won't

  1. A

    Turbo actuator won't work, new actuator been fit! So much info inside thread

    Losing my mind with my 2008 Audi A6 3.0 TDI Fault code 3348 for turbo actuator, clear the code, instantly comes back Turbo and actuator has been swapped for a new recon unit from a specialist, pre-calibrated Turn ignition on, the inlet manifold actuators self test sweep, but the turbo...
  2. S

    Hotpoint wmfug742 won't start cycles

    Hello! I was wondering if some clever person could help me work out what's wrong with my washing machine? When I try to start a cycle, the machine makes several clunk and beeping sounds and flashes the red lock symbol. I've had a repairman from hotpoint come round, he changed the motor and I...
  3. S

    I have a mk sentry breaker and it won't switch off

    I have a mk sentry 5932s b32 breaker that won't switch off .is this common
  4. C

    Light Flickering and LED won't fit in holes

    Hi all. I have a few issues: - I bought an LED spotlight which is 50w (Input power 7.8w) 240v, but it flickers when I turn the lights on. There are 2 other older bulbs in the circuit which are 12v 20w..... When I take these other two out and just leave the new 50w LED bulb in it still flickers...
  5. I

    LED tubes won't turn ON sometimes due to dimmer on the same 120V line

    I just rewired my kitchen CFL T8 fixture with direct wire - double ended Sylvania A/B type LED tubes, no more ballast. One single 120V 15A line connected to living room with LED dimmer and LED light bulbs. Couple of the feet from dimmer another simple On/Off switch(kitchen) connected to the same...
  6. U

    Bosch Oven Fan won't stay on

    Hi all, I have a 6 year old HBG73U150/45 oven from Bosch. The ventilation fan no longer stays on to exhaust the humid air inside from inside the chamber. In the worst case, water vapour seeps out the front and then the touch screen goes berserk -- won't stop beeping :( I took the cover off and...
  7. happysteve

    They want to install a smart meter... but won't fit an isolator... which my old meter has built-in...

    An interesting phone conversation with my own electricity supplier (Good Energy) which was very disappointing, and made me sigh (professionally) :( They phoned out of the blue to ask if they could book a date to replace my gas and electricity meters with smart versions. I said I'd probably be...
  8. S

    Zanussi Lindo 300 Tumble dryer has power but won't run

    Hello all, A newbie to the forum here but looking forward to learning things from you all. I've got a Zanussi Lindo 300 tumble dryer, Model ZDC8202P. The info label states Type TC09H65HW, Prod No 916 097 379 00, 230-240V, 2800W. I've done a lot of searches for common faults similar to mine...
  9. S

    Dangerous Video Youtube won't remove: Join electrical cables the pretty way

    Came across these videos on youtube. Do you think this is safe? Reported many times myself but it is still there. Perhaps if you agree you could report them as well. Vid 1: Vid 2: Ironically they are promoting Safer Internet Day as well boasting about removing harmful content. Shame...
  10. F

    Need Help: Mechanical Chime Won't Ring After Transformer Replaced

    Hi. Here's some background info. I am located in the United States, and have had a Nest Hello video doorbell working perfectly for a couple of years. It's powered by a 16V 10va transformer. I also have a mechanical door chime that rings when someone presses the button on the Nest Hello. The...
    • ftresi
    • Thread
    • after chime doorbell help mechanical need help replaced ring transformer won't
    • Replies: 14
    • Forum: DIY Electrical Advice
  11. J

    Well Pressure Switch won't cut out.

    My well pressure switch would not cut out so I replaced it with a brand new one (on at 40 lbs, off at 60 lbs) and made sure my pressure tank was at 38 lbs. No Joy. I tested all wires and found that all connections except one were 120v, as they should be. The cut off switch wire is at 48v...
  12. S

    Candy Dryer won't turn?

    Hello all, I have a candy Free-standing dryer GCC 591NBB-80. However it wont turn, it just makes a strange noise when I press it on. If I manually turn drum with my hand it turns very freely. Really would like to see if I could repair it rather than get someone out. Any advice please...
  13. C

    Oven won't switch back on

    Ok, so basically I turned the oven off at the wall when we went away for our honeymoon, came back yesterday switched it back on and now have no power at all. I've checked fuse box and the plug attached to the switch works, but other than that I don't know what else I can do before calling out an...
  14. K

    1992 Pontiac Firebird won't crank, no power to starter enable relay, no security light, temperature gauge fluttering

    My 92' Firebird that I just acquired will not start. I bypassed VATS security with resistors so the security light now shuts off. I replaced my positive battery lead that was shot and the only thing that happens when I turn the key is the temp gauge fluttering. The relay only has 0.5 constant...
    • kalgran
    • Thread
    • gauge light no power power power to relay security starter temperature won't
    • Replies: 4
    • Forum: Auto Electrician Forum
  15. A

    Attic Fan motor won't run

    I have an attic fan on a thermostat. I can hear it turn on; but, the motor hums but the blades don't turn. There is nothing obstructing the blades and they turn by hand. Don't know where to start.
  16. P

    Smeg Opera A3 Main Oven Won't Turn On

    My Smeg Opera A3 has just developed a fault with the main oven. Nothing works at all. Fan, oven element, grill element lights - all dead. I've changed the main oven element before when that failed but it's clearly a different problem. Any suggestions where to start? Thanks.
  17. naylorpd

    3 phase RCCB tripped, won't reset

    Hi, in my garage I have a 3 phase RCCB that has tripped and I just can't get it to reset, even with all the downstream MCBs switched off. Bit of a nuisance really as mother in law has no power to her flat above the garage and the garage door and front gate don't work. I tried uploading photo...
  18. Lister1987

    Megger 1730 won't complete IR dead test at any range

    As title, playing with test rig and running through dead tests; conductor continuity passes fine but if I try and do any range IR test it just won't have it. I've tested the dead short to verify leads are ok and they are, I can't figure out why it's not running the test, it's a dead rig so no...
  19. P

    My RCD won't reset after testing

    my RCD's wont reset after testing. I have 6 RCD in my fuse box all in a row (and only 4 MCB - which doesn't seem usual). After pressing the test button, the RCD triggers. The RCD won't however allow itself to be reset. I have tried resetting with all the MCB turned off as well as all...
  20. E

    Dishwasher Siemens won't start, instead the on/off button beeps.

    Hi, I am totally desperate, looking for advice. With the Covid, nobody wants to come home to repair my dishwasher. It is a Siemens SN65E003EU/43. I had a problem with the draining pump which I remove and cleaned. Once I plugged it back in, nothing happen and the dishwasher won’t start...
Best EV Chargers 2025
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

YOUR Unread Posts

Advert

TrueNAS JBOD Storage Server

UK Tiling Forum | Tilers Forums
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Electrician Tips from Professional Electricians
JBOD Forums: a forum for JBOD storage server advice
JBOD Suppliers: JBOD Storage Server Supplies
Back
Top