wants | Page 5

wants

Recent contents View information Top users
  1. L

    New kitchen fitted now wants down lights

    Hi went to a customer house and the have just had a new kitchen fitted new floor and some coving done now they want me to put six down lights in They don't want the floors upstairs taken up and don't want loads of holes in the ceiling Can you give me some tips of the following best down...
  2. R

    Wants Electricians Mate or Electrical engineers Mate Job In Birmingham

    Hi Mark here, i'm 18 and looking for a temporary job around the Birmingham area as either an electricians mate or electrical/electronic engineers mate for around 9 months or less. I have a National Diploma level 3 in electrical and electronic engineering. Experience with electrical work assiting...
  3. T

    Who wants to be a millionaire!

    It's the £50,000 question
  4. R

    Pir recommendation please

    Hello there, A customer has four external lights that are all looped on one feed. He wants pir motion sensor lights but wants only one pir instead of one on each light each light due to the cost. Can anyone recommend a decent pir that does not need to be wired in 3 core as the wiring is...
  5. Jimmy Boy

    My electric supplier wants me to.....

    Have new 'smart' Gas and Leccy meters put in, I don't have to have them done I can decline are the new one's likely to be more accurate in my favour or theirs ? ATB S
  6. O

    Old bathroom - customer wants a fan fitted

    Been to look at a possible job today and its one of the usual "difficult" ones. Very old installation, rewireable fuses, not a RCD in sight, and the customer has bought a humidstat fan. The location for the fan would be outside zone 2 - as would the 3 pole isolation switch. The only way to...
  7. F

    time served electrician wants to get back into the industry as a domestic installer

    Hi everyone, I am a 40 yold time served electrician that used to have a JIB approved rating back in 1994, since then i moved out of the industry but now want to set up on my own as a domestic installer Im based in leeds and would welcome advice as to what I need to do (part p course) i think...
  8. T

    new member wants to help any one

    hello every body i am a new member i am specialist in street lighting
  9. S

    Who wants to meet for an Xmas beer?

    Hi guys, The title says it all. I'm based just outside Manchester in Leigh, Lancashire would anyone want to .... erm you know the scary thing, get away from the cyber stuff and meet for a pint? Richard
  10. M

    Customer has his own pre 17th cu he wants to use

    He has already put it on a board next to the existing cu (bless him) It is a Wylex NHRS5504ymCb Split board 6 RCD protected ways and 6 non protected ways I think I can use this by having On the non RCD side Shed Sub main (has own rcd, will check Zs at this installation) Cooker has 45A main...
  11. M

    Confused - no electrian I contact wants to rewire my kitchen

    Ok - I may be shot down in flames, but here goes: I'm a qualified electrician (C&G 2381,91), but have another day job. I've chased out boxes & cable runs while posting on these forums. I want to employ someone for reasonable money to come & rewire my kitchen & post Part P forms. I can't...
  12. M

    9 years exp elec mate wants get qualified

    have been a sparky 's mate for 9 years going to do the electro tech certificate to qualify was just wondering if i would have to do the full course as any new starter in the trade or will i only have to do so much with the leve of experience i have any help would be welcomed cheers
  13. W

    Individual rcd's

    Can anyone help; I have a potential customer who wants individual rcd protection on all circuits (approx 8 of) I have fitted them a few years ago, but can't remember manufacturer, I do remember each rcd takes up two spaces in the consumer unit. Can they still be used? All I can find is the...
  14. W

    unqualified council inspection!

    Hi all, I have just completed the 1st fix on a rewire and have invited the local council along to inspect (huge invitation fee!!!!!) in order to apply for part P registration. I have installed everything to 17th as this is my qualification and to me makes it easier. Council guy is 16th and...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top