Customer has two industrial washing machines three phase he wants to install in hotel faceplate indicates three phase 60hz supply needed. Says they came off a ship. Would our 50 hz supply work they are roughly 16 and 18 kamps each.
thekingiam
Thread
attach
customer
industrial
machine
needed
phase
supply
three
three phase
washing
I have a problem with my Indesit WIXL 143 - 4 years old.
After a wash, clothes are still saturated with water. The machine doesn't transfer to a fast spin. On any program, all lights are flashing.
Checked the pump, outlet hose and filter etc. - all clear, no blockage.
Thanks in advance.
Hey all,
I pat tested my washing machine at home yesterday and it's failing the insulation resistance test, giving a reading of 0.87 Mohm.
After some investigating, I found that by unplugging the drain outlet pump, the insulation resistance reading is now >199 Mohm. Therefore the pump is...
Bit of a fast ball.
My missus is determined to have a new washing machine! I am more determined to spend that three hundred quid wisely investing it with william hill (other bookmakers could also be used(I'm not advertising)) whilst slurping strongbow.
Anyway our washing machine has wrapped...
Good evening all! I have been asked for some professional advice and would like to pick your collective brains.
A client has been advised by his architect to place the washing machine in the bathroom.
I have been reading the 17th which bans sockets within 3 metres of zones.
Can the design be...
I've used a particular socket in my kitchen to carry out monthly calibration checks (ZS & RCD) on my MFT, for several months with no issues. Last week I carried out my tests on my MFT and the x5 RCD test timed out at 40ms. Thinking I had a faulty RCBO, I replaced today, but the fault remained...
Poorly Candy/Hoover washing machine at home, just trying to work out how feasible it is to change drum bearings or just forget it and buy a new one.
Can anyone advise?
Hello.
I'd be interested in what people think of the following, and any helpful advice.
I want to put a washing-machine in a bathroom and here are the relevant details :
The machine is rated IPX4, power rated at 1850W, has instructions as to how to remove the plug if required, and the manual...
A colleague of mine has mentioned that they have experienced electric shock symptoms whilst washing up. They say that all the circuits in the kitchen are protected by RCD so assuming they are working ok, it rules out the theory that there is an electrical circuit problem.
Possible earthing...
I have a hotpoint Aquarius washing machine. As soon as its plugged in and switched on it trips the rcd. I've tried at another socket toake sire its nor a fault on the socket, but its definitely the machine. Could anybody give me any pointers as what to look for. Thanks
Called to a property today. Customer said that kitchen ring circuit trpped whilst washing machine was half way through cycle. Tested the circuit with my insulation resistance tester and all was fine.
Tested the appliance itself and found dead short between live / earth and 0.26 between neutral...
got called out this afternoon, lady had engineer out from manufacturers this morning to repair washing machine. He did the repair then got "some big" machine out and tested her sockets!!. He then advised her not to use the electrics in the house and gave her a note saying dont use until had...
Last week the door seal rear retainer went on our Indesit washing machine. Yesterday the part was finally delivered, it's a circular spring about 400mm in diameter which secures the door seal to the drum housing and so far I've been on about an hour trying to get it fitted.
I'm hoping one of my...
Hello guys,
I 've been asked to provide power in a utility room with a shower, for a tumble drier, washing machine and boiler. I was thinking that fused spurs will suffice, they would be outside zone 2 but not 3 m away horizontally.
Any thoughts?
Cheers
Tom
tombrooker84
Thread
boiler
installation
machine
shower
too
tumble
washing
Would a 16 amp MCB be capable for a kitchen ring?? 3x double plugs, 4x 13 amp fuse spurs for the washing machine etc.. and the cooker is on its own mcb...thanks
Quick question got to get my six posts ,If double socket is used under counter can that satisfy regulations as isolation point or is a single pole fused switch also needed . got a tenner on it so need to know thanks for all welcomes
Afternoon chaps,
Anyone familiar with washing machines? We have a Hotpoint WF220. Select a (any) wash program, press start it starts the wash cycle but it carries on washing untill I manually stop it. The machine fill water into the drum and the drum spins at wash speed, but it carries on...
Hi all i'm a little stuck been asked by my folks to have a look at their washing machine as they all think if it has a plug on it i know the whole workings, design, and how to repair it. My problem is there seems to be a short on the motor when running i know its not the pump or element as have...
jim1000
Thread
fault
insulation
machine
motor
seems
testing
washing
Anyone got any idea why [LG] washing machines with "Inverter technology" continually trip RCD's? LG insist that the fault is not theirs and that the machine I know of should be connected to a non-RCD supply to remedy the problem.
Given that most machines are in kitchens, ergo Special Locations...
Poptasticdave
Thread
circuit
don't
inverter
machine
machines
other
rcd
rcds
washer
washing
Hi,
I have a socket behind a washing machine near the the open washing machine drain stand pipe. I am guessing that the pipe was blocked and the water overflowed and leaked onto the socket and blew the fuse.
The machine is new so I contacted the landlord who sent an electrician around, he...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc