under | Page 8

under

  1. Jim90

    Lamp post under mains pylon question

    Hi guys, We are replacing lamp post heads on a site and all is going well until we reached a set of 4 underneath 11/33kv pylons. We are getting a horrible ‘belt’ off the casing of the lamp post head. The post is coated so unable to receive a belt at low level. All we can think of is it’s the...
  2. Leesparkykent

    ERG, Lom maintenance and any other name they trade under are on watchdog

    Any one who's been not paid by this company may wish to watch it.
  3. D

    Wet Under Floor Heating Modification

    Hi Guys. I have a flat with a 9KW electric boiler, dedicated for the wet underfloor heating system. The tenants have reported that all the digital room stats were not working, as when they increased the temperature to get more heat, nothing was happening. Within 15 minutes in the property I...
  4. J

    Can incoming mains run above ground under suspended floor?

    Hi all. I'm looking for some expert advice on the above. I am having an extension built and the footings are a raft slab which can be built/poured under the existing incoming mains cable (it's in a black pipe approx 50mm dia). There will be a suspended floor approximately 100mm above the...
  5. R

    Kitchen under cabinet/plinth lighting

    Hi Im just wondered if anyone can recommend some under cabinet/plinth lighting they use? I was thinking led strip lighting All help appreciated Thanks
  6. D

    Sockets under desks

    I’m working on a small office job at the moment and have to install a few twin sockets underneath a couple of desks, the desks are back to back with each other so no wall to fit the sockets to. I’d just like to know what other people’s opinions on the best way to do this are, I’m not keen on...
  7. R

    Eyelid Lights Fitted Under Soffit

    Wondering if anyone has fitted eyelid type wall lights under soffits? I think I've only seen these wall mounted but I want to light up my double garage door, I want the light to point more out towards the drive than light up the door itself so wondered if this would work? Also there is a sensor...
  8. Gavin John Hyde

    Under cabinet lights issue

    Been a bit baffled by an issue on my mates kitchen under cabinet lights. She has 4 lights, they are around 12 years old, the house was her mums but she inherited it, 2 work fine with no issue, the other 2 have intermittent flickering, she has replaced bulbs on a couple of occasions and still...
  9. K

    Disappearing voltage under load

    Hi all, quick one that I’m guessing one of you guys will solve quickly! Currently been doing some work on an old wartime building and trying to get power back onto some son floodlights after some demolition work internally, I’ve got 240v across line and neutral at the junction box (that’s...
  10. gazdkw82

    Cable support in under floor void

    Upon moving some floorboards to drain the boiler I stuck my head in the void that's under my downstairs living room floor and noticed the cables between sockets are just hanging, suspended in free air. Is there any need to add support? I've taken the socket faceplates off and it doesn't seem the...
  11. Chizzle

    Electrician Jobs Hi to all, Looking for some work as a electrician mate and someone to take me under their wing

    Hi my name is Chaz based in Hounslow London. I have just recently completed my studying as a domestic installer. I know its not as good as the whole collage learning. Im 32 years of age currently working full time in a totally diffrent industry but looking for a fresh start and new career. My...
  12. G

    Found cabling under floorboards, is it safe?

    Been living in our current house for a couple of years and finally turning our spare bedroom (junk room at the moment) into a useable bedroom. I want to move a double socket a couple of feet to the left so we can fit some wardrobes in so I lifted a floorboard up today to see if it would be easy...
  13. S

    RCCB tripping when under load problems

    Hello I am new to the forum and was hoping I could pick your collective brains. I am an electrician with 7 years experiance. I have mainly worked for the MOD and on commercial and industrial builds throughout my time. I now do the odd bit of domestic work and need some help on a kitchen ring...
  14. D

    Insulated wire running under radiator?

    I have a radiator mounted on the wall under the window and a socket to the right of the radiator. I have an extension running from the socket under the radiator to my desk; there is enough wire so that it runs along the floor under the radiator. Will the wiring be dangerous due to the heat of...
  15. S

    Under cabinet strip lighting, Upgrade to LED

    Hi I have under cabinet strip lighting. The old 2 pin lighting. I want to buy LED. Question . Can I just use the same powere cable that I used before. I have enclosed some photos . If anyone can advise , it would be much appreciated Thanks Steve
  16. TonyJohnson

    Under floor heating in a shed?

    Hi, I have been asked to finish a job in a shed installed 2 years ago. Just reading up on the regs, as it is heating there is an element of a higher fire risk.... What the deal if its in a wooden shed?
  17. martinwood333

    Breaker Tripping under unusual circumstance...

    Hi there all. First off would just like to introduce myself real quick. My name is Martin and I live in Airdrie, Scotland! My Wife and I have lived in our house for a little over 3 years. For the past year or so, I've been experiencing a rather odd issue (which has gotten progressively worse)...
  18. rustynails

    Under cabinet LED lights issue

    Hi all, I have a problem with two sets of 12V LED under cabinet lights. Set 1 is a set of 6 lights under the kitchen cabinets. Set 2 is a set of 4 lights above in glass cabinets. The problem is set 2 flicker/pulse every 20/30 seconds whilst set 1 is on and only when set 1 is on. I have IR’d...
  19. N

    Can you hardwire a plug-in LED set of lights (for under kitchen cabinets)?

    Hi there, I am getting my kitchen replaced next week and I need to buy some undercabinet lighting. I prefer to have them hardwired instead of plugged-in so that we have a free socket and less cables running around. I have found a set of dimmable puck LED lights on amazon which I like but...
  20. P

    Eicr cooker switch under cupboards

    Hi all been a while but need advice, done an eicr today found that the cooker switch has been left under the plinth so cable not secure etc, tested at the oven which was fine earth wise, what code would this be regarding access and cable security etc, thanks in advance

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top