30ma trip on split board

[andrewni]

Any opinions on replacing a 100a main switch with 30 ma TVs, I'll have to move the internal tails from the bottom off the rcd to the top I know but is there anything to say I can't? Or just use rcbos

 

[Marvo]

I'm confused....but that's not uncommon nowadays

Maybe a photo??

 

[Brightspark2]

RCBO'S will be better...

Is it a consumer unit feeding the full house?...

 

[andrewni]

Sockets are covered by 30, other side is main switch, I can't see anything wrong with doing it , but was just putting it out there as never needed to do it before

 

[Dan23584]

So you have a split load board, RCD one side and main switch the other right? You want to replace the main switch with another RCD?

 

[telectrix]

Then you'd have two RCRd in series. Bad idea

 

[Dan23584]

Just fit RCBOs on the non RCD protected side.

- - - Updated - - -

Indeed!

 

[Dan23584]

Then you'd have two RCRd in series. Bad idea

I think the OP wants to fit them in parallel, if you read the back he mentions moving link tails to top of RCD. So 2 RCDs with no main switch! Mmmm....

 

[Octopus]

I'm confused. More information please.

 

[MDJ]

Another numpty question, PLEASE TYPE IN ENGLISH!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!