unit

Recent contents Top users
  1. R

    Upgrade Consumer Unit in Garage with EV Charger Capability.

    I’m looking to get my consumer unit upgraded in my Garage as it’s an old Chint board that is not very good.. My Dad is looking at EV Chargers too and I was wondering if it’s possible to get a consumer unit that would handle that. The current board has MCBs for 6A - Lighting 16A Electric Fire...
    • RDB85
    • Thread
    • charger consumer consumer unit ev charger garage unit upgrade
    • Replies: 8
    • Forum: UK Electrical Forum
  2. Bigkev1975

    Motorbike wiring Suzuki bandit 02 600 m unit blue

    Hi peeps I’m going to try wiring an m unit blue into my motorbike there are a few things I’m not sure about I’ve drawn a wiring diagram does it look ok? which I’ve attached,for the bike which is a 02 600 bandit also I’ve attached the original Wiring diagram because I’m getting rid of the fuse...
  3. T

    Secondary consumer unit from SWA cable

    All of the work described below will be completed by a qualified electrician, I am just curious and using the info for planning!! I am planning a garage conversion. While I was bringing across services for water/gas etc I laid a 16mm2 3 core SWA between the main dwelling and the garage (all at...
  4. H

    Old black box near consumer unit

    Hi, My electrics keep tripping.. this black box in the picture seems to be the culprit. Slight touch of it and it trips. The electrician suggested removing this and connecting two main cables from main switch to the consumer unit with connectors. He said this black box is very old and not...
  5. K

    Recessed consumer unit

    Hi guys A customer wants a new surface mounted consumer unit installed. Their current unit is recessed. The cables are not long enough to come out into rear of new board. Any suggestions would be great. 👍
  6. M

    Advice on safety of new Consumer Unit Install

    Hi all, new to posting but been reading for years. I inherited a house from my grandmother who passed in 2021, I intend to renovate and rent out, step by step, job by job as money allows. Getting the property ready to rent has uncovered a fair few jobs needed to bring it out of the 1970's I...
  7. K

    UK Any suggestions for feed to consumer unit?

    Hi guys. Been to look at a job today to replace old wylex board. Feed to unit seen in pictures fed from garage. It 16mm twin and earth. I’m unable to access cables entering board so would struggle to replace with swa.
  8. V

    Protecting a 2nd consumer unit

    Done this loads of times before, but this situation is quite unique so bare with me. I've been asked to cable up an out building at a country park which is about 30m from another out building which has mains supply already installed from a main building some distance away via a 10mm SWA buried...
  9. K

    Relocation of consumer unit

    Hi guys I’ve been requested to replace a consumer unit but will need relocating lower within a tight cupboard. I will be installing a box with din rail and terminals etc and running new cables to new unit. Problem I have is that the meter and isolator is mounted on a board. The only way to...
  10. A

    Unit 104 design project - software recommendations

    Hi I’m just in the process of my L3 and have come around to doing the C&G Unit 104 Design Project. Does anybody have any recommendations of design software I can use on the PC to complete the drawings electronically? Many thanks
  11. S

    New circuit in plastic consumer unit. Yes or no?

    I work with someone who really isn't happy installing new circuits into plastic consumer units. Sometimes he refuses to do it if the board in question isn't in a great state or if the existing wiring is spaghetti junction. Obviously the regs state that it's fine to add if the board conforms to...
  12. W

    240V AC unit no power

    I have a 240V wall mounted AC unit that indicated no power with 240 at the plug. Replaced unit and I have the same issue.
  13. S

    SWA Cable for run between switched fuse isolator and consumer unit

    Hi all, I am looking to replace an existing CU (ground floor) and put it in a new position (first floor). The existing CU is on the inside of a wall to the meter cabinet (which is on the other - external - side of the wall). The existing cabling between these two devices is not SWA/armoured...
  14. J

    New Consumer Unit Fireproof Stuffing Glands

    I recently had an electrician install a new consumer unit in my cellar. A second electrician, who is subcontracted by my bathroom fitter to carry out electrical work in the bathroom, has said that the cable entry to the fuseboard should be sealed with either fire resistant stuffing glands or...
  15. J

    joining two feeds into one consumer unit.

    I have two 40A swa cables from my main house consumer unit. This consumer unit serves the whole house and the two swa cables serve two consumer units in an extension. One is upstairs and has very little demand and one is downstairs with a higher demand. My question is: Can I add the upstairs swa...
  16. D

    Main Earthing in Consumer Unit

    I am due to carry out an electrical job in a third floor flat. Incoming supply is TN-S. Cannot locate a main earthing conductor inside the CU on the earth bar, just the individual circuits CPCs. There are two earths clamped to the bottom of the metal CU, one disappearing down some metal...
  17. D

    Running new circuit to AC unit, please review my plan.

    Running a new circuit to an AC unit, making sure I'm on the right track. The attached chart has the information for this unit which is on column 4. Maximum overcurrent protection: 30 amps Minimum circuit ampacity: 19amps 240 volts It will be running across a rooftop in a pretty hot location...
  18. V

    New consumer unit - Necessary to replace existing grey tails ?

    Hi, I'm getting conflicting stories about this, I wonder if someone could put this to bed once and for all. I'm replacing a consumer unit in the next few days, and it currently has the common grey tails going from the isolator to the existing consumer unit, one is ,marked "L" then other marked...
  19. N

    Upgrading an existing consumer unit with RCBOs

    hi there I have a plastic consumer unit that was installed about 8 years ago - inside is the standard array with RCD. Im planning to switch to RCBOs (and cost wise I actually bought a fully populated consumer unit as it works out a lot cheaper ) my question is to comply and get through a...
  20. eleanor jones

    Consumer unit left main switch ?

    Which consumer units have left main switch?
Best EV Chargers 2025
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

YOUR Unread Posts

Daily, weekly or monthly email

Receive a daily, weekly, or monthly email containing a digest of new and recently updated threads.

Advert

TrueNAS JBOD Storage Server

UK Tiling Forum | Tilers Forums
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Electrician Tips from Professional Electricians
JBOD Forums: a forum for JBOD storage server advice
JBOD Suppliers: JBOD Storage Server Supplies
Back
Top