unit | Page 9

unit

Recent contents View information Top users
  1. C

    Recommendations for voltage tester with proving unit

    Hi everyone, Which proving unit kit would you recommend? Obviously would be better to don't spend a fortune. Kewtech, Megger, Fluke o Martindale? Thanks
  2. J

    125A consumer unit powered by 63A Switched BS88 Fused Unit

    Hi, Ive got an upcoming job to determine the cause of a BS88 fuse tripping in a switched fuse unit that powers a 125A consumer unit yet none of the MCB's trip, Just the one cartridge fuse. What is a concern about this site is that the old fused switch unit is 63A, yet it is feeding a 125A...
  3. D

    Oven with 13a plug top

    Been asked to fit new oven , which comes with a 13a plugtop , there is no socket close to plug into , if i cut plug off and connect into cooker unit connection behind cooker , do i have to adjust the 30a cooker unit fuse.
  4. B

    Time needed to test consumer unit circuits?

    Hello, how much time is needed to test consumer unit circuits before re-connection to the mains? Is each circuit a 5 or 10 minute job?
  5. D

    UK Consumer unit in a meter cupboard

    Can a 1-way unit be installed in a meter cupboard? My meter is at the rear of the property and consumer unit at the front. The meter is due to be changed in a fortnight's time and wondered if i could ask that room is left to accommodate one. The reason i ask is that i ordered an EV in October...
  6. J

    UK Consumer Unit spare way

    Hi all. I am due to get an EV wallbox fitted so I will be running a new 6mm SWA from under my stairs to the termination point outside. My issue is I have no spare ways for a 32A breaker in my consumer unit for the installer. Is there any recommendations on shifting some load to free up a way...
  7. gazdkw82

    Recessing consumer unit

    Got alot of works being done at my house. I'm debating studding the wall out near the consumer unit in order to easily install new cables. Some of the cables are data as well as electrical and will be enclosed in their own containment. The board is a metal clad split load board (Crabtree...
  8. A

    Could having both factory tweeters and coaxial speakers be overloading my head unit amp?

    My head unit overloads whenever I play bass-heavy music, if it gets too bassy, the sound will cut off completely and won't come back until hours later when it has reset. I have alpine coaxial speakers (RMS 60 W, peak power 240 W, impedance = 4 ohms) and a sony dsxa410 head unit (4 x 55 W...
  9. D

    Consumer unit resposition

    Client is wanting to remove the wall that his consumer unit is located on. He has spoken to Western power and they are planning to relocate main incomer to a Electric meter box. Then will his Electrical supplier will be moving his meter and tails aswell, I am planning to re-locate his fuse...
  10. W

    Using a consumer unit after removing total control meter

    I have 2 consumer units, one normal and one for t control, I no longer have storage heaters so want to get the meter removed, can I then use the consumer unit to supply the sockets that were originaly used for storage heating, my immersion heater is also connected to this consumer unit so that...
  11. D

    Moving a consumer unit.

    Question.. If a consumer unit needs moving by 1 metre and all the cables need to be jointed through, is a full EIC needed as if its's a consumer unit replacement? Cheers
  12. V

    Shock from a consumer unit even after Safe Isolation!

    Not a big one, but it bloody hurt and scared the pants of me! If anyone reading the following knows why this happened I'm all ears. I safely isolated a garage consumer unit, but didn't turn off the associated MCB in the house, so the tails to the unit were still live, ready to put in a new...
  13. Faultlessfinish

    Power supply type in industrial unit

    Hi everyone! I'm just after some advice regarding the power supply in an industrial unit I am about to lease. Does this unit have a 3 phase supply that I can use? I plan to get an electrician to fit some commercial fan heaters, but can't decide wether or not I already have 3 phase power that...
  14. C

    Spur of a Cooker unit for under cabinet lighta

    Afternoon guys quick question It’s been a year after the kitchen has been competed and now I’m looking at doing led strip lights under the cabinets on the plynths. on one side of the kitchen I only have available 2 cooker isolating switches that I wired in for the induction hob and the...
  15. A

    UK Impact on cable rating if trunking used to consumer unit

    Hi My consumer unit is located in the garage, the cables are currently clipped to a solid wall above the unit. I am considering putting the cables in trunking to give them some more protection, the trunking would be just under a meter long. I believe its common practice to use trunking in this...
  16. NellyManjaro

    Favourite Consumer Unit

    I don't know if other people are having the same issue with stock as I am, but I do stick to local businesses and they are struggling to keep up with demand during this covid nonsense. So from time to time I will have to go to a bigger manufacturer. Because I shop local its what my local...
  17. C

    Consumer Unit in Bathroom

    Been asked to carry out some works in a bathroom. The clients mains board, cutout and meter are in the airing cupboard of the bathroom currently. As part of the plans they are removing the airing cupboard and plan to just put a standard cupboard with a lock around the mains board which will now...
  18. M

    LED flasher unit

    Hi. New member here. I have a strange problem with a new LED headlight installation on my very old VW. I've recently installed a set of ebay LED headlights and tail lights on my old buggy. They're the ones with an outer ring that swaps white/amber for the turn signal. They're running through an...
  19. P

    Is it possible to a squeeze a lighting RCD onto this old MK Consumer unit ?

    Hi Everyone, The CU is c.2006 and I was hoping NOT to have to pay for a new metal CU with all new MCBs, RCDs etc. There seems to be a lot of debate about whether my lighting circuit at position 7 requires an RCD but if it does can anyone figure out a way of using the existing CU - the space at...
  20. D

    Is a fused double pole isolator classed as a consumer unit.

    I’ve just replaced a faulty 63A double pole isolator supplying a feed to a consumer unit several meters away to a flat. ive come to do the notification on the niceic web page and there is no appropriate category to tick other than circuit addition or alteration in a special locatiom install a...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top