got two large high spec new builds to wire up early summer and they’ve both got wet underfloor heating my task is to wire it up obviously. I’ve never done one before and it’s also got 5 room stats upstairs alone. Have any...
  3. tim@fuseboxwal

    Voltage drop under load

    Hi, has anyone encountered a similar fault... TN-C-S supply with old wylex fusebox. Last night, customer experienced total power loss whilst in the shower (electric), nothing tripped and no fuses blown. Customer pulled out fuses to check them and then replaced them all but could only get some...
  4. M

    Best under cabinet led strip lights

    Hi guys Doing my kitchen and want to put the led strips under the cabinets and also the kick boards. Any recommendations for any? The one for the kick boards would need to fit round a u shape so would ideally be flexible to bend round. Cheers guys
  5. S

    UK Driveway light

    Ive got a driveway light on armoured cable. The cable comes into the house under the stairs. Can I put a plug on this cable and plug into a RCD socket.
  6. P

    Consumer Units under stairs

    On a new build can you still fit a CU under the stairs.
  7. C

    Under ground wires to shed

    Hey everyone, I'm trying to run electricity out to my shed to run a workshop (table saw, miter saw, dust collector, some lights and some other small power tools) . There used to be a hot tub that was gone before I bought the house thst has a 100 amp double post breaker (I think that's what its...
  8. K

    Can i run led under cabinet lights off a ring circuit spur?

    Hi I'm fitting a new kitchen and as the light circuit isn't that easy to get to I want to fit a spur off 2 different sockets. My thoughts were to run a spur from each socket and fit a fused switch to feed low voltage led under cabinet lighting. 3 leds under each side. would this be acceptable or...
  9. S

    UK under cabinet lights question

    So picuture under cabinet lights, a 230 supply from a spur, to a LED tamlite driver, and 2 lights coming off of this... why is it that one of the lamps fails weekly and the other one has been going strong for over a year..
  10. RapsterUK

    Kitchen under cupboard lighting wiring

    Hi all, we recently moved into a house that has a recently fitted new kitchen. One thing that was never finished was the under cupboard lighting (under the top cupboards to light the worktops) We were told the wiring was already there and connected to an existing switch. There is indeed wiring...
  11. S

    garden cabin wiring exposed under floor

    Wiring a large garden cabin and the customer has specified floor sockets. The floor is pine floor boards over osb boarded direct onto joists with no gap and joists and below are actually outside as cabin has no sides below floor level. Does anyone have any tips on how to weather proof the socket...
  12. S

    Are 30mA split load consumer units non compliant under 18th edition

    Hi All, Just wanted to see what peoples opinion is is installing a 30ma Split load board compliant/ non compliant under the 18th Edition or you have to use RCBO's for each final circuit? BS7671:2018, Page 155 regulation 531.3.5.2 is a note which says on TN systems which states " Exept where...
  13. M

    Using IEC cable under concrete floor

    Hello I've been asked to supply power to the middle of an office floor to supply the table with power, only a small office but they don't want trip hazards but the don't want floor boxes so to keep there costs down for them instead of it being permanent in case they move I thought of chasing...
  14. G

    Under ground service to weather head or service head.

    What is common practice when hooking Armoured cable to a weather head. Do I need a aluminum weather head or is a threaded PVC one ok? Do I use a weather head with threads so my teck connector can screw straight in.....do I need ground bushings at both ends? Any advice is appreciated. Thanks,
  15. A

    UK Plug under leaking sink

    We have rented a house where the landlord had installed a single socket directly beneath the water feeds and plug to the kitchen sink. the socket is mounted on a loose hardboard partition in the back of the under sink unit, which is not an integral part of a carcase unit. The dishwasher was...
  16. S

    Under floor heating over 3kw

    Hi guys Being to a job today where the builder has installed some electric under floor heating Total area is 20.5 m2 The mats are 150w per m2 The total load is just over 3kw. He has first fixed the wiring and checking it he has used a socket wired off the ring main to spur off to a switch...
  17. S

    Earth wire loose under sink - advice

    Hopefully a very quick question. Whilst looking under my sink this morning I noticed the Earth wire between the hot and cold pipes is no longer connected. I can't recall if it ever has been but I'm assuming this has come loose and I should reconnect it? If I do connect it should I take any...
  18. G

    Hardwiring under cabinet lights

    Hi all, I want to add some under cabinet LED’s to the kitchen and hardwire them to a light switch. We had our kitchen newly fitted out sometime back and the electrician has already wired to a spare switch we have and left the other end of the wire in a junction box on top of the cabinets. This...
  19. Gavin John Hyde

    What lurks under the floor?

    Customer sent me a picture of some cables that lead to a socket, needs them moved.as socket is below a window that will be knkcked through to make a door. Apart from the lovely spider in the picture, if you zoom in there is some thing with a bright green eye staring at the camera!! WTF is that...
  20. P

    Newbie from the land down under

    Hi Folks, I am well passed the sell by date at 77 but often do some electrical work providing I know what I am doing I was a pro guitar player over 45 years. I repaired all my equipment over the years and made a few circuits. I have just returned to the UK due to health issues...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top